參數資料
型號: TPS54262QPWPRQ1
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: SWITCHING REGULATOR, PDSO20
封裝: GREEN, PLASTIC, HTSSOP-20
文件頁數: 5/42頁
文件大?。?/td> 2335K
代理商: TPS54262QPWPRQ1
L
f
2
V
D)
(1
I
sw
Reg
L_LPM
L_DISCONT
×
-
=
L
f
2
V
D)
(1
I
sw
Reg
L_LPM
L_DISCONT
×
-
=
Reg
DS(ON)
Load
V
~
R
I
VIN
<
-
Min
OFF
sw
Reg
t
f
1
VIN
V
1
-
>
÷
è
-
and
www.ti.com
SLVS996C – SEPTEMBER 2009 – REVISED JUNE 2010
1) Active Mode Continuous Conduction Mode (CCM)
In this mode of operation the switcher operates in continuous conduction mode, and the inductor current is
always non-zero if the total load current (internal and external) is greater than IL_DISCONT shown in Equation 3.
(3)
Where,
D = duty cycle
L = output inductor
VReg = output voltage
fsw = switching frequency
For VIN < 8.5 V, the device enables an internal ~100
Ω load. This, combined with the external load, can cause
the device to enter into CCM even under light external loading conditions (see Figure 14). This mode of
operation is shown in Figure 15 is also called the Normal mode of operation.
Figure 15. Active Mode CCM
Figure 16. Active Mode DCM
2) Active Mode Discontinuous Conduction Mode (DCM)
In this mode of operation the switcher operates in discontinuous conduction mode, and the inductor current
becomes zero if the total load current (internal and external) is less than IL_DISCONT shown in Equation 4.
(4)
The device enters in this mode of operation when LPM pin is set high (i.e disabled) and output loading is less
than IL_DISCONT. This mode of operation is shown in Figure 16.
3) Pulse Skip Mode (PSM)
In this mode of operation the switcher operates in discontinuous conduction mode, and the inductor current
becomes zero. The device enters in this mode of operation in the following conditions:
At low input voltages when VReg starts losing regulation and the OFF time (tOFF) of the switching FET tends to
be close to or slightly less than the minimum OFF time (tOFF-Min). If OFF time is much smaller than tOFF-Min,
there is a risk that the part stops switching and regulation is lost until power is re-cycled with OFF time
greater than tOFF-Min. This mode of operation is shown in Figure 18. Comparing Figure 17 and Figure 18,
pulse skipping occurs in Figure 18 but not in Figure 17 under similar output loading conditions.
(5)
Copyright 2009–2010, Texas Instruments Incorporated
13
Product Folder Link(s): TPS54262-Q1
相關PDF資料
PDF描述
TPS54286PWPG4 3.6 A DUAL SWITCHING CONTROLLER, 750 kHz SWITCHING FREQ-MAX, PDSO14
TPS54283PWPR 3.6 A DUAL SWITCHING CONTROLLER, 375 kHz SWITCHING FREQ-MAX, PDSO14
TPS54286PWPRG4 3.6 A DUAL SWITCHING CONTROLLER, 750 kHz SWITCHING FREQ-MAX, PDSO14
TPS54290PWP 4.6 A DUAL SWITCHING CONTROLLER, 360 kHz SWITCHING FREQ-MAX, PDSO16
TPS54291PWPR 4.6 A DUAL SWITCHING CONTROLLER, 720 kHz SWITCHING FREQ-MAX, PDSO16
相關代理商/技術參數
參數描述
TPS54283 制造商:TI 制造商全稱:Texas Instruments 功能描述:SWIFT Converter Product Portfolio
TPS54283PWP 功能描述:直流/直流開關調節器 2A Non-Synch Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS54283PWPG4 功能描述:直流/直流開關調節器 2A Non-Synch Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS54283PWPR 功能描述:直流/直流開關調節器 2A Dual Non-Synch Buck Conv RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS54283PWPRG4 功能描述:直流/直流開關調節器 2A Non-Synch Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5