- 您現在的位置：買賣IC網 > PDF目錄379352 > SC16IS762IPW (NXP Semiconductors N.V.) Dual UART with I2C-bus-SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support PDF資料下載
參數資料
| 型號： | SC16IS762IPW |
| 廠商： | NXP Semiconductors N.V. |
| 元件分類： | 連接器件 |
| 英文描述： | Dual UART with I2C-bus-SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support |
| 封裝： | SC16IS752IBS<SOT617-1 (HVQFN32)|<<http://www.nxp.com/packages/SOT617-1.html<1<Always Pb-free,;SC16IS752IBS<SOT617-1 (HVQFN32)|<<http://www.nxp.com/packages/SOT617-1.html& |
| 文件頁數： | 29/60頁 |
| 文件大?。?/td> | 356K |
| 代理商： | SC16IS762IPW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
SC16IS752_SC16IS762
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 8 — 1 September 2011
29 of 60
NXP Semiconductors
SC16IS752; SC16IS762
Dual UART with I
2
C-bus/SPI interface, 64-byte FIFOs, IrDA SIR
8.11 Transmission Control Register (TCR)
This 8-bit register is used to store the RX FIFO threshold levels to stop/start transmission
during hardware/software flow control.
Table 22
shows Transmission Control Register bit
settings. If TCR bits are cleared, then selectable trigger levels in FCR are used in place of
TCR.
Table 22.
Bit
7:4
3:0
TCR trigger levels are available from 0 bytes to 60 characters with a granularity of four.
Remark:
TCR can only be written to when EFR[4] = logic 1 and MCR[2] = logic 1. The
programmer must program the TCR such that TCR[3:0] > TCR[7:4]. There is no built-in
hardware check to make sure this condition is met. Also, the TCR must be programmed
with this condition before Auto-RTS or software flow control is enabled to avoid spurious
operation of the device.
8.12 Trigger Level Register (TLR)
This 8-bit register is used to store the transmit and received FIFO trigger levels used for
interrupt generation. Trigger levels from 4 to 60 can be programmed with a granularity
of four.
Table 23
shows Trigger Level Register bit settings.
Table 23.
Bit
7:4
3:0
Remark:
TLR can only be written to when EFR[4] = logic 1 and MCR[2] = logic 1. If
TLR[3:0] or TLR[7:4] are logical 0, the selectable trigger levels via the FIFO Control
Register (FCR) are used for the transmit and receive FIFO trigger levels. Trigger levels
from 4 characters to 60 characters are available with a granularity of four. The TLR should
be programmed for
N
4
, where N is the desired trigger level.
When the trigger level setting in TLR is zero, the SC16IS752/SC16IS762 uses the trigger
level setting defined in FCR. If TLR has non-zero trigger level value, the trigger level
defined in FCR is discarded. This applies to both transmit FIFO and receive FIFO trigger
level setting.
When TLR is used for RX trigger level control, FCR[7:6] should be left at the default state
‘00’.
Transmission Control Register bits description
Symbol
Description
TCR[7:4]
RX FIFO trigger level to
resume
TCR[3:0]
RX FIFO trigger level to
halt
Trigger Level Register bits description
Symbol
Description
TLR[7:4]
RX FIFO trigger levels (4 to 60), number of characters available
TLR[3:0]
TX FIFO trigger levels (4 to 60), number of spaces available
相關PDF資料 |
PDF描述 |
|---|---|
| SC5R5153Z | 2.7V/2.0F Primary or back-up power supply for video, audio |
| SC5R5222Z | SWITCH DIP,SPST,10-POS,20-PIN STANDARD,SLIDE RAISED,50VDC |
| SC5R5332Z | High capacitance and low resistance for long cycle life applications |
| SC5R5303Z | High capacitance and low resistance for long cycle life applications |
| SC5R5403Z | CABLE ASSEMBLY,RG58/U,50', BNC TO BNC,50 OHM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SC16IS762IPW,112 | 功能描述:UART 接口集成電路 DUAL UART 64BYTE RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16IS762IPW,128 | 功能描述:UART 接口集成電路 I2C/SPI-UARTBRIDGE RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16IS762IPW112 | 制造商:NXP Semiconductors 功能描述:IC DUAL UART FIFO 5MBPS 3.6V TSSOP28 |
| SC16IS762IPW-F | 功能描述:UART 接口集成電路 I2C/SPI-UARTBRIDGE W/IRDA AND GPIO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16IS762IPW-S | 功能描述:IC UART DUAL I2C/SPI 28-TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - UART（通用異步接收器/發送器） 系列:- 標準包裝:250 系列:- 特點:* 通道數:2，DUART FIFO's:16 字節 規程:RS232，RS485 電源電壓:2.25 V ~ 5.5 V 帶并行端口:- 帶自動流量控制功能:是 帶IrDA 編碼器/解碼器:是 帶故障啟動位檢測功能:是 帶調制解調器控制功能:是 帶CMOS:是 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:托盤 其它名稱:XR16L2551IM-F-ND |
發布緊急采購，3分鐘左右您將得到回復。