- 您現在的位置：買賣IC網 > PDF目錄380766 > STM1404 (意法半導體) Security Supervisor with Battery Switchover(帶電池轉換功能的安全監控器) PDF資料下載
參數資料
| 型號： | STM1404 |
| 廠商： | 意法半導體 |
| 英文描述： | Security Supervisor with Battery Switchover(帶電池轉換功能的安全監控器) |
| 中文描述： | 安全監控與電池切換（帶電池轉換功能的安全監控器） |
| 文件頁數： | 13/36頁 |
| 文件大?。?/td> | 362K |
| 代理商： | STM1404 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
STM1404
Pin descriptions
13/36
If a Security Alarm (SAL) is issued on Tamper, then the state of the Vccsw pin is as follows:
1.
STM1404A (V
OUT
remains ON when SAL is active-low): Vccsw pin will continue to
operate in normal mode;
2.
STM1404B (V
OUT
is taken to High-Z when SAL is active-low): Vccsw pin will be set to
High when this occurs; and
3.
STM1404C (V
OUT
is driven to Ground when SAL is active-low): Vccsw pin will be set to
High when this occurs.
BLD, V
BAT
low voltage detect output (open drain)
This is an internally loaded test of the battery, activated only during a power-up sequence to
insure that the battery is good either prior to or after encapsulation of the module. There are
three customer options for V
DET
:
2.3V (2.5V – external diode drop of about 0.2V) for a 3V lithium cell;
2.5V (2.7V – 0.2V) for a 3V lithium cell; or
3.2V (3.4V – 0.2V) for a 3.68V lithium “AA” battery.
●
●
●
This output pin will go active-low when it detects a voltage on the V
BAT
pin below V
DET
. BLD
will be released when V
CC
drops below V
RST
.
Active-low RST output (open drain)
Goes low and stays low when V
CC
drops below V
RST
(Reset Threshold selected by the
customer), or when MR is logic low. It remains low for t
rec
(200ms, typical) AFTER V
CC
rises
above V
RST
and MR goes from low to high.
MR, Manual reset input
A logic low on MR asserts the RST output. The RST output remains asserted as long as MR
is low and for t
rec
after MR returns to high. This active low input has an internal 40k
Ω
(typical) pull-up resistor. It can be driven from a TTL or CMOS Logic line or shorted to
Ground with a switch. Leave it open if unused.
PFO, Power-fail output (open drain)
When PFI is less than V
PFI
(Power-fail Input Threshold Voltage) or V
CC
falls below V
SW
(battery switchover threshold ~ 2.4V), PFO goes low, otherwise, PFO remains high. Leave
this pin open if unused.
PFI, Power-fail input
When PFI is less than V
PFI
, or when V
CC
falls below V
SW
(see PFO, above), PFO goes
active-low. If this function is unused, connect this pin to V
SS
.
V
REF
, Reference voltage output (1.237, typ)
This is valid only when V
CC
is between 2.4V and 3.6V. When V
CC
falls below 2.4V (V
SW
),
V
REF
is pulled to Ground with an internal 100k
Ω
resistor. This is an optional feature available
on the STM1404A. On the STM1404B/C, this pin is V
TPU
(internally switched V
CC
or V
BAT
).
If unused, this pin should float.
相關PDF資料 |
PDF描述 |
|---|---|
| STM3210B-EVAL | STM32F10XXX Evaluation Board(STM32F10XXX評估板) |
| STM3210B-PRIMER | Raisonance STM32 Primer for fun, easy evaluation and development with STM32(STM32F10XXX系列開發工具，包括Raisonance開發軟件) |
| STM401-2 | RF POWER MODULE WIRELESS LOCAL LOOP APPLICATIONS |
| STM326-2 | RF POWER MODULE WIRELESS LOCAL LOOP APPLICATIONS |
| STM351-2 | RF POWER MODULE WIRELESS LOCAL LOOP APPLICATIONS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| STM1404_08 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:3 V FIPS-140 security supervisor with battery switchover |
| STM1404A | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Security Supervisor with Battery Switchover |
| STM1404ARMBQ6F | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:3 V FIPS-140 security supervisor with battery switchover |
| STM1404ARMCQ6F | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:3 V FIPS-140 security supervisor with battery switchover |
| STM1404ARMDQ6F | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:3 V FIPS-140 security supervisor with battery switchover |
發布緊急采購，3分鐘左右您將得到回復。