- 您現在的位置：買賣IC網 > PDF目錄203637 > W986432DH-6 (WINBOND ELECTRONICS CORP) 2M X 32 SYNCHRONOUS DRAM, 5 ns, PDSO86 PDF資料下載
參數資料
| 型號： | W986432DH-6 |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | DRAM |
| 英文描述： | 2M X 32 SYNCHRONOUS DRAM, 5 ns, PDSO86 |
| 封裝： | 0.400 INCH, 0.50 MM PITCH, TSOP2-86 |
| 文件頁數： | 3/48頁 |
| 文件大小： | 1648K |
| 代理商： | W986432DH-6 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁
W986432DH
Publication Release Date: July 30, 2002
- 11 -
Revision A5
The Power Down mode is exited by bringing CKE high. When CKE goes high, a No Operation
Command is required on the next rising clock edge, depending on tCK. The input buffers need to be
enabled with CKE held high for a period equal to tCKS (min.) + tCK (min.).
No Operation Command
The No Operation Command should be used in cases when the SDRAM is in a idle or a wait state to
prevent the SDRAM from registering any unwanted commands between operations. A No Operation
Command is registered when
CS
is low with
RAS ,
CAS , and
WE
held high at the rising
edge of the clock. A No Operation Command will not terminate a previous operation that is still
executing, such as a burst read or write cycle.
Deselect Command
The Deselect Command performs the same function as a No Operation Command. Deselect
Command occurs when
CS
is brought high, the
RAS ,
CAS , and
WE
signals become don't
cares.
Clock Suspend Mode
During normal access mode, CKE must be held high enabling the clock. When CKE is registered low
while at least one of the banks is active, Clock Suspend Mode is entered. The Clock Suspend mode
deactivates the internal clock and suspends any clocked operation that was currently being executed.
There is a one clock delay between the registration of CKE low and the time at which the SDRAM
operation suspends. While in Clock Suspend mode, the SDRAM ignores any new commands that are
issued. The Clock Suspend mode is exited by bringing CKE high. There is a one clock cycle delay
from when CKE returns high to when Clock Suspend mode is exited.
相關PDF資料 |
PDF描述 |
|---|---|
| W986432DH-8 | 2M X 32 SYNCHRONOUS DRAM, 6 ns, PDSO86 |
| W987Z6CBG80 | 8M X 16 SYNCHRONOUS DRAM, 6 ns, PBGA54 |
| WA-1RVX051-A4 | SNAP ACTING/LIMIT SWITCH |
| WA-1RX12-A4 | SNAP ACTING/LIMIT SWITCH |
| WB3M200VD1R800 | 200 CONTACT(S), MALE, STRAIGHT SINGLE PART CARD EDGE CONN, SURFACE MOUNT, PLUG |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W986432DH-6I | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SDRAM|4X512KX32|CMOS|TSSOP|86PIN|PLASTIC |
| W986432DH-7 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SDRAM|4X512KX32|CMOS|TSSOP|86PIN|PLASTIC |
| W986432DH-7L | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SDRAM|4X512KX32|CMOS|TSSOP|86PIN|PLASTIC |
| W9864G2DH6 | 制造商:WINBOND 功能描述:New |
| W9864G2GH | 制造商:WINBOND 制造商全稱:Winbond 功能描述:512K X 4 BANKS X 32BITS SDRAM |
發布緊急采購，3分鐘左右您將得到回復。