參數資料
型號： TEA6880
廠商： NXP Semiconductors N.V.
英文描述： ECONOLINE: RB & RA - Dual Output from a Single Input Rail- Power Sharing on Output- Industry Standard Pinout- 1kVDC & 2kVDC Isolation- Custom Solutions Available- UL94V-0 Package Material- Efficiency to 85%
中文描述： 截至級車電臺模擬信號處理器支持核心計劃
文件頁數： 10/88頁
文件大?。?/td> 328K
代理商： TEA6880
2000 May 08
10
Philips Semiconductors
Product specification
Up-level Car radio Analog Signal
Processor (CASP)
TEA6880H
7
FUNCTIONAL DESCRIPTION
7.1
Stereo decoder
The MPX input is the null-node of an operational amplifier
with internal feedback resistor. Adapting the stereo
decoder input to the level of the MPX signal, coming from
the FM demodulator output, is realized by the value of the
input series resistor R
IN
. To this input a second source
(AM detector output) can be fed by current addition.
The input amplifier is followed by an integrated 4th order
Bessel low-pass filter with a cut-off frequency of 80 kHz.
It provides necessary signal delay for FM noise blanking
and damping of high frequency interferences coming to
the stereo decoder input.
Output of this filter is fed to the soft mute control circuitry,
the output is voltage to current converted and then fed to
phase detector, pilot detector and pilot canceller circuits,
contained in the stereo decoder PLL block. For
regeneration of the 38 kHz subcarrier, a PLL is used.
The fully integrated oscillator is adjusted by means of a
digitalauxiliaryPLLintothecapturerangeofthemainPLL.
The auxiliary PLL needs an external reference frequency
(75.4 kHz) which is provided by the TEA6840H.
The required 19 and 38 kHz signals are generated by
division of the oscillator output signal in a logical circuitry.
The 19 kHz quadrature phase signal is fed to the 19 kHz
phase detector, where it is compared with the incoming
pilot tone. The DC output signal of the phase detector
controls the oscillator (PLL).
The pilot presence detector is driven by an internally
generated in-phase 19 kHz signal. Its pilot dependent DC
output voltage is fed to a threshold switch, which activates
thepilotindicatorbitandturnsthestereodecodertostereo
operation. The same DC voltage is used to control the
amplitude of an anti-phase internally generated 19 kHz
signal. In the pilot canceller, the pilot tone is compensated
by this anti-phase 19 kHz signal.
The pilot cancelled signal is fed to the matrix. There, the
side signal is demodulated and combined with the main
signal to left and right audio channel. Compensation for
roll-off in the incoming MPX signal caused by IF filters and
FM demodulator is typically realized by an external
compensation network at pin 57, individual alignment is
achieved by I
2
C-bus controlled amplification of the side
signal (DAA). A smooth mono to stereo takeover is
achieved by controlling the efficiency of the matrix with
help of the SNC peak detector.
The matrix is followed by the FM noise suppression gates,
which are combined with FM single poles and High Cut
Control (HCC). The single pole is defined by internal
resistors and external capacitors. From the gate circuits
audio is fed to the switchable de-emphasis, where the
demodulated AM stereo signal can be fed in. After
de-emphasis the signal passes to the output buffers and is
fed to the radio input of the source selector. For HCC, the
time constant of the single pole contained in the output
buffer can be changed to higher values. This function is
controlled by an average detector contained in the
multipath and fading detector.
7.2
FM noise blanker
The input of the ignition noise blanker is coupled to the
MPXRDS (pin 55) input signal and to the IF level input
(pin 3). Both signals are fed via separate 120 kHz filters
and rectifiers to an adder circuit. The output signal of the
adder circuit is fed in parallel to the noise detector and the
interference detector. The noise detector is a negative
peak detector. Its output controls the trigger sensitivity
(prevention to false triggering at noisy input signals) and
the gain of the MPX high-pass filter. The output of the
interference detector, when receiving a steep pulse, fires a
monoflop, contained in the pulse former circuitry. The time
constantofthemonoflopisdefinedbyaninternalcapacitor
and its output activates the blanking gates in the audio.
7.3
AM noise blanker
The AM noise blanking pulse is derived from the AM audio
signal which is fed into pin 53 with the help of a
peak-to-average comparator. The blanking time is set by a
pulse former with external capacitor. The blanking pulse is
fed to the gate in the AM audio path and out to pin
AMHOLD to operate the gate built into the external
AM stereo processor.
7.4
Multipath/fading detection and weak signal
control
For FM signal quality dependent controls there is built-in a
combinationofsixdetectorsdrivenbythelevelinformation
direct, by the AC components on the level via a 20 kHz
band-pass filter (AM wideband) or the high notes present
at the FM demodulator output via a 60 kHz high-pass filter
(ultrasonic noise). The relation between DC level and the
AC components is programmable by the I
2
C-bus (2 bits
each). Output of level buffer, AM wideband detector and
ultrasonic noise detector are analog-to-digital converted
and readable by the I
2
C-bus.
相關PDF資料
PDF描述
TEA6880H Up-level Car radio Analog Signal Processor CASP
TECO3264 32-Channel Echo Canceller(32通道回波清除器)
TFH150A 150 MHz SAW Filter For CDMA Basestation Applications(150 MHz SAW濾波器(CDMA基站設備應用))
TFH155A 155.52 MHz SAW Filter for SDH/SONET Timing Recovery Applications(155.52 MHz SAW濾波器(SDH/SONET定時恢復應用))
TFH160A 160 MHz SAW Filter For CDMA Basestation Applications(160 MHz SAW濾波器(CDMA基站設備應用))
相關代理商/技術參數
參數描述
TEA6880H 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Up-level Car radio Analog Signal Processor CASP
TEA6880H/V2 功能描述:音頻 DSP AUDIO POWER MISC RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube
TEA6880H/V2,518 功能描述:音頻 DSP AUDIO POWER RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube
TEA6880H/V2,557 功能描述:音頻 DSP AUDIO POWER MISC RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube
TEA6880HBA-T 功能描述:音頻 DSP AUDIO POWER RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*