- 您現在的位置：買賣IC網 > PDF目錄361881 > WM8782 (Wolfson Microelectronics) 24-Bit, 192kHz Stereo ADC PDF資料下載
參數資料
| 型號： | WM8782 |
| 廠商： | Wolfson Microelectronics |
| 元件分類： | ADC |
| 英文描述： | 24-Bit, 192kHz Stereo ADC |
| 中文描述： | 24位192kHz立體聲ADC |
| 文件頁數： | 7/19頁 |
| 文件大?。?/td> | 216K |
| 代理商： | WM8782 |
Product Preview
WM8782
w
PP, May 2004, Rev 1.0
7
Analogue Reference Levels
Midrail Reference Voltage
VMID
AVDD to VMID and
VMID to VREFN
–3%
AVDD/2
+3%
V
Potential Divider Resistance
Buffered Reference Voltage
VREF source current
VREF sink current
Supply Current
Analogue supply current
Digital supply current
Power Down
R
VMID
VREFP
I
VREF
I
VREF
50
k
V
mA
mA
–3%
AVDD/2
+3%
5
5
AVDD = 5V
DVDD = 3.3V
55
4
0.5
mA
mA
mA
Notes:
1.
All performance measurements are done with a 20kHz low pass filter, and where noted an A-weight filter, except
where noted. Failure to use such a filter will result in higher THD+N and lower SNR and Dynamic Range readings than
are found in the Electrical Characteristics. The low pass filter removes out of band noise; although this is not audible,
it may affect dynamic specification values.
2.
VMID is decoupled with 10uF and 0.1uF capacitors close to the device package. Smaller capacitors may reduce
performance.
3.
This high leakage current is due to the topology of the instate pads. The pad input is connected to the midpoint of an
internal resistor string to pull input to vmid if undriven.
TERMINOLOGY
1.
Signal-to-noise ratio (dB) – Ratio of output level with 1kHz full scale input, to the output level with all zeros into the
digital input, over a 20Hz to 20kHz bandwidth. (No Auto-zero or Automute function is employed in achieving these
results).
2.
Dynamic range (dB) – DR is a measure of the difference between the highest and lowest portions of a signal.
Normally a THD+N measurement at 60dB below full scale. The measured signal is then corrected by adding the 60dB
to it. (e.g. THD+N @ -60dB= -32dB, DR= 92dB).
3.
THD+N (dB) – THD+N is a ratio, of the rms values, of (Noise + Distortion)/Signal.
4.
Channel Separation (dB) – Also known as Cross-Talk. This is a measure of the amount one channel is isolated from
the other. Normally measured by sending a full scale signal down one channel and measuring the other.
相關PDF資料 |
PDF描述 |
|---|---|
| WM8782SEDS | 24-Bit, 192kHz Stereo ADC |
| WM8951LGEFL | STEREO ADC WITH MICROPHONE INPUT AND CLOCK GENERATOR |
| WM8951L | STEREO ADC WITH MICROPHONE INPUT AND CLOCK GENERATOR |
| WM9703 | TVS UNIDIRECT 400W 22V SMA |
| WM9712L | AC97 Audio and Touchpanel CODEC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| WM8782_06 | 制造商:WOLFSON 制造商全稱:WOLFSON 功能描述:24-Bit, 192kHz Stereo ADC |
| WM8782_10 | 制造商:WOLFSON 制造商全稱:WOLFSON 功能描述:24-Bit, 192kHz Stereo ADC |
| WM8782-6125-SSOP20-EV1 | 制造商:Wolfson Microelectronics 功能描述:Evaluation Board for WM8782 Stereo ADC |
| WM8782ASEDS/RV | 功能描述:音頻模/數轉換器 IC STEREO ADC RoHS:否 制造商:Wolfson Microelectronics 轉換速率: 分辨率: ADC 輸入端數量: 工作電源電壓: 最大工作溫度: 最小工作溫度: 安裝風格: 封裝 / 箱體: 封裝: |
| WM8782ASEDS/V | 功能描述:音頻模/數轉換器 IC STEREO ADC RoHS:否 制造商:Wolfson Microelectronics 轉換速率: 分辨率: ADC 輸入端數量: 工作電源電壓: 最大工作溫度: 最小工作溫度: 安裝風格: 封裝 / 箱體: 封裝: |
發布緊急采購，3分鐘左右您將得到回復。