參數資料
型號： TPS54062DGKR
廠商： TEXAS INSTRUMENTS INC
元件分類： 穩壓器
英文描述： SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, PDSO8
封裝： PLASTIC, MSOP-8
文件頁數： 5/30頁
文件大?。?/td> 745K
代理商： TPS54062DGKR
OUT
LS
O
DC
O
SW
ON
IN
O
HS
O
LS
V
+ R
I
+ R
I
1
(maxskip) =
t
V
I
R
+ I
R
f
÷
÷
-
è
è
OUTSC
LS
CL
DC
CL
SW
ON
IN
CL
HS
CL
LS
V
+ R
× I
+ R
I
div
(shift) =
×
t
V
I
R
+ I
R
f
÷
÷
-
è
è
RT/CLK
TPS54062
Clock
Source
PLL
RT
RT/CLK
TPS54062
Hi-Z
Clock
Source
PLL
RT
SLVSAV1
– MAY 2011
short-circuit events (particularly with high input voltage applications), the control loop has a finite minimum
controllable on time and the output has a low voltage. During the switch on time, the inductor current ramps to
the peak current limit because of the high input voltage and minimum on time. During the switch off time, the
inductor would normally not have enough off time and output voltage for the inductor to ramp down by the ramp
up amount. The frequency shift effectively increases the off time allowing the current to ramp down.
(5)
(6)
Where:
IO = Output current
ICL = Current Limit
VIN = Input Voltage
VOUT = Output Voltage
VOUTSC Output Voltage during short
RDC = Inductor resistance
RHS = High side MOSFET resistance
RLS = Low side MOSFET resistance
ton = Controllable on time
fdiv = Frequency divide (equals 1, 2, 4, or 8)
How to Interface to RT/CLK Pin
The RT/CLK pin can be used to synchronize the regulator to an external system clock. To implement the
synchronization feature connect a square wave to the RT/CLK pin through one of the circuit networks shown in
Figure 20. The square wave amplitude must transition lower than 0.5V and higher than 1.3V on the RT/CLK pin
and have an on time greater than 40 ns and an off time greater than 40ns. The synchronization frequency range
is 300kHz to 400kHz. The rising edge of the PH will be synchronized to the falling edge of RT/CLK pin signal.
The external synchronization circuit should be designed in such a way that the device will have the default
frequency set resistor connected from the RT/CLK pin to ground should the synchronization signal turn off. It is
recommended to use a frequency set resistor connected as shown in Figure 20 through another resistor (e.g.,
50
Ω) to ground for clock signal that are not Hi-Z or 3-state during the off state. The sum of the resistance should
set the switching frequency close to the external CLK frequency. It is recommended to ac couple the
synchronization signal through a 10pF ceramic capacitor to RT/CLK pin. The first time the CLK is pulled above
the CLK threshold the device switches from the RT resistor frequency to PLL mode. The internal 0.5V voltage
source is removed and the CLK pin becomes high impedance as the PLL starts to lock onto the external signal.
Since there is a PLL on the regulator the switching frequency can be higher or lower than the frequency set with
the external resistor. The device transitions from the resistor mode to the PLL mode and then will increase or
decrease the switching frequency until the PLL locks onto the CLK frequency within 100 microseconds. When
the device transitions from the PLL to resistor mode the switching frequency will slow down from the CLK
frequency to 150kHz, then reapply the 0.5V voltage and the resistor will then set the switching frequency. The
switching frequency is divided by 8, 4, 2, and 1 as the voltage ramps from 0 to 0.8 volts on VSENSE pin. The
device implements a digital frequency shift to enable synchronizing to an external clock during normal startup
and fault conditions.
Figure 20. Synchronizing to a System Clock
Copyright
2011, Texas Instruments Incorporated
13
Product Folder Link(s): TPS54062
相關PDF資料
PDF描述
TPS54140DGQR SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO10
TPS54140DGQ SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO10
TPS54162QPWPRQ1 3 A SWITCHING REGULATOR, 2200 kHz SWITCHING FREQ-MAX, PDSO20
TPS5420DR 5 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO8
TPS5420D 6.5 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO8
相關代理商/技術參數
參數描述
TPS54062DRBR 功能描述:直流/直流開關調節器 4.7-60Vin,50mA Sync Step-Down Cnvrtr RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS54062DRBT 功能描述:直流/直流開關調節器 4.7-60Vin,50mA Sync Step-Down Cnvrtr RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS54062EVM-695 功能描述:電源管理IC開發工具 TPS54062 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
TPS54073 制造商:TI 制造商全稱:Texas Instruments 功能描述:2.2 ?4 -V, 14-A SYNCHRONOUS BUCK CONVERTER WITH DISABLED SINKING DURING START-UP
TPS54073EVM-098 功能描述:電源管理IC開發工具 14A DC/DC Conv Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*