參數資料
型號： TDA9884TS
廠商： NXP SEMICONDUCTORS
元件分類： 接收器
英文描述： I2C-bus controlled multistandard alignment-free IF-PLL for mobile reception
中文描述： AM/FM, AUDIO/VIDEO DEMODULATOR, PDSO24
封裝： 5.30 MM, PLASTIC, SOT-340-1, MO-150, SSOP-24
文件頁數： 11/55頁
文件大小： 231K
代理商： TDA9884TS
2003 Nov 28
11
Philips Semiconductors
Product specification
I
2
C-bus controlled multistandard alignment-free
IF-PLL for mobile reception
TDA9884TS
7.10
SIF-AGC detector
SIF gain control is performed by the detection of the
DC component of the AM demodulator output signal. This
DC signal corresponds directly to the SIF voltage at the
output of the SIF amplifier so that a constant SIF signal is
supplied to the AM demodulator and to the single
reference QSS mixer.
By switching the gain of the input amplifier of the SIF-AGC
detector via the I
2
C-bus, the internal SIF level for
FM sound is 5.5 dB lower than for AM sound. This is to
adapt the SIF-AGC characteristic to the VIF-AGC
characteristic. The adaption is ideal for a picture-to-sound
FM carrier ratio of 13 dB.
Viaacomparator,theintegratedAGCcapacitorischarged
or discharged for the generation of the required SIF gain.
Due to AM sound, the AGC reaction time is slow
(f
c
< 20 Hz for the closed AGC loop). For reducing this
AM sound time constant in the event of a decreasing
IF amplitude step, the charging and discharging currents
of the AGC capacitor are increased by a factor of 12 (fast
mode) when the VIF-AGC detector (at positive modulation
mode) operates in the fast mode too. An additional circuit
(threshold approximately 7 dB) ensures a very fast gain
reduction for a large increasing IF amplitude step.
For negative modulation and QSS mode the AGC also is
set to fast mode. For negative modulation and mobile
mode the currents are increased additionally by a factor
of 36.
7.11
Single reference QSS mixer
With the present system a high performance Hi-Fi stereo
sound processing can be achieved. For a simplified
application without a SIF SAW filter, the single reference
QSSmixercanbeswitchedtotheintercarriermodeviathe
I
2
C-bus.
The single reference QSS mixer generates the 2nd FM
TV sound intercarrier signal. It is realized by a linear
multiplier which multiplies the SIF amplifier output signal
and the VIF-PLL VCO signal (90 degrees output) which is
locked to the picture carrier. In this way the QSS mixer
operates as a quadrature mixer in the intercarrier mode
and provides suppression of the low frequency video
signals.
In the true split sound mode the VIF-PLL VCO is locked by
a synthesizer. By this the 2nd FM TV sound intercarrier
signal is generated independently from the vision carrier
so that in the case of a low RF level, the sound
demodulationispossiblewheretheVIF-PLLwouldunlock.
In the true split sound mode the VIF demodulation is not
available.
The QSS mixer output signal is fed internally via a
high-pass and low-pass combination to the
FM demodulator as well as via an operational amplifier to
the intercarrier output pin SIOMAD.
7.12
AM demodulator
The amplitude modulated SIF amplifier output signal is fed
both to a two-stage limiting amplifier that removes the AM
and to a linear multiplier. The result of the multiplication of
the SIF signal with the limiter output signal is
AM demodulation (passive synchronous demodulator).
The demodulator output signal is fed via a low-pass filter
that attenuates the carrier harmonics and via the input
amplifier of the SIF-AGC detector to the audio amplifier.
7.13
FM demodulator and acquisition help
The narrow-band FM-PLL detector consists of:
Gain controlled FM amplifier and AGC detector
Narrow-band PLL.
The intercarrier signal from the intercarrier mixer is fed to
the input of an AC-coupled gain controlled amplifier with
two stages. The gain controlled output signal is fed to the
phase detector of the narrow-band FM-PLL
(FM demodulator). For good selectivity and robustness
against disturbance caused by the video signal, a high
linearity of the gain controlled FM amplifier and of the
phase detector as well as a constant signal level are
required. The gain control is done by means of an ‘in
phase’ demodulator for the FM carrier (from the output of
the FM amplifier). The demodulation output is fed into a
comparator for charging or discharging the integrated
AGC capacitor. This leads to a mean value AGC loop to
control the gain of the FM amplifier.
The FM demodulator is realized as a narrow-band PLL
with an external loop filter, which provides the necessary
selectivity(bandwidthapproximately100 kHz).Toachieve
good selectivity, a linear phase detector and a constant
input level are required. The gain controlled intercarrier
signal from the FM amplifier is fed to the phase detector.
The phase detector controls via the loop filter the
integratedlowradiationrelaxationoscillator.Thedesigned
frequency range is from 4 to 7 MHz.
相關PDF資料
PDF描述
TDA9885 I2C-bus controlled single and multistandard alignment-free IF-PLL demodulators
TDA9886 I2C-bus controlled single and multistandard alignment-free IF-PLL demodulators
TDA9887 I2C-bus controlled multistandard alignment-free IF-PLL demodulator with FM radio
TDA9888 DVB selective AGC amplifier
TDA9889 DVB selective AGC amplifier
相關代理商/技術參數
參數描述
TDA9884TS/V1 功能描述:調節器/解調器 MOBILE VIF AND SIF DEMODULATOR RoHS:否 制造商:Texas Instruments 封裝 / 箱體:PVQFN-N24 封裝:Reel
TDA9884TS/V1,112 功能描述:調節器/解調器 MOBILE VIF AND SIF RoHS:否 制造商:Texas Instruments 封裝 / 箱體:PVQFN-N24 封裝:Reel
TDA9884TS/V1,118 功能描述:調節器/解調器 MOBILE VIF AND SIF RoHS:否 制造商:Texas Instruments 封裝 / 箱體:PVQFN-N24 封裝:Reel
TDA9884TS/V1/S1,11 功能描述:調節器/解調器 MOBILE VIF AND SIF RoHS:否 制造商:Texas Instruments 封裝 / 箱體:PVQFN-N24 封裝:Reel
TDA9884TS/V1/S1,118 制造商:NXP Semiconductors 功能描述:PHATDA9884TS/V1/S1.118 MOBILE VIF/SIF
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*