參數資料
型號: R5F2L36ACDFP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP64
封裝: 10 X 10 MM, 0.50 MM PITCH, PLASTIC, LQFP-64
文件頁數: 20/74頁
文件大?。?/td> 959K
代理商: R5F2L36ACDFP
28
2588F–AVR–06/2013
ATtiny261/461/861
When the PLL output is selected as clock source, the start-up times are determined by SUT fuse
bits as shown in Table 6-5.
6.2.3
Calibrated Internal 8 MHz Oscillator
By default, the Internal Oscillator provides an approximately 8 MHz clock signal. Though voltage
and temperature dependent, this clock can be very accurately calibrated by the user. See Table
shipped with the CKDIV8 Fuse programmed. See “System Clock Prescaler” on page 31 for
more details.
This clock may be selected as the system clock by programming the CKSEL Fuses as shown in
Table 6-6. If selected, it will operate with no external components. During reset, hardware loads
the pre-programmed calibration value into the OSCCAL Register and thereby automatically cal-
ibrates the RC Oscillator. The accuracy of this calibration is shown as Factory calibration in
Notes:
1. The device is shipped with this option selected.
2. If the oscillator frequency exceeds the specification of the device (depends on VCC), the
CKDIV8 Fuse can be programmed to divide the internal frequency by 8.
When this oscillator is selected, start-up times are determined by SUT fuses as shown in Table
Note:
1. If the RSTDISBL fuse is programmed, this start-up time will be increased to 14CK + 4 ms to
ensure programming mode can be entered.
2. The device is shipped with this option selected.
Table 6-5.
Start-up Times for the PLLCK
SUT1:0
Start-up Time from
Power Down
Additional Delay from
Power-On-Reset (V
CC = 5.0V)
Recommended
usage
00
14CK + 1K (1024) + 4 ms
4 ms
BOD enabled
01
14CK + 16K (16384) + 4 ms
4 ms
Fast rising power
10
14CK + 1K (1024) + 64 ms
4 ms
Slowly rising power
11
14CK + 16K (16384) + 64 ms
4 ms
Slowly rising power
Table 6-6.
Internal Calibrated RC Oscillator Operating Modes
CKSEL3:0
Nominal Frequency
0010
8.0 MHz
Table 6-7.
Start-up Times for the Internal Calibrated RC Oscillator Clock Selection
SUT1:0
Start-up Time
from Power-down
Additional Delay from
Reset (VCC = 5.0V)
Recommended
Usage
00
6 CK
14CK(1)
BOD enabled
01
6 CK
14CK + 4 ms
Fast rising power
6 CK
14CK + 64 ms
Slowly rising power
11
Reserved
相關PDF資料
PDF描述
R5F2L3A7CNFA 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100
R5F2L3AACDFP 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100
R5F2L3ACCNFP 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100
R5F2L38ACNFA 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP80
R5F2L38CCNFP 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP80
相關代理商/技術參數
參數描述
R5F2L36ACDFP#30 制造商:Renesas Electronics Corporation 功能描述:IC MCU 16BIT 96KB FLASH 64LQFP
R5F2L36ACDFP#U1 制造商:Renesas Electronics Corporation 功能描述:
R5F2L36ACDFP#V2 制造商:Renesas Electronics Corporation 功能描述:R8C/L36C 96+4/10 64LQFP 10X10 制造商:Renesas Electronics Corporation 功能描述:R8C/L36C 96+4/10 64LQFP 10X10 -40 TO +85 - Trays 制造商:Renesas Electronics Corporation 功能描述:MCU 16BIT 96KB FLASH 64LQFP
R5F2L36ACNFP#30 制造商:Renesas Electronics Corporation 功能描述:IC MCU 16BIT 96KB FLASH 64LQFP
R5F2L36ACNFP#V2 制造商:Renesas Electronics Corporation 功能描述:IC MCU 16BIT 96KB FLASH 64LQFP