- 您現在的位置：買賣IC網 > PDF目錄361881 > WM8718SEDS (Wolfson Microelectronics) 24 BIT DIFFERENTIAL STEREO DAC WITH VOLUME CONTROL PDF資料下載
參數資料
| 型號： | WM8718SEDS |
| 廠商： | Wolfson Microelectronics |
| 英文描述： | 24 BIT DIFFERENTIAL STEREO DAC WITH VOLUME CONTROL |
| 中文描述： | 24位差分立體聲DAC，具有音量控制 |
| 文件頁數： | 7/27頁 |
| 文件大?。?/td> | 284K |
| 代理商： | WM8718SEDS |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
WM8718
Production Data
w
PD Rev 4.1 March 2004
7
Test Conditions
AVDD = 5V, DVDD = 3.3V, AGND, DGND = 0V, T
A
= +25
o
C, fs = 48kHz, MCLK = 256fs unless otherwise stated.
PARAMETER
SYMBOL
TEST CONDITIONS
Analogue Output Levels
Load = 10k
, 0dBFS
Differential Output level
Load = 10k
, 0dBFS,
(AVDD = 3.3V)
Gain mismatch
channel-to-channel
To midrail or a.c.
Minimum resistance load
MIN
TYP
MAX
UNIT
2.0
1.32
V
RMS
V
RMS
±1
%FSR
coupled
To midrail or a.c.
coupled
(AVDD = 3.3V)
5V or 3.3V
1
k
600
Maximum capacitance load
Output d.c. level
100
(AVDD-
GND)/2
pF
V
Power On Reset (POR)
POR threshold
2.0
V
Notes:
1.
Ratio of output level with 1kHz full scale input, to the output level with all ZEROS into the digital input, over a 20Hz to
20kHz bandwidth.
All performance measurements done with 20kHz low pass filter, and where noted an A-weight filter. Failure to use such a
filter will result in higher THD+N and lower SNR and Dynamic Range readings than are found in the Electrical
Characteristics. The low pass filter removes out of band noise; although it is not audible it may affect dynamic specification
values.
VMID decoupled with 10uF and 0.1uF capacitors (smaller values may result in reduced performance).
2.
3.
TERMINOLOGY
1.
Signal-to-noise ratio (dB) - SNR is a measure of the difference in level between the full-scale output and the output with a
ZERO signal applied. (No Auto-ZERO or Automute function is employed in achieving these results).
2.
Dynamic range (dB) - DNR is a measure of the difference between the highest and lowest portions of a signal. Normally a
THD+N measurement at 60dB below full scale. The measured signal is then corrected by adding the 60dB to it. (e.g.
THD+N @ -60dB= -32dB, DR= 92dB).
3.
THD+N (dB) - THD+N is a ratio, of the rms values, of (Noise + Distortion)/Signal.
4.
Stop band attenuation (dB) - Is the degree to which the frequency spectrum is attenuated (outside audio band).
5.
Channel Separation (dB) - Also known as Cross Talk. This is a measure of the amount one channel is isolated from the
other. Normally measured by sending a full-scale signal down one channel and measuring the other.
6.
Pass-Band Ripple – Any variation of the frequency response in the pass-band region.
相關PDF資料 |
PDF描述 |
|---|---|
| WM8722 | Stereo DAC with Integrated Tone Generator and Line/Variable Level Outputs |
| WM8725 | 99dB Stereo DAC |
| WM8725ED | 99dB Stereo DAC |
| WM8728 | 24-bit, 192kHz Stereo DAC with Volume Control and DSD Support |
| WM8756EFT | 192KHZ SIX CHANNEL SACD COMPATIBLE AUDIO DAC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| WM8718SEDS/R | 功能描述:音頻數/模轉換器 IC Stereo DAC Differential O/P RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel |
| WM8718SEDS/RV | 功能描述:音頻數/模轉換器 IC Stereo DAC Differential O/P RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel |
| WM8718SEDS/V | 功能描述:音頻數/模轉換器 IC Stereo DAC Differential O/P RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel |
| WM8720 | 制造商:WOLFSON 制造商全稱:WOLFSON 功能描述:24-bit, 96kHz Stereo DAC with Volume Control |
| WM8720_05 | 制造商:WOLFSON 制造商全稱:WOLFSON 功能描述:24-bit, 96kHz Stereo DAC with Volume Control |
發布緊急采購，3分鐘左右您將得到回復。