- 您現在的位置：買賣IC網 > PDF目錄365431 > S70WS512N00BAWAB3 (Spansion Inc.) Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory PDF資料下載
參數資料
| 型號： | S70WS512N00BAWAB3 |
| 廠商： | Spansion Inc. |
| 英文描述： | Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory |
| 中文描述： | 同硅晶片堆疊多芯片產品（MCP）的512兆位（32兆× 16位）的CMOS 1.8伏，只有同時讀/寫，突發模式閃存 |
| 文件頁數： | 54/93頁 |
| 文件大?。?/td> | 846K |
| 代理商： | S70WS512N00BAWAB3 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁當前第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁
March 14, 2005 S70WS512N00_00_A0
S70WS512N00 Based MCPs
55
A d v a n c e I n f o r m a t i o n
Notes
1.
When the parts are first shipped, the PPBs are cleared (erased to
1
) and upon power up or reset,
the DYBs can be set or cleared depending upon the ordering option chosen.
The DYBs can be set (programmed to
0
) or cleared (erased to
1
) as often as needed.
2.
If the option to clear the DYBs after power up is chosen, (erased to
1
), then the sectorsmay
be modified depending upon the PPB state of that sector (see
Table 9.2
).
The sectors would be in the protected state If the option to set the DYBs after power up is
chosen (programmed to
0
).
It is possible to have sectors that are persistently locked with sectors that are left in the
dynamic state.
The DYB Set or Clear commands for the dynamic sectors signify protected or unprotected
state of the sectors respectively. However, if there is a need to change the status of the per-
sistently locked sectors, a few more steps are required. First, the PPB Lock Bit must be
cleared by either putting the device through a power-cycle, or hardware reset. The PPBs can
then be changed to reflect the desired settings. Setting the PPB Lock Bit once again locks
the PPBs, and the device operates normally again.
To achieve the best protection, it is recommended to execute the PPB Lock Bit Set command
early in the boot code and protect the boot code by holding WP# = V
IL
. Note that the PPB
and DYB bits have the same function when ACC = V
HH
as they do when ACC = V
IH
.
3.
4.
5.
6.
9.4
Persistent Protection Bit Lock Bit
The Persistent Protection Bit Lock Bit is a global volatile bit for all sectors. When set (programmed
to
0
), it locks all PPBs and when cleared (programmed to
1
), allows the PPBs to be changed. There
is only one PPB Lock Bit per device.
Notes
1.
No software command sequence unlocks this bit unless the device is in the password pro-
tection mode; only a hardware reset or a power-up clears this bit.
The PPB Lock Bit must be set (programmed to
0
) only after all PPBs are configured to the
desired settings.
2.
9.5
Password Protection Method
The Password Protection Method allows an even higher level of security than the Persistent Sector
Protection Mode by requiring a 64 bit password for unlocking the device PPB Lock Bit. In addition
to this password requirement, after power up and reset, the PPB Lock Bit is set
0
to maintain the
password mode of operation. Successful execution of the Password Unlock command by entering
the entire password clears the PPB Lock Bit, allowing for sector PPBs modifications.
相關PDF資料 |
PDF描述 |
|---|---|
| S70WS512N00BFWA20 | Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory |
| S70WS512N00BFWA22 | Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory |
| S70WS512N00BFWA23 | Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory |
| S70WS512N00BFWA30 | Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory |
| S70WS512N00BFWA32 | Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S70WS512N00BFWA20 | 制造商:SPANSION 制造商全稱:SPANSION 功能描述:Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory |
| S70WS512N00BFWA22 | 制造商:SPANSION 制造商全稱:SPANSION 功能描述:Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory |
| S70WS512N00BFWA23 | 制造商:SPANSION 制造商全稱:SPANSION 功能描述:Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory |
| S70WS512N00BFWA30 | 制造商:SPANSION 制造商全稱:SPANSION 功能描述:Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory |
| S70WS512N00BFWA32 | 制造商:SPANSION 制造商全稱:SPANSION 功能描述:Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory |
發布緊急采購，3分鐘左右您將得到回復。