- 您現在的位置：買賣IC網 > PDF目錄373739 > TSL3301-LF (TAOS Inc.) 102 】 1 LINEAR OPTICAL SENSOR ARRAY WITH ANALOG-TO-DIGITAL CONVERTER PDF資料下載
參數資料
| 型號： | TSL3301-LF |
| 廠商： | TAOS Inc. |
| 英文描述： | 102 】 1 LINEAR OPTICAL SENSOR ARRAY WITH ANALOG-TO-DIGITAL CONVERTER |
| 中文描述： | 102】1非線性光學傳感器陣列與模擬到數字轉換器 |
| 文件頁數： | 3/16頁 |
| 文件大小： | 247K |
| 代理商： | TSL3301-LF |
TSL3301LF
102
×
1 LINEAR OPTICAL SENSOR ARRAY
WITH ANALOG-TO-DIGITAL CONVERTER
TAOS0078C
APRIL 2007
3
The
LUMENOLOGY
Company
Copyright 2007, TAOS Inc.
www.taosinc.com
Terminal Functions
TERMINAL
NAME
I/O
DESCRIPTION
NO.
6, 7
1
3
4
2
GND
SCLK
SDIN
SDOUT
V
DD
Ground
System clock input for serial I/O and all internal logic.
Serial data input. Data is clocked in on the rising edge of SCLK.
Serial data output. Data is clocked out on the falling edge of SCLK.
Positive supply voltage.
I
I
O
Detailed Description
The TSL3301
LF is a 102
×
1 linear optical array with onboard A/D conversion. It communicates over a serial
digital interface and operates over a 3 V to 5.5 V range. The array is divided into three 34-pixel zones (left, center,
and right), with each zone having programmable gain and offset (dark signal) correction.
The sensor consists of 102 photodiodes, also called pixels, arranged in a linear array. Light energy impinging
on a pixel generates a photocurrent, which is then integrated by the active integration circuitry associated with
that pixel. During the integration period, a sampling capacitor connects to the output of the integrator through
an analog switch. The amount of charge accumulated at each pixel is directly proportional to the light intensity
(E
e
) on that pixel and to the integration time (t
int
). At maximum programmed gain, one LSB corresponds to
approximately 300 electrons.
Integration, sampling, output, and reset of the integrators are performed by the control logic in response to
commands input via the SDIN pin. Data is read out on the SDOUT pin. A normal sequence of operation consists
of a pixel reset (
RESET
), start of integration (
STARTInt
), integration period, sampling of integrators
(
SAMPLEInt
), and pixel output (
READPixel
). Reset sets all the integrators to zero. Start of integration releases
the integrators from the reset state and defines the beginning of the integration period. Sampling the integrators
ends the integration period and stores the charge accumulated in each pixel in a sample and hold circuit.
Reading the pixels causes the sampled value of each pixel to be converted to 8-bit digital format and output on
the SDOUT pin. All 102 pixels are output sequentially unless interrupted by an abort (
ABORTPixel
) command
or reset by a
RESET
command.
Gain adjustment is controlled by three 5-bit DACs, one for each of the the three zones. Table 1 lists the gain
settings and the corresponding pixel values. Offset is affected by the gain setting and may have to be adjusted
after gain changes are made.
Offset correction is controlled by three 8-bit sign-magnitude
DACs and is performed in the analog domain prior
to the digital conversion. There is a separate offset DAC for each of the three zones. Codes 0h
7Fh correspond
to positive offset values and codes 80h – FFh correspond to negative offset values.
The offset correction is proportional to the gain setting. At minimal gain, one LSB of the offset DAC corresponds
to approximately 1/3 LSB of the device output, and at maximum gain, to about 1 LSB of the device output.
Note that the gain and offset registers are in indeterminate states after power up and must be set by the controller
as required.
Sign-magnitude is a binary representation in which the most significant bit (MSB) is used to represent the sign of the number, with the
remaining bits representing the magnitude. An MSB of 1 indicates a negative number.
相關PDF資料 |
PDF描述 |
|---|---|
| TSL3301 | 102 】 1 LINEAR OPTICAL SENSOR ARRAY WITH ANALOGTODIGITAL CONVERTER |
| TSLB257S | HIGH々SENSITIVITY COLOR LIGHT々TO々VOLTAGE CONVERTERS |
| TSLB257S-LF | HIGH々SENSITIVITY COLOR LIGHT々TO々VOLTAGE CONVERTERS |
| TSLG257S | HIGH々SENSITIVITY COLOR LIGHT々TO々VOLTAGE CONVERTERS |
| TSLG257S-LF | HIGH々SENSITIVITY COLOR LIGHT々TO々VOLTAGE CONVERTERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSL3301USBEVM | 功能描述:光學傳感器開發工具 TAOS Eval Module w/USB Interface RoHS:否 制造商:ams 工具用于評估: 接口類型: 最大工作溫度: |
| TSL3LTE20L0D | 制造商:KOA 制造商全稱:KOA Speer Electronics, Inc. 功能描述:surface mount molded current sense resistors |
| TSL3LTE20L0F | 制造商:KOA 制造商全稱:KOA Speer Electronics, Inc. 功能描述:surface mount molded current sense resistors |
| TSL3LTE20L0G | 制造商:KOA 制造商全稱:KOA Speer Electronics, Inc. 功能描述:surface mount molded current sense resistors |
| TSL3LTE20L0H | 制造商:KOA 制造商全稱:KOA Speer Electronics, Inc. 功能描述:surface mount molded current sense resistors |
發布緊急采購，3分鐘左右您將得到回復。