參數資料
型號： SAB-C163-LF
廠商： SIEMENS AG
英文描述： 16-bit CMOS Single-Chip Microcontroller
中文描述： 16位CMOS單片機
文件頁數： 12/68頁
文件大?。?/td> 625K
代理商： SAB-C163-LF
11Aug98@14:48h Intermediate Version
Semiconductor Group
10
1998-08
C163-L
External Bus Controller
All of the external memory accesses are performed by a particular on-chip External Bus Controller
(EBC). It can be programmed either to Single Chip Mode when no external memory is required, or
to one of four different external memory access modes, which are as follows:
– 16-/18-/20-/24-bit Addresses, 16-bit Data, Demultiplexed
– 16-/18-/20-/24-bit Addresses, 16-bit Data, Multiplexed
– 16-/18-/20-/24-bit Addresses, 8-bit Data, Multiplexed
– 16-/18-/20-/24-bit Addresses, 8-bit Data, Demultiplexed
In the demultiplexed bus modes, addresses are output on PORT1 and data is input/output on
PORT0 or P0L, respectively. In the multiplexed bus modes both addresses and data use PORT0 for
input/output.
Important timing characteristics of the external bus interface (Memory Cycle Time, Memory Tri-
State Time, Length of ALE and Read Write Delay) have been made programmable to allow the user
the adaption of a wide range of different types of memories and external peripherals.
In addition, up to 4 independent address windows may be defined (via register pairs ADDRSELx /
BUSCONx) which allow to access different resources with different bus characteristics. These
address windows are arranged hierarchically where BUSCON4 overrides BUSCON3 and
BUSCON2 overrides BUSCON1. All accesses to locations not covered by these 4 address windows
are controlled by BUSCON0.
Up to 5 external CS signals (4 windows plus default) can be generated in order to save external glue
logic. Access to very slow memories is supported via a particular ‘Ready’ function.
A HOLD/HLDA protocol is available for bus arbitration and allows to share external resources with
other bus masters. The bus arbitration is enabled by setting bit HLDEN in register SYSCON. After
setting HLDEN once, pins P6.7...P6.5 (BREQ, HLDA, HOLD) are automatically controlled by the
EBC. In Master Mode (default after reset) the HLDA pin is an output. By setting bit DP6.7 to ’1’ the
Slave Mode is selected where pin HLDA is switched to input. This allows to directly connect the
slave controller to another master controller without glue logic.
For applications which require less than 16 MBytes of external memory space, this address space
can be restricted to 1 MByte, 256 KByte or to 64 KByte. In this case Port 4 outputs four, two or no
address lines at all. It outputs all 8 address lines, if an address space of 16 MBytes is used.
Note:
When the on-chip SSP Module is to be used the segment address output on Port 4 must be
limited to 4 bits (ie. A19...A16) in order to enable the alternate function of the SSP interface
pins.
相關PDF資料
PDF描述
SAFC164SM 16-Bit Single-Chip Microcontrol ler
SAFC165H EMBEDDED C166 WITH USART IOM-2 AND HDLC SUPPORT
SAFC165UTAH EMBEDDED C166 WITH USART IOM-2 AND HDLC SUPPORT
SAFC503 8-Bit CMOS Microcontroller
SAK-C164CI-8EM 16-Bit Single-Chip Microcontroller
相關代理商/技術參數
參數描述
SAB-C163-LF-CU 制造商:Siemens 功能描述:IC,MICROCONTROLLER,16-BIT,80166 CPU,CMOS,QFP,100PIN,PLASTIC
SABC163LFLU 制造商:INFINEON 功能描述:Step AC
SABC163LFTR 制造商:Infineon Technologies AG 功能描述:MCU 16-bit C166 CISC/RISC ROMLess 5V 100-Pin TQFP T/R
SAB-C163T-16FF 制造商:Rochester Electronics LLC 功能描述:- Bulk
SAB-C164CI-LM 3V CA 功能描述:16位微控制器 - MCU 16BIT ROM/ROMLESS RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*