- 您現在的位置：買賣IC網 > Datasheet目錄57 > SI4020-I1-FT (Silicon Laboratories Inc)IC TX FSK 915MHZ 5.4V 16-TSSOP Datasheet資料下載
參數資料
| 型號： | SI4020-I1-FT |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 24/32頁 |
| 文件大?。?/td> | 1058K |
| 描述： | IC TX FSK 915MHZ 5.4V 16-TSSOP |
| 標準包裝： | 96 |
| 頻率： | 315MHz，433MHz，868MHz，和 915MHz |
| 調制或協議： | FSK，OOK |
| 數據傳輸率 - 最大： | 256 kbps |
| 電流 - 傳輸： | 14mA |
| 數據接口： | PCB，表面貼裝 |
| 天線連接器： | PCB，表面貼裝 |
| 電源電壓： | 2.2 V ~ 5.4 V |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 16-TSSOP（0.173"，4.40mm 寬） |
| 包裝： | 管件 |
| 產品目錄頁面： | 585 (CN2011-ZH PDF) |
| 其它名稱： | 336-1621-5 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
Si4020
24
RESET MODES
The chip will enter into reset mode if any of the following conditions are met:
" Power-on reset: During a power up sequence until the Vdd has reached the correct level and stabilized
" Power glitch reset: Transients present on the V
dd
line
" Software reset: Special control command received by the chip
Power-on reset
After power up the supply voltage starts to rise from 0V. The reset block has an internal ramping voltage reference (reset-ramp
signal), which is rising at 100mV/ms (typical) rate. The chip remains in reset state while the voltage difference between the actual
Vdd and the internal reset-ramp signal is higher than the reset threshold voltage, which is 600 mV (typical). As long as the Vdd voltage
is less than 1.6V (typical) the chip stays in reset mode regardless the voltage difference between the Vdd and the internal ramp
signal.
The reset event can last up to 150ms supposing that the V
dd
reaches 90% its final value within 1ms. During this period the chip does
not accept control commands via the serial control interface.
Power-on reset example:
Power glitch reset
The internal reset block has two basic mode of operation: normal and sensitive reset. The default mode is sensitive, which can be
changed by the appropriate control command (see Related control commands at the end of this section). In normal mode the power
glitch detection circuit is disabled.
There can be spikes or glitches on the V
dd
line if the supply filtering is not satisfactory or the internal resistance of the power supply is
too high. In such cases if the sensitive reset is enabled an (unwanted) reset will be generated if the positive going edge of the V
dd
has
a rising rate greater than 100mV/ms and the voltage difference between the internal ramp signal and the V
dd
reaches the reset
threshold voltage (600 mV). Typical case when the battery is weak and due to its increased internal resistance a sudden decrease of
the current consumption (for example turning off the power amplifier) might lead to an increase in supply voltage. If for some reason
the sensitive reset cannot be disabled step-by-step decrease of the current consumption (by turning off the different stages one by
one) can help to avoid this problem.
Any negative change in the supply voltage will not cause reset event unless the Vdd level reaches the reset threshold voltage (250mV
in normal mode, 1.6V in sensitive reset mode).
If the sensitive mode is disabled and the power supply turned off the Vdd must drop below 250mV in order to trigger a power-on reset
event when the supply voltage is turned back on. If the decoupling capacitors keep their charges for a long time it could happen that
no reset will be generated upon power-up because the power glitch detector circuit is disabled.
Note that the reset event reinitializes the internal registers, so the sensitive mode will be enabled again.
相關PDF資料 |
PDF描述 |
|---|---|
| SI4021-A1-FT | IC TX FSK 915MHZ 5.4V 16-TSSOP |
| SI4022-A0-FT | IC TX FSK UNI 868/915MHZ 16TSSOP |
| SI4711-B30-GM | IC TX FM RADIO 76-108MHZ 20UQFN |
| SI4713-B30-GMR | IC TX FM RADIO RPS/RDS 20UQFN |
| SKY12146-321LF | IC VAR VOLT ATTEN 12QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SI4020-I1-FTR | 功能描述:射頻發射器 Transmitter EZRadio RoHS:否 制造商:Micrel 類型:ASK Transmitter 封裝 / 箱體:SOT-23-6 工作頻率:300 MHz to 450 MHz 封裝:Reel |
| SI-40219 | 制造商:BEL 制造商全稱:Bel Fuse Inc. 功能描述:SI-40219 |
| Si4021-A1-FT | 功能描述:射頻發射器 Transmitters IA4221 RoHS:否 制造商:Micrel 類型:ASK Transmitter 封裝 / 箱體:SOT-23-6 工作頻率:300 MHz to 450 MHz 封裝:Reel |
| SI4021-A1-FTR | 功能描述:射頻發射器 Transmitter EZRadio RoHS:否 制造商:Micrel 類型:ASK Transmitter 封裝 / 箱體:SOT-23-6 工作頻率:300 MHz to 450 MHz 封裝:Reel |
| SI-40222 | 制造商:BEL 制造商全稱:Bel Fuse Inc. 功能描述:SI-40222 |
發布緊急采購，3分鐘左右您將得到回復。