參數資料
型號： P89LPC932BDH
廠商： NXP SEMICONDUCTORS
元件分類： 微控制器/微處理器
英文描述： 80C51 8-bit microcontroller with two-clock core 8 KB 3 V low-power Flash with 512-byte data EEPROM
中文描述： 8-BIT, FLASH, 12 MHz, MICROCONTROLLER, PDSO28
封裝： 4.40 MM, PLASTIC, MO-153, SOT-361-1, TSSOP-28
文件頁數： 19/64頁
文件大?。?/td> 316K
代理商： P89LPC932BDH
9397 750 14871
Koninklijke Philips Electronics N.V. 2005. All rights reserved.
Product data sheet
Rev. 02 — 10 May 2005
19 of 64
Philips Semiconductors
P89LPC932A1
8-bit microcontroller with accelerated two-clock 80C51 core
The frequency of this clock output is
1
2
that of the CCLK. If the clock output is not needed
in Idle mode, it may be turned off prior to entering Idle, saving additional power.
7.4 On-chip RC oscillator option
The P89LPC932A1 has a 6-bit TRIM register that can be used to tune the frequency of
the RC oscillator. During reset, the TRIM value is initialized to a factory preprogrammed
value to adjust the oscillator frequency to 7.373 MHz
±
1 % at room temperature.
End-user applications can write to the TRIM register to adjust the on-chip RC oscillator to
other frequencies.
7.5 Watchdog oscillator option
The watchdog has a separate oscillator which has a frequency of 400 kHz. This oscillator
can be used to save power when a high clock frequency is not needed.
7.6 External clock input option
In this configuration, the processor clock is derived from an external source driving the
XTAL1/P3.1 pin. The rate may be from 0 Hz up to 18 MHz. The XTAL2/P3.0 pin may be
used as a standard port pin or a clock output.
When using an oscillator frequency
above 12 MHz, the reset input function of P1.5 must be enabled. An external circuit
is required to hold the device in reset at power-up until V
DD
has reached its
specified level. When system power is removed V
DD
will fall below the minimum
specified operating voltage. When using an oscillator frequency above 12 MHz, in
some applications, an external brownout detect circuit may be required to hold the
device in reset when V
DD
falls below the minimum specified operating voltage.
Fig 6.
Block diagram of oscillator control.
÷
2
002aaa891
RTC
CPU
WDT
DIVM
CCLK
UART
OSCCLK
I
2
C-BUS
PCLK
TIMER 0 AND
TIMER 1
HIGH FREQUENCY
MEDIUM FREQUENCY
LOW FREQUENCY
XTAL1
XTAL2
RC
OSCILLATOR
WATCHDOG
OSCILLATOR
(7.3728 MHz
±
1 %)
PCLK
RCCLK
SPI
CCU
(P89LPC932A1)
32
×
PLL
(400 kHz 30 %
相關PDF資料
PDF描述
P89LPC932FDH 8-bit microcontroller with accelerated two-clock 80C51 core 8 kB Flash with 512-byte data EEPROM and 768-byte RAM
P89LPC932FHN 8-bit microcontroller with accelerated two-clock 80C51 core 8 kB Flash with 512-byte data EEPROM and 768-byte RAM
P89LPC932A1FA 8-Bit Microcontroller with accelerated two-clock 80C51 core 8kB 3V byte-erasable flash with 512-byte data EEPROM
P8N18 N-CHANNEL LOGIC LEVEL POWER FIELD EFFECT TRANSISTORS
P8XC557E8 8 BIT MICROCONTROLLER
相關代理商/技術參數
參數描述
P89LPC932FDH 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with accelerated two-clock 80C51 core 8 kB Flash with 512-byte data EEPROM and 768-byte RAM
P89LPC932FDH.529 制造商:NXP Semiconductors 功能描述:IC 8BIT MCU 8K FLASH SMD 89LC932
P89LPC932FDH/CP3235, 制造商:NXP Semiconductors 功能描述:MICRO CONTROLLER(MCU
P89LPC932FHN 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with accelerated two-clock 80C51 core 8 kB Flash with 512-byte data EEPROM and 768-byte RAM
P89LPC933 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with accelerated two-clock 80C51 core 4 kB/8 kB/16 kB 3 V byte-erasable flash with 8-bit ADCs
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*