參數資料
型號： TPS54386PWPG4
廠商： TEXAS INSTRUMENTS INC
元件分類： 穩壓器
英文描述： 7 A DUAL SWITCHING CONTROLLER, 750 kHz SWITCHING FREQ-MAX, PDSO14
封裝： GREEN, PLASTIC, HTSSOP-14
文件頁數： 6/58頁
文件大?。?/td> 1773K
代理商： TPS54386PWPG4
www.ti.com
Output Voltage Sequencing
5-V VOUT1
(2 V/div)
3.3-V VOUT2
(2 V/div)
T - Time - 1 ms/div
SEQ = BP
Sequential
CH2 then CH1
T - Time - 1 ms/div
SEQ = GND
Sequential
CH1 then CH2
5-V VOUT1
(2 V/div)
3.3-V VOUT2
(2 V/div)
SLUS774B – AUGUST 2007 – REVISED OCTOBER 2007
The TPS5438x allows single-pin programming of output voltage startup sequencing. During power-on, the state
of the SEQ pin is detected. Based on whether the pin is tied to BP, to GND, or left floating, the outputs behave
as described in Table 1.
Table 1. Sequence States
SEQ PIN STATE
MODE
EN1
EN2
Ignored by the device.when VEN2 <
enable threshold voltage
Tie EN1 to < enable threshold voltage
for BP to be active when VEN2 >
BP
Sequential, Output 2 then Output 1
Active
enable threshold voltage
Tie EN1 to > enable threshold voltage
for low quiescent current (BP inactive)
when VEN2 > enable threshold voltage
Ignored by the device.when VEN1 <
enable threshold voltage
Tie EN2 to < enable threshold voltage
for BP to be active when VEN1 >
GND
Sequential, Output 1 then Output 2
Active
enable threshold voltage
Tie EN2 to > enable threshold voltage
for low quiescent current (BP inactive)
when VEN1 > enable threshold voltage
Independent or Ratiometric, Output 1
Active. EN1 and EN2 must be tied
(floating)
and Output 2
together for Ratio-metric startup.
If the SEQ pin is connected to BP, then when Output 2 is enabled, Output 1 is allowed to start approximately 400
s after Output 2 has reached regulation; that is, sequential startup where Output 1 is slave to Output 2. If EN2 is
allowed to go high after the outputs have been operating, then both outputs are disabled immediately, and the
output voltages decay according to the load that is present.
If the SEQ pin is connected to GND, then when Output 1 is enabled, Output 2 is allowed to start approximately
400
s after Output 1 has reached regulation; that is, sequential startup where Output 2 is slave to Output 1. If
EN1 is allowed to go high after the outputs have been operating, then both outputs are disabled immediately,
and the output voltages decay according to the load that is present.
Figure 18. SEQ Pin TIed to BP
Figure 19. SEQ Pin Tied to GND
14
Copyright 2007, Texas Instruments Incorporated
Product Folder Link(s): TPS54383 TPS54386
相關PDF資料
PDF描述
TPS54521RHLT SWITCHING REGULATOR, PQCC14
TPS54550PWP 9.5 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO16
TPS54550PWPRG4 9.5 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO16
TPS54610PWPR 12 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28
TPS54610PWPRG4 12 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28
相關代理商/技術參數
參數描述
TPS54386PWPR 功能描述:直流/直流開關調節器 DC/DC Controller RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS54386PWPRG4 功能描述:直流/直流開關調節器 3A Non-Synch Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS54386PWPRQ1 制造商:TI 功能描述:DC/DC Controller
TPS54386-Q1 制造商:TI 制造商全稱:Texas Instruments 功能描述:3-A DUAL NON-SYNCHRONOUS CONVERTER WITH INTEGRATED HIGH-SIDE MOSFET
TPS54386TPWPRQ1 功能描述:開關變換器、穩壓器與控制器 4.5-28V,Dual 3A Out 600kHz SD Converter RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*