參數資料
型號: TPS54386PWPG4
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: 7 A DUAL SWITCHING CONTROLLER, 750 kHz SWITCHING FREQ-MAX, PDSO14
封裝: GREEN, PLASTIC, HTSSOP-14
文件頁數: 7/58頁
文件大?。?/td> 1773K
代理商: TPS54386PWPG4
www.ti.com
5-V VOUT1
(2 V/div)
3.3-V VOUT2
(2 V/div)
T - Time - 1 ms/div
Soft Start
SLUS774B – AUGUST 2007 – REVISED OCTOBER 2007
NOTE:
An R-C network connected to the ENx pin may be used in addition to the SEQ pin in
sequential mode to delay the startup of the first output voltage. This approach may be
necessary in systems with a large number of output voltages and elaborate voltage
sequencing requirements. See Enable and Timed Turn On of the Outputs.
If the SEQ pin is left floating, Output 1 and Output 2 each start ratiometrically when both outputs are enabled at
the same time. Output 1 and Output 2 soft start at a rate that is determined by the respective final output
voltages and enter regulation at the same time. If the EN1 and EN2 pins are allowed to operate independently,
then the two outputs also operate independently.
Figure 20. SEQ Pin Floating
Each output has a dedicated soft start circuit. The soft start voltage is an internal digital reference ramp to one of
two noninverting inputs of the error amplifier. The other input is the (internal) precision 0.8-V reference. The total
ramp time for the FB voltage to charge from 0 V to 0.8 V is about 2.1 ms. During a soft start interval, the
TPS5438x output slowly increases the voltage to the noninverting input of the error amplifier. In this way, the
output voltage ramps up slowly until the voltage on the noninverting input to the error amplifier reaches the
internal 0.8 V reference voltage. At that time, the voltage at the noninverting input to the error amplifier remains
at the reference voltage.
NOTE:
To avoid a disturbance in the output voltage during the stepping of the digital soft
start, a minimum output capacitance of 50
F is recommended. See Feedback Loop
and Inductor-Capacitor (L-C) Filter Selection Once the filter and compensation
components have been established, laboratory measurements of the physical design
should be performed to confirm converter stability.
During the soft start interval, pulse-by-pulse current limiting is in effect. If an overcurrent pulse is detected, six
PWM pulses are skipped to allow the inductor current to decay before another PWM pulse is applied. (See the
Output Overload Protection section.) There is no pulse skipping if a current limit pulse is not detected.
DESIGN HINT
If the rate of rise of the input voltage (PVDDx) is such that the input voltage is too low
Copyright 2007, Texas Instruments Incorporated
15
Product Folder Link(s): TPS54383 TPS54386
相關PDF資料
PDF描述
TPS54521RHLT SWITCHING REGULATOR, PQCC14
TPS54550PWP 9.5 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO16
TPS54550PWPRG4 9.5 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO16
TPS54610PWPR 12 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28
TPS54610PWPRG4 12 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28
相關代理商/技術參數
參數描述
TPS54386PWPR 功能描述:直流/直流開關調節器 DC/DC Controller RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS54386PWPRG4 功能描述:直流/直流開關調節器 3A Non-Synch Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS54386PWPRQ1 制造商:TI 功能描述:DC/DC Controller
TPS54386-Q1 制造商:TI 制造商全稱:Texas Instruments 功能描述:3-A DUAL NON-SYNCHRONOUS CONVERTER WITH INTEGRATED HIGH-SIDE MOSFET
TPS54386TPWPRQ1 功能描述:開關變換器、穩壓器與控制器 4.5-28V,Dual 3A Out 600kHz SD Converter RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel