參數資料
型號: W77LE58F-25
廠商: WINBOND ELECTRONICS CORP
元件分類: 微控制器/微處理器
英文描述: 8 BIT MICROCONTROLLER
中文描述: 8-BIT, FLASH, 25 MHz, MICROCONTROLLER, PQFP44
封裝: QFP-44
文件頁數: 52/81頁
文件大?。?/td> 657K
代理商: W77LE58F-25
Preliminary W77LE58
- 52 -
When configured as a "Timer", the timer counts clock cycles. The timer clock can be programmed to
be thought of as 1/12 of the system clock or 1/4 of the system clock. In the "Counter" mode, the
register is incremented on the falling edge of the external input pin, T0 in case of Timer 0, and T1 for
Timer 1. The T0 and T1 inputs are sampled in every machine cycle at C4. If the sampled value is
high in one machine cycle and low in the next, then a valid high to low transition on the pin is
recognized and the count register is incremented. Since it takes two machine cycles to recognize a
negative transition on the pin, the maximum rate at which counting will take place is 1/24 of the
master clock frequency. In either the "Timer" or "Counter" mode, the count register will be updated at
C3. Therefore, in the "Timer" mode, the recognized negative transition on pin T0 and T1 can cause
the count register value to be updated only in the machine cycle following the one in which the
negative edge was detected.
The "Timer" or "Counter" function is selected by the "C T
Register. Each Timer/Counter has one selection bit for its own; bit 2 of TMOD selects the function for
Timer/Counter 0 and bit 6 of TMOD selects the function for Timer/Counter 1. In addition each
Timer/Counter can be set to operate in any one of four possible modes. The mode selection is done
by bits M0 and M1 in the TMOD SFR.
/
" bit in the TMOD Special Function
Time-Base Selection
The W77LE58 gives the user two modes of operation for the timer. The timers can be programmed to
operate like the standard 8051 family, counting at the rate of 1/12 of the clock speed. This will ensure
that timing loops on the W77LE58 and the standard 8051 can be matched. This is the default mode of
operation of the W77LE58 timers. The user also has the option to count in the turbo mode, where the
timers will increment at the rate of 1/4 clock speed. This will straight-away increase the counting
speed three times. This selection is done by the T0M and T1M bits in CKCON SFR. A reset sets
these bits to 0, and the timers then operate in the standard 8051 mode. The user should set these bits
to 1 if the timers are to operate in turbo mode.
MODE 0
In Mode 0, the timer/counters act as a 8 bit counter with a 5 bit, divide by 32 pre-scale. In this mode
we have a 13 bit timer/counter. The 13 bit counter consists of 8 bits of THx and 5 lower bits of TLx.
The upper 3 bits of TLx are ignored.
The negative edge of the clock increments the count in the TLx register. When the fifth bit in TLx
moves from 1 to 0, then the count in the THx register is incremented. When the count in THx moves
from FFh to 00h, then the overflow flag TFx in TCON SFR is set. The counted input is enabled only if
TRx is set and either GATE = 0 or INTx = 1. When C T
and if C T
/
is set to 1, then it will count 1 to 0 transitions on T0 (P3.4) for timer 0 and T1 (P3.5) for
timer 1. When the 13 bit count reaches 1FFFh the next count will cause it to roll-over to 0000h. The
timer overflow flag TFx of the relevant timer is set and if enabled an interrupts will occur. Note that
when used as a timer, the time-base may be either clock cycles/12 or clock cycles/4 as selected by
the bits TxM of the CKCON SFR.
/
is set to 0, then it will count clock cycles,
相關PDF資料
PDF描述
W77LE58P-25 8 BIT MICROCONTROLLER
W78151 8-BIT Microcontroller(8位的微控制器)
W78L51F-24 8-BIT MICROCONTROLLER
W78L51 8-BIT MICROCONTROLLER
W78L51-24 8-BIT MICROCONTROLLER
相關代理商/技術參數
參數描述
W77LE58P-25 制造商:WINBOND 制造商全稱:Winbond 功能描述:8 BIT MICROCONTROLLER
W77M032A 制造商:WINBOND 制造商全稱:Winbond 功能描述:8-BIT MICROCONTROLLER
W77M032A25DL 制造商:WINBOND 制造商全稱:Winbond 功能描述:8-BIT MICROCONTROLLER
W77M032A25FL 功能描述:IC MCU 8-BIT 1K SRAM 44-PQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:W77 標準包裝:60 系列:PSOC® 3 CY8C38xx 核心處理器:8051 芯體尺寸:8-位 速度:67MHz 連通性:EBI/EMI,I²C,LIN,SPI,UART/USART 外圍設備:電容感應,DMA,LCD,POR,PWM,WDT 輸入/輸出數:25 程序存儲器容量:64KB(64K x 8) 程序存儲器類型:閃存 EEPROM 大小:2K x 8 RAM 容量:8K x 8 電壓 - 電源 (Vcc/Vdd):1.71 V ~ 5.5 V 數據轉換器:A/D 2x20b,D/A 4x8b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:48-VFQFN 裸露焊盤 包裝:托盤
W77M032A25PL 制造商:WINBOND 制造商全稱:Winbond 功能描述:8-BIT MICROCONTROLLER