- 您現在的位置：買賣IC網 > PDF目錄385946 > TPS2350EVM (Texas Instruments, Inc.) TPS2350 -48V Hot Swap/Supply Selector Evaluation Module(’-48V熱交換/電源選擇器TPS2350的評估板) PDF資料下載
參數資料
| 型號： | TPS2350EVM |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | TPS2350 -48V Hot Swap/Supply Selector Evaluation Module(’-48V熱交換/電源選擇器TPS2350的評估板) |
| 中文描述： | TPS2350 - 48V熱插拔/供應選擇評估模塊（\u0026#39;- 48V的熱交換/電源選擇器TPS2350的評估板） |
| 文件頁數： | 12/20頁 |
| 文件大小： | 375K |
| 代理商： | TPS2350EVM |
SLUU171A - September 2003
12
TPS2350 48-V Hot Swap/Supply Selector Evaluation Module
3.2
Verifying the EVM Operation
The following procedure steps may be used to verify functional operation of the EVM after receipt.
3.2.1
Equipment Setup
On the EVM, place the POWER and ENABLE switches in the OFF position.
Set the DIP switches 1 through 4 of switch SW1 to the ON position.
Turn on power supply number 1 (PS No. 1) and adjust the output for about 48 V. Turn on power supply number
2 (PS No. 2) and adjust the output for about 44 V. Verify the current limit of supplies 1 and 2 is set to allow sourcing
of at least 3 A. Turn off the supplies
Turn on power supply number 3 (PS No. 3), and adjust the output to about 5 V. Turn off the power supply.
Connect the EVM and test equipment as shown in Figure 4.
OSCILLOSCOPE
CH 1
CH 2
CH 3
CH 4
TPS2350 48V
Supply Selector
Evaluation Module
J2 (48V_INA)
J1 (48V_RTN)
TP6
TP5
TP25
TP15 (GND)
PS No. 1
(+48 VDC)
+
TP24
TP22
J3 (48V_INB)
PS No. 2
(+44 VDC)
+
PS No. 3
(+5 VDC)
+
(VS) J6
(VOUT) J5
TP3
VOLTS COM
DMM
(GND) TP7
Connect test leads
as desired.
Figure 4. TPS2350 48-V Supply Selector EVM Equipment Setup
On the oscilloscope, set the channel amplifiers to the following scales:
CH1: 2 V/div
CH2: 2 V/div
CH3: 5 V/div
CH4: 20 V/div
For easier correlation to the information in this document, the scope trace baselines can be positioned as shown
in Figure 5.
Set the scope to trigger on the rising edge of channel 1, at about a 1-V level. Set the scope timebase to 10 ms,
and the trigger mode to NORMAL.
相關PDF資料 |
PDF描述 |
|---|---|
| TPS2370EVM | Power Over Ethernet Powered Device (PD) EVM(在支持以太網功率驅動裝置的電源熱插拔評估) |
| TPS2811(中文) | Dual High-Speed MOSFET Drivers, Noninverting(雙路高速反相MOSFET驅動器) |
| TPS2812(中文) | Dual High-Speed MOSFET Drivers, Inverting(雙路高速同相MOSFET驅動器) |
| TPS2813(中文) | Dual High-Speed MOSFET Drivers, 1 Noninverting,1 Inverting(一路同相，一路反相高速MOSFET驅動器) |
| TPS2814(中文) | Dual High-Speed MOSFET Drivers, 1 Noninverting,1 Inverting(2輸入AND高速MOSFET驅動器,一路同相,一路反相) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS2350PW | 功能描述:熱插拔功率分布 Pwr Mngr for Redund -48V Supplies RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS2350PW | 制造商:Texas Instruments 功能描述:HOT SWAP CONTROLLER ((NW)) 制造商:Texas Instruments 功能描述:IC, HOT SWAP POWER MANAGER, 14-TSSOP |
| TPS2350PWG4 | 功能描述:熱插拔功率分布 Pwr Mngr for Redund -48V Supplies RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS2350PWR | 功能描述:熱插拔功率分布 Pwr Mngr for Redund -48V Supplies RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| TPS2350PWRG4 | 功能描述:熱插拔功率分布 Pwr Mngr for Redund -48V Supplies RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。