- 您現在的位置：買賣IC網 > PDF目錄299876 > S-8328J25MC-F2F-T2 0.3 A SWITCHING CONTROLLER, 287.5 kHz SWITCHING FREQ-MAX, PDSO5 PDF資料下載
參數資料
| 型號： | S-8328J25MC-F2F-T2 |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.3 A SWITCHING CONTROLLER, 287.5 kHz SWITCHING FREQ-MAX, PDSO5 |
| 封裝： | PLASTIC, SOT-23, 5 PIN |
| 文件頁數： | 11/65頁 |
| 文件大小： | 759K |
| 代理商： | S-8328J25MC-F2F-T2 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁
SMALL PACKAGE PWM/PFM CONTROL STEP-UP SWITCHING REGULATOR
Rev. 7.2-10
S-8324/8328 Series
Seiko Instruments Inc.
19
1. Inductor
An inductance has strong influence on max. output current IOUT and efficiency
η.
Figure 7 shows IOUT
η characteristics for inductance of S-8324 and S-8328.
Figure 7
The peak current IPK increases by decreasing L and IOUT is at max. value at L value.
Further decreasing L decreases IOUT due to the lack of the current driving capacity of the switching transistor.
The loss of IPK by the switching transistor decreases by increasing L and the efficiency becomes max. at L value.
Further increasing L decreases efficiency due to the loss of the DC resistance of the coil.
47 to 220
H inductor for S-8324 A/B/C/D/E and 22 to 100 H inductor for S-8328 A/B/C/D/E, 10 to 22H inductor for S-8324 H/J, and 4.7
to 10
H inductor for S-8328 H/J are recommended.
Choose a value for L by refering to the reference data because the maximum output current is due to the input voltage in an actual case.
Choose an inductor so that the peak current IPK does not exceed the allowable current.
Exceeding the allowable current of the inductor causes magnetic saturation, remarkable low efficiency and destruction of the IC chip due
to a large current.
The peak current IPK in uncontinuous mode is caluculated from the following formula:
IPK =
fosc: oscillation frequency
VD
0.4V
For instance, when you choose 100
H at fosc=50 kHz for L using the S-8324A 50MC at the following conditions, IPK is caluculated to 170
mA from the (17) formula.
Input voltage VIN=3 V
Output voltage VOUT=5 V
Load current IOUT=30 mA
The switching current limit circuit is not built into this IC chip.
IPK current must be 500 mA or less.
2 IOUT (VOUT+VD-VIN)
fOSC
L
(A)
(17)
S-8324 A/B/C/D/E
IOUT
D75C
η
IOUT
47
220
recommended range
L (
H)
VOUT=5.0V, VIN=3.0V
S-8328 A/B/C/D/E
IOUT
CD105
η
IOUT
22
100
L (
H)
VOUT=5.0V, VIN=3.0V
DISCONTINUED
PRODUCT
相關PDF資料 |
PDF描述 |
|---|---|
| S-8331B20FS-T2G | SWITCHING CONTROLLER, PDSO8 |
| S-8340A25AFT-T2 | 0.1 A SWITCHING CONTROLLER, 690 kHz SWITCHING FREQ-MAX, PDSO8 |
| S-8351A28MC-J2NT2G | SWITCHING REGULATOR, 110 kHz SWITCHING FREQ-MAX, PDSO5 |
| S-93C56ADFJ | 128 X 16 MICROWIRE BUS SERIAL EEPROM, PDSO8 |
| S-93C56BD0I-I8T1G | 128 X 16 MICROWIRE BUS SERIAL EEPROM, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S832D | 功能描述:SW TOGGLE 3PDT 30A LEVER SCREW RoHS:是 類別:開關 >> 撥動開關 系列:S 標準包裝:1 系列:A 電路:雙刀雙擲 開關功能:開-開-開 觸點額定電壓:6A @ 125VAC 觸動器類型:扁平型 觸動器長度:11.38mm 發光:不發光 安裝類型:面板安裝 端接類型:焊片 軸襯螺紋:1/4-40 包裝:散裝 |
| S-832D | 制造商:Nihon Kaiheiki Ind Co Ltd 功能描述:250V 50000 Silver 70 -10 42mm 24mm 73mm |
| S832D-RO | 功能描述:撥動開關 3PST ON-NONE-ON RoHS:否 制造商:C&K Components 觸點形式:DPDT 開關功能:ON - ON - ON 電流額定值: 電壓額定值 AC:20 V 電壓額定值 DC:20 V 功率額定值:0.4 VA 端接類型:V-Bracket 安裝風格: 端子密封:Epoxy 觸點電鍍:Gold 照明:Not Illuminated |
| S832-RO | 功能描述:撥動開關 3PDT ON-ON HIGH CAP RoHS:否 制造商:C&K Components 觸點形式:DPDT 開關功能:ON - ON - ON 電流額定值: 電壓額定值 AC:20 V 電壓額定值 DC:20 V 功率額定值:0.4 VA 端接類型:V-Bracket 安裝風格: 端子密封:Epoxy 觸點電鍍:Gold 照明:Not Illuminated |
| S8-32X1 | 制造商:MISCELLANEOUS 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。