參數資料
型號: P89LPC915
廠商: NXP Semiconductors N.V.
英文描述: 8-bit microcontrollers with accelerated two-clock 80C51 core 2 kB 3 V Flash with 8-bit A/D converter
中文描述: 8 - 8加速雙位單片機80C51的時鐘核心2 Kb的3伏閃存位A / D轉換器
文件頁數: 42/72頁
文件大小: 344K
代理商: P89LPC915
Philips Semiconductors
P89LPC915/916/917
8-bit microcontrollers with accelerated two-clock 80C51 core
Product data
Rev. 04 — 17 December 2004
42 of 72
9397 750 14397
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
Reset can be triggered from the following sources:
External reset pin (during power-up or if user configured via UCFG1. This option
must be used for an oscillator frequency above 12 MHz.)
Power-on detect
Brownout detect
Watchdog Timer
Software reset
UART break character detect reset.
For every reset source, there is a flag in the Reset Register, RSTSRC. The user can
read this register to determine the most recent reset source. These flag bits can be
cleared in software by writing a logic 0 to the corresponding bit. More than one flag bit
may be set:
During a power-on reset, both POF and BOF are set but the other flag bits are
cleared.
For any other reset, previously set flag bits that have not been cleared will remain
set.
9.16 Timers/counters 0 and 1
The P89LPC915/916/917 devices have two general purpose counter/timers which
are upward compatible with the standard 80C51 Timer 0 and Timer 1. An option to
automatically toggle the T0 pin upon timer overflow has been added. In addition an
option to toggle the T1 pin upon overflow has been added on the P89LPC917. In the
‘Timer’ function, the register is incremented every machine cycle. In the ‘Counter’
function, the register of Timer 0 is incremented in response to a 1-to-0 transition at its
external input pin. This external input is sampled once very machine cycle.
Timer 0 has five operating modes (modes 0, 1, 2, 3, and 6).
Timer 1 has four operating modes (modes 0, 1, 2, and 3), except on the P89LPC917
where Timer 1 also has mode 6. Modes 0, 1, and 2 are the same for both
Timers/Counters. Mode 3 is different.
9.16.1
Mode 0
Putting either Timer into Mode 0 makes it look like an 8048 Timer, which is an 8-bit
Counter with a divide-by-32 prescaler. In this mode, the Timer register is configured
as a 13-bit register. Mode 0 operation is the same for Timer 0 and Timer 1.
9.16.2
Mode 1
Mode 1 is the same as Mode 0, except that all 16 bits of the timer register are used.
9.16.3
Mode 2
Mode 2 configures the Timer register as an 8-bit Counter with automatic reload.
Mode 2 operation is the same for Timer 0 and Timer 1.
相關PDF資料
PDF描述
P89LPC915HDH 8-bit microcontrollers with accelerated two-clock 80C51 core 2 kB 3 V Flash with 8-bit A/D converter
P89LPC916 8-bit microcontrollers with accelerated two-clock 80C51 core 2 kB 3 V Flash with 8-bit A/D converter
P89LPC917 8-bit microcontrollers with accelerated two-clock 80C51 core 2 kB 3 V Flash with 8-bit A/D converter
P89LPC932A1 8-Bit Microcontroller with accelerated two-clock 80C51 core 8kB 3V byte-erasable flash with 512-byte data EEPROM
P89LPC932 80C51 8-bit microcontroller with two-clock core 8 KB 3 V low-power Flash with 512-byte data EEPROM
相關代理商/技術參數
參數描述
P89LPC9151 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with accelerated two-clock 80C51 core, 2 kB 3 V byte-erasable flash with 8-bit ADC
P89LPC9151FDH 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with accelerated two-clock 80C51 core, 2 kB 3 V byte-erasable flash with 8-bit ADC
P89LPC9151FDH,129 功能描述:8位微控制器 -MCU IC 80C51 MCU FLASH 2KB RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
P89LPC915FDH 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontrollers with accelerated two-clock 80C51 core 2 kB 3 V Flash with 8-bit A/D converter
P89LPC915FDH,129 功能描述:8位微控制器 -MCU 80C51 2K FL 256B RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT