
SN74GTLPH16612
18-BIT LVTTL-TO-GTLP UNIVERSAL BUS TRANSCEIVER
SCES326 – MARCH 2000
6
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)
Supply voltage range, V
CC
: 3.3 V
–0.5 V to 4.6 V
–0.5 V to 7 V
–0.5 V to 7 V
–0.5 V to 4.6 V
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
B port and V
REF
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5 V
Input voltage range, V
I
(see Note 1): A-port and control inputs
Voltage range applied to any output in the high or power-off state, V
O
(see Note 1): A port
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
B port
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Current into any output in the low state, I
O
: A port
B port
Current into any A-port output in the high state, I
O
(see Note 2)
Continuous current through each V
CC
or GND
Input clamp current, I
IK
(V
I
< 0)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Output clamp current, I
OK
(V
O
< 0)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Package thermal impedance,
θ
JA
(see Note 3): DGG package
DL package
Storage temperature range, T
stg
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES:
1. The input and output negative-voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
2. This current flows only when the output is in the high state and VO > VCC.
3. The package thermal impedance is calculated in accordance with JESD 51.
–0.5 V to 7 V
–0.5 V to 4.6 V
128 mA
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
80 mA
64 mA
±
100 mA
–50 mA
–50 mA
64
°
C/W
56
°
C/W
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
–65
°
C to 150
°
C
recommended operating conditions (see Notes 4 through 6)
MIN
3.15
NOM
3.3
MAX
3.45
UNIT
VCC
Supply voltage
3.3 V
V
5 V
4.75
5
5.25
VTT
Termination voltage
GTL
1.14
1.2
1.26
V
GTLP
1.35
1.5
1.65
VREF
Supply voltage
GTL
0.74
0.8
0.87
V
GTLP
0.87
1
1.1
VI
Input voltage
B port
VTT
5.5
V
Except B port
VIH
High level input voltage
High-level input voltage
B port
VREF+50 mV
V
Except B port
2
VIL
Low level input voltage
Low-level input voltage
B port
VREF–50 mV
0.8
V
Except B port
IIK
IOH
Input clamp current
–18
mA
High-level output current
A port
–32
mA
IOL
Low level output current
Low-level output current
A port
64
mA
B port
34
TA
Operating free-air temperature
–40
85
°
C
NOTES:
4. All unused control inputs of the device must be held at VCC or GND to ensure proper device operation. Refer to the TI application
report Implications of Slow or Floating CMOS Inputs literature number SCBA004.
5. Normal connection sequence is GND first, VCC = 5 V second, and VCC = 3.3 V, I/O, control inputs, VTT, and VREF (any order) last.
6. VTT and RTT can be adjusted to accommodate backplane impedances as long as they do not exceed the dc absolute IOL ratings.
Similarly, VREF can be adjusted to optimize noise margins, but normally is 2/3 VTT.