- 您現在的位置：買賣IC網 > PDF目錄370003 > PIIPM50P12B004 Programmable solated intelligent power module. a 50A. 1200V. three-phase inverter for 15kW industrial and servo motors with on-board programmable DSP. current sensing. isolation. gate drivers and power stage. PDF資料下載
參數資料
| 型號： | PIIPM50P12B004 |
| 英文描述： | Programmable solated intelligent power module. a 50A. 1200V. three-phase inverter for 15kW industrial and servo motors with on-board programmable DSP. current sensing. isolation. gate drivers and power stage. |
| 中文描述： | 可編程solated智能功率模塊。 1 50A條。 1200伏。三相逆變器為15Kw的工業和伺服電機與板上可編程DSP。電流感應。隔離。柵極驅動器和功率級。 |
| 文件頁數： | 3/29頁 |
| 文件大小： | 1151K |
| 代理商： | PIIPM50P12B004 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
www.irf.com
3
PIIPM25P12B008
I27147 01/03
Signal pins on RS422 serial port
Symbol
Lead Description
Pin number
Vin iso
GND iso
Tx+
Tx-
Rx+
Rx-
Enc1 – Hall1 / SpiCK
Enc2 – Hall2 / SpiSTE Incremental Encoder 2 / Hall effect sensor input 2 / SpiSTE input (GND iso referenced)
Strb – Hall3 / SpiRx
Incremental Encoder Strobe / Hall effect sensor input 3 / SpiRx input (GND iso ref.)
SpiTx
SpiTx output (GND iso referenced)
Vin
External 15V supply voltage. Internally referred to DC bus minus pin (DC -)
COM
External 15V supply ground reference. This pin is directly connected to DC -
Signal pins on IEEE1149.1 JTAG connector
External 5V supply voltage for opto-couplers and line driver supply
Extenal 5V supply ground reference for opto-couplers and line driver supply
RS422 Trasmitter Non inverting Driver Output
RS422 Trasmitter Inverting Driver Output
RS422 Receiver Non inverting Driver Input,
RS422 Receiver Inverting Driver Input
Incremental Encoder 1 / Hall effect sensor input 1/ SpiCK input (GND iso referenced)
6
7
1
2
4
3
5
9
10
8
17-18
19-20
RS422
serial
port
Symbol
Lead Description
State
Pin number
TMS
TMS2
TDI
TDO
JTAG test mode select
JTAG test mode select 2
JTAG test data input
JTAG test data output
JTAG test clock. TCK is a 10MHz clock source from the emulation pod. This
signal can be used to drive the system test clock.
JTAG test reset
Emulation pin 0
Emulation pin 1
Presence detect.
Indicates that the emulation cable is connected and that the PI-IPM logic is
powered up. PD is tied to the DSP 3.3V supply through a 1k resistor.
JTAG test clock return. Test clock input to the emulator.
Internally short circuited to TCK.
Boot ROM enable. This pin is sampled during DSP reset, pulling it low
enables DSP boot ROM (Flash versions only). 47k internal pull up.
External 15V supply ground reference. This pin is directly connected to DC -
Input
Input
Input
Output
12
5-6
14
13
15
TCK
TRST~
EMU0
EMU1/OFF~
Input
Input
I/O
I/O
11
9-10
7-8
1
PD
Output
TCK_RET
Output
16
Boot-En
COM
Input
N/A
17
20
IEEE1149.1
JTAG
相關PDF資料 |
PDF描述 |
|---|---|
| PIMM25SG144B | 500kHz and 1MHz High Efficiency 1.5A Switching Regulators; Package: SO; No of Pins: 8; Temperature Range: -40?°C to 85?°C |
| PIMM25SG144M | Microprocessor |
| PIMM33SG144B | Microprocessor |
| PIMM33SG144C | Microprocessor |
| PIMM33SG144M | Microprocessor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PIIPM50P12B004X | 制造商:International Rectifier 功能描述: |
| PIIPM50P12C004 | 制造商:IRF 制造商全稱:International Rectifier 功能描述:Programmable Isolated IPM |
| PIIPM50P12C004X | 制造商:IRF 制造商全稱:International Rectifier 功能描述:Programmable Isolated IPM |
| PIIPM50P12D004 | 制造商:IRF 制造商全稱:International Rectifier 功能描述:Programmable Isolated IPM |
| PIIPM50P12D004X | 制造商:IRF 制造商全稱:International Rectifier 功能描述:Programmable Isolated IPM |
發布緊急采購，3分鐘左右您將得到回復。