參數資料
型號: TPS40040DRBT
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: 7.2 A SWITCHING CONTROLLER, 350 kHz SWITCHING FREQ-MAX, PDSO8
封裝: 3 X 3 MM, PLASTIC, SON-8
文件頁數: 8/38頁
文件大?。?/td> 741K
代理商: TPS40040DRBT
www.ti.com
VDD Filter Resistor
Thermal Shutdown
Package Power Dissipation
P
D(driver) + QG
V
DRIVE
F
SW W driver
(1)
P
T +
2
P
D
V
DRIVE
) I
Q
V
DD W
(2)
P
T + 2
G
Q
F
SW ) IQ
V
DD W
(3)
SLUS700D – MARCH 2006 – REVISED DECEMBER 2007
To further limit the noise on VDD, a small 1-
to 2- resistor may be placed between the input voltage and the
VDD pin to create a small filter to VDD. The resistor should connect near the drain of the upper switch MOSFET
to prevent trace IR drops from increasing the sensed voltage drop. The resistor itself should be placed close to
Pin 4.
The current through the resistor includes the device's no-load switching current of 2 mA plus gate switching
current. The voltage drop induced across this resistor reduces the VDD-to-SW voltage sensed by the over
current protection circuitry within the device. This results with the apparent voltage drop across the upper switch
MOSFET being increased, thereby decreasing the current at which protection will occur. To minimize this effect,
the resistor value should be selected to yield less than a 25-mV drop.
If the junction temperature of the device reaches the thermal shutdown level, the PWM and the oscillator are
turned off and HDRV and LDRV are driven off. When the junction cools to the required level, the PWM soft starts
as during a normal power-up cycle.
The power dissipation in a controller is largely dependent on the MOSFET driver currents and the input voltage.
The driver current is proportional to the total gate charge, QG, of the external MOSFETs, and the operating
frequency of the converter. Driver power, neglecting external gate resistance, is calculated from:
And the total power dissipation, assuming the same MOSFET is selected for both the high side and synchronous
rectifier is:
or
where IQ is the quiescent operating current (neglecting drivers).
The max power capability of the PowerPad package is dependent on the layout as well as air flow. The
thermal impedance from junction-to-air assuming 2-oz copper trace and thermal pad with solder and no air flow
is detailed in Reference [5].
16
Copyright 2006–2007, Texas Instruments Incorporated
Product Folder Link(s): TPS40040 TPS40041
相關PDF資料
PDF描述
TPS40041DRBRG4 7.2 A SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO8
TPS40050QPWPRQ1 SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS40051QPWPRQ1 SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS40051PWP 0.2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS40050PWP 0.2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
相關代理商/技術參數
參數描述
TPS40040DRBT 制造商:Texas Instruments 功能描述:Peak Reflow Compatible (260 C):Yes
TPS40040DRBTG4 功能描述:DC/DC 開關控制器 Lo Vin Synch Buck DC/DC Cntrlr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40040EVM-001 功能描述:電源管理IC開發工具 10A Synch Buck Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
TPS40041 制造商:TI 制造商全稱:Texas Instruments 功能描述:LOW PIN COUNT, LOW VIN (2.5 V TO 5.5 V) SYNCHRONOUS BUCK DC-TO-DC CONTROLLER WITH ENABLE
TPS40041DRBR 功能描述:DC/DC 開關控制器 Low Vin Synch Buck DC/DC Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK