APPENDIX B—CISPR22 COMPLIANCE Various" />
參數資料
型號: SI3015-BS
廠商: Silicon Laboratories Inc
文件頁數: 50/64頁
文件大?。?/td> 0K
描述: IC ISOMODEM LINE-SIDE DAA 16SOIC
標準包裝: 48
系列: ISOmodem®
數據格式: V.90
波特率: 2.4k
電源電壓: 3.3V,5V
安裝類型: 表面貼裝
封裝/外殼: 16-SOIC(0.154",3.90mm 寬)
供應商設備封裝: 16-SOIC N
包裝: 管件
Si3038
54
Rev. 2.01
APPENDIX B—CISPR22 COMPLIANCE
Various countries are expected to adopt the IEC
CISPR22 standard over the next few years. For
example, the European Union (EU) has adopted a
standard entitled EN55022, which is based on the
CISPR22 standard. EN55022 is now part of the EU’s
EMC Directive and compliance is expected to be
required starting in 2003. Adherence to this standard
will be necessary to display the CE mark on designs
intended for sale in the EU. The typical schematic and
global bill of materials (BOM) (see Figure 19 and
Table 16) contained in this data sheet are designed to
be compliant to the CISPR22 standard.
If smaller inductors are desired, a notch filter may be
used and compliance to CISPR22 still achieved. As
shown in Figure 35, a series capacitor-resistor in
parallel with L1 and L2 forms the simple notch filter.
Table 27 shows corresponding values used for C24,
C25, C38, C39, L1, L2, R31, and R32.
Figure 35. Notch Filter for CISPR22 Compliance
The direct current resistance (DCR) of the listed
inductors is an important consideration. If the DCR of
the inductors used is less than 3
each, then country
PTT specifications which require 300
or less of dc
resistance at TIP and RING with 20 mA of loop current
can be satisfied with the Japan dc termination mode. If
the DCR of the inductors is at or slightly above 3
, the
low voltage termination mode may need to be used to
satisfy the 300
dc resistance requirement at 20 mA of
loop
current.
In
all
cases,
Considerations" on page 24 should be followed.
If compliance to the CISPR22 standard and certain
other country PTT requirements are not desired, then
L1 and L2 may be removed. If these inductors are
removed, C24 and C25 should be increased to 2200 pF,
and C9 should be changed to 22 nF, 250 V. With these
changes, PTT compliance in the following countries will
not be achieved: India (I/Fax-03/03 standard), Taiwan
(ID0001 standard), Chile (Decree No. 220 1981
standard), and Argentina (CNC-St2-44.01 standard).
For questions concerning compliance to CISPR22 or
other relevant standards, contact a Silicon Laboratories
technical representative.
Table 27. Notch Filter Component Values
C24/C25 C38/C39
L1/L2
R31/R32
1000 pF
33 pF,
50 V
150
H, DCR
<3
, I >120 mA
680
,
1/10 W
C38
C24
L1
R31
FB1
TIP
To
DAA
C39
C25
L2
R32
FB2
RING
相關PDF資料
PDF描述
PIC16C54T-XTE/SO IC MCU OTP 512X12 18SOIC
PIC16C54T-RC/SS IC MCU OTP 512X12 20SSOP
VE-262-IX-F2 CONVERTER MOD DC/DC 15V 75W
PIC16C54T-RC/SO IC MCU OTP 512X12 18SOIC
PIC16C54T-RCI/SS IC MCU OTP 512X12 20SSOP
相關代理商/技術參數
參數描述
SI3015-BSR 功能描述:電信線路管理 IC CONTACT SILICON LABS FOR AVAILABILITY RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
SI3015-E-FSR 制造商:Silicon Laboratories Inc 功能描述:
Si3015-F-FS 功能描述:電信線路管理 IC Si2400 ISOmodem Line-Side RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
SI3015-F-FSR 制造商:Silicon Laboratories Inc 功能描述:Modem Chip Chipset 2.4Kbps 16-Pin SOIC T/R 制造商:Silicon Laboratories Inc 功能描述:MODEM CHIP CHIPSET ISOMODEM 2.4KBPS 16SOIC - Tape and Reel 制造商:Silicon Laboratories 功能描述:Modem Chip Chipset 2.4Kbps 16-Pin SOIC T/R
SI3015-FS 功能描述:IC ISOMODEM LINE-SIDE DAA 16SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 調制解調器 - IC 和模塊 系列:ISOmodem® 標準包裝:25 系列:- 數據格式:V.21,V.22,V.23,V.29,V.32,V.34,V.90,V.92,Bell 103,Bell 212A 波特率:33.6k 電源電壓:3.3V 安裝類型:- 封裝/外殼:- 供應商設備封裝:- 包裝:托盤 配用:591-1013-ND - KIT DEV SOCKETMODEM PARALLEL591-1009-ND - KIT DEV SRL SOCKETMODEM UNIVERSL 其它名稱:MT5656SMI-P-V-34.R2-SPMT5656SMI-P-V-34.R2-SP-NDQ4711574