- 您現在的位置：買賣IC網 > PDF目錄385768 > RF2480 (RF MICRO DEVICES INC) DIRECT QUADRATURE MODULATOR PDF資料下載
參數資料
| 型號： | RF2480 |
| 廠商： | RF MICRO DEVICES INC |
| 元件分類： | 無繩電話/電話 |
| 英文描述： | DIRECT QUADRATURE MODULATOR |
| 中文描述： | TELECOM, CELLULAR, RF AND BASEBAND CIRCUIT, PDSO16 |
| 封裝： | ROHS COMPLIANT, SOIC-16 |
| 文件頁數： | 4/8頁 |
| 文件大?。?/td> | 82K |
| 代理商： | RF2480 |
5-32
RF2480
Rev A3 011019
5
M
U
Pin
1
Function
I REF
Description
Reference voltage for the I mixer. This voltage should be the same as
the DC voltage supplied to the I SIG pin. A voltage of 3.0V is recom-
mended. The SIG and REF inputs are inputs of a differential amplifier.
Therefore the REF and SIG inputs are interchangeable. If swapping the
I SIG and I REF pins, the Q SIG and Q REF also need to be swapped
to maintain the correct phase. It is also possible to drive the SIG and
REF inputs in a balanced mode. This will increase the gain.
Interface Schematic
For optimum carrier suppression, the DC voltages on I REF, Q REF, I
SIG and Q SIG should be adjusted slightly to compensate for inherent
undesired internal DC offsets; for optimum sideband suppression,
phase and signal amplitude on IREF, Q REF, I SIG and Q SIG should
be adjusted slightly to compensate for inherent undesired internal off-
sets. See RFMD AN0001 for more detail.
Reference voltage for the Q mixer. This voltage should be the same as
the DC voltage supplied to the Q SIG pin. A voltage of 3.0V is recom-
mended. See pin 1 for more details.
2
Q REF
3
GND2
Ground connection of the LO phase shift network. This pin should be
connected directly to the ground plane.
Same as pin 3.
4
5
6
GND2
GND2
LO
Same as pin 3.
The input of the phase shifting network. This pin has an internal DC
blocking capacitor. This port is voltage driven so matching at different
frequencies is not required.
Power supply for all circuits except the RF output stage. An external
capacitor is needed if no other low frequency bypass capacitor is
nearby.
Power Down control. When this pin is "low", all circuits are shut off. A
"low" is typically 1.2V or less at room temperature.When this pin is
"high" (V
CC
), all circuits are operating normally. If PD is below V
CC
, out-
put power and performance will be degraded. Operating in this region
is not recommended, although it might be useful in some applications
where power control is required.
RF Output. This pin has an internal DC blocking capacitor. At some fre-
quencies, external matching may be needed to optimize output power.
7
VCC1
8
PD
9
RF OUT
10
GND3
Ground connection for the RF output stage. This pin should be con-
nected directly to the ground plane.
Power supply for the RF output amplifier. An external capacitor is
needed if no other low frequency bypass capacitor is near by.
Ground connection for the LO and baseband amplifiers, and for the
mixers. This pin should be connected directly to the ground plane.
Same as pin 12.
11
VCC2
12
GND1
13
14
GND1
GND1
Same as pin 12.
425
425
100
100
I REF
I SIG
425
425
100
100
Q REF
Q SIG
LO
200
PD
V
CC
RF OUT
相關PDF資料 |
PDF描述 |
|---|---|
| RF2483 | LOW NOISE DUAL-BAND QUADRATURE MODULATOR WITH AGC |
| RF2484 | DIRECT QUADRATURE MODULATOR |
| RF2485 | VHF QUADRATURE MODULATOR |
| RF2486 | PCS LOW NOISE AMPLIFIER/MIXER |
| RF2488 | MULTI-MODE DUAL-BAND LNA MIXER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RF2480_06 | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:DIRECT QUADRATURE MODULATOR |
| RF2480_1 | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:DIRECT QUADRATURE MODULATOR |
| RF2480-000 | 功能描述:可復位保險絲 RoHS:否 制造商:Bourns 電流額定值: 電阻:7.5 Ohms 最大直流電壓: 保持電流:0.1 A 安裝風格:SMD/SMT 端接類型:SMD/SMT 跳閘電流:0.6 A 引線間隔: 系列:MF-PSHT 工作溫度范圍:- 40 C to + 125 C |
| RF2480PCBA | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:DIRECT QUADRATURE MODULATOR |
| RF2480SR | 制造商:RF Micro Devices Inc 功能描述:IC QUADRATURE MODULATOR 16-SOIC |
發布緊急采購，3分鐘左右您將得到回復。