![](http://datasheet.mmic.net.cn/Infineon-Technologies/SAB-C165-LM-3V-HA_datasheet_99637/SAB-C165-LM-3V-HA_41.png)
C165
Data Sheet
37
V2.0, 2000-12
PORT0 configuration current8)
IP0H
–- 5
A
VIN = VIHmin
IP0L
- 100
–
A
VIN = VILmax
XTAL1 input current
IIL
CC –
± 20
A0 V < V
IN < VDD
Pin capacitance9)
(digital inputs/outputs)
CIO CC –
10
pF
f = 1 MHz
TA = 25 °C
1) Keeping signal levels within the levels specified in this table, ensures operation without overload conditions.
For signal levels outside these specifications also refer to the specification of the overload current
IOV.
2) Valid in bidirectional reset mode only.
3) This specification is not valid for outputs which are switched to open drain mode. In this case the respective
output will float and the voltage results from the external circuitry.
4) These parameters describe the RSTIN pullup, which equals a resistance of ca. 50 to 250 k
.
5) The maximum current may be drawn while the respective signal line remains inactive.
6) The minimum current must be drawn in order to drive the respective signal line active.
7) This specification is valid during Reset and during Hold-mode or Adapt-mode. During Hold-mode Port 6 pins
are only affected, if they are used (configured) for CS output and the open drain function is not enabled. The
READY-pullup is always active, except for Powerdown mode.
8) This specification is valid during Reset and during Adapt-mode.
9) Not 100% tested, guaranteed by design and characterization.
DC Characteristics (Reduced Supply Voltage Range) (cont’d)
(Operating Conditions apply)1)
Parameter
Symbol
Limit Values
Unit Test Condition
min.
max.