參數資料
型號: W29GL032CT7A
廠商: WINBOND ELECTRONICS CORP
元件分類: PROM
英文描述: 2M X 16 FLASH 3V PROM, 80 ns, PBGA48
封裝: GREEN, VFBGA-48
文件頁數: 10/65頁
文件大?。?/td> 650K
代理商: W29GL032CT7A
W29GL032C
12
7.2.15 Buffer Write Abort
Write Buffer Programming Sequence will ABORT, if the following condition takes place:
The word count minus one loaded is bigger than the page buffer size (32) during, “Number of
Locations to Program.”
Sector Address written is not the same as the one specified during the Write-Buffer-Load
instruction.
If the Address/Data set is not inside the Write Buffer Page range which was set during cycle
5’s first initial write-buffer-page select address/data set.
No “Program Confirm Instruction” after the assigned number of “data load” cycles.
After Write Buffer Abort, the status register will be DQ1=1, DQ7 = DATA# (last address loaded),
DQ6=toggle, DQ5=0. This status represents a Write Buffer Programming Operation was ABORTED. A
Write-to-Buffer-Abort Reset instruction sequence has to be written to reset the device back to the read
array mode.
DQ1 is the bit for Buffer Write Abort. When DQ1=1, the device will abort from buffer write operation
and go back to read status register shown in the following table:
Status
DQ7
DQ6
DQ5
DQ3
DQ2
DQ1
RY/#BY
Buffer Write Busy
DQ7#
Toggle
0
N/A
0
Buffer Write Abort
DQ7#
Toggle
0
N/A
1
0
Buffer Write Exceeded Time Limit
DQ7#
Toggle
1
N/A
0
Table 7-8
Polling Buffer Write Abort Flag
7.2.16 Accelerated Programming Operation
The device will enter the Accelerated Programming mode by applying high voltage (VHH) to the
#WP/ACC pin. Accelerated Programming mode allows the system to skip the normal unlock
sequences instruction and program byte/word locations directly. The current drawn from the #WP/ACC
pin during accelerated programming is no more that IACC1. Important Note: Do not exceed 10
accelerated programs per sector.
7.2.17 Automatic Select Bus Operation
There are basically two methods to access Automatic Selection Operations; Automatic Select
Instructions through software commands and High Voltage applied to A9.
See Automatic Select
Instruction Sequence later on in this section for details of equivalent instruction operations that do not
require the use of VHH. The following five bus operations require A9 to be raised to VHH.
7.2.17.1
Sector Lock Status Verification
To verify the protected state of any sector using bus operations, execute a Read Operation with VHH
applied to A9, the sector address present on address pins A[20:12], address pins A6, A3, A2, and A0
held Low, and address pins A1 held High. If DQ0 is Low, the sector is considered not protected, and if
DQ0 is High, the sector is considered to be protected.
7.2.17.2
Read Silicon Manufacturer ID Code
Winbond’s 29GL family of Parallel Flash memories feature an Industry Standard compatible
Manufacturer ID code of 01h. To verify the Silicon Manufacturer ID code, execute a Read Operation
with VHH applied to the A9 pin and address pins A6, A3, A2, A1 and A0 are held Low. The ID code
can then be read on data bits DQ[7:0].
相關PDF資料
PDF描述
WME128K8-150CCA 128K X 8 EEPROM 5V, 150 ns, CDIP32
WMS512K8VL-100DECEA 512K X 8 STANDARD SRAM, 100 ns, CDSO32
WMS512K8VL-85DECE 512K X 8 STANDARD SRAM, 85 ns, CDSO32
WF2M32B-90HM5A 8M X 8 FLASH 5V PROM MODULE, 90 ns, CPGA66
W7NCF01GH11CS7DG 64M X 16 FLASH 3.3V PROM CARD, 150 ns, UUC
相關代理商/技術參數
參數描述
W29GL032CT7B 制造商:Winbond Electronics Corp 功能描述:IC FLASH 32MBIT 70NS 64LFBGA
W29GL032CT7S 功能描述:IC FLASH 32MBIT 70NS 48TSOP RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:2,500 系列:- 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:1K (128 x 8) 速度:100kHz 接口:UNI/O?(單線) 電源電壓:1.8 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP,8-MSOP(0.118",3.00mm 寬) 供應商設備封裝:8-MSOP 包裝:帶卷 (TR)
W29GL064C 制造商:WINBOND 制造商全稱:Winbond 功能描述:64M-BIT 3.0-VOLT PARALLEL FLASH MEMORY WITH PAGE MODE
W29GL064CB7A 功能描述:IC FLASH 64MBIT 70NS 48TFBGA RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:1 系列:- 格式 - 存儲器:閃存 存儲器類型:閃存 - NAND 存儲容量:4G(256M x 16) 速度:- 接口:并聯 電源電壓:2.7 V ~ 3.6 V 工作溫度:0°C ~ 70°C 封裝/外殼:48-TFSOP(0.724",18.40mm 寬) 供應商設備封裝:48-TSOP I 包裝:Digi-Reel® 其它名稱:557-1461-6
W29GL064CB7B 制造商:Winbond Electronics Corp 功能描述:IC FLASH 64MBIT 70NS 64LFBGA