參數資料
型號: P89LPC902FD,112
廠商: NXP Semiconductors
文件頁數: 31/53頁
文件大?。?/td> 0K
描述: IC 80C51 MCU FLASH 1K 8-SOIC
產品培訓模塊: Migrating from 8/16-Bit MCUs to 32-Bit ARMs
標準包裝: 1
系列: LPC900
核心處理器: 8051
芯體尺寸: 8-位
速度: 7.3728MHz
外圍設備: 欠壓檢測/復位,LED,POR,WDT
輸入/輸出數: 6
程序存儲器容量: 1KB(1K x 8)
程序存儲器類型: 閃存
RAM 容量: 128 x 8
電壓 - 電源 (Vcc/Vdd): 2.4 V ~ 3.6 V
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 8-SOIC(0.154",3.90mm 寬)
包裝: 剪切帶 (CT)
配用: 622-1006-ND - SOCKET ADAPTER BOARD
568-1759-ND - EMULATOR DEBUGGER/PROGRMMR LPC9X
其它名稱: 568-1995-1
Philips Semiconductors
P89LPC901/902/903
8-bit microcontrollers with two-clock 80C51 core
Product data
Rev. 05 — 17 December 2004
37 of 53
9397 750 14465
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
8.18.9
Transmit interrupts with double buffering enabled (Modes 1, 2 and 3)
Unlike the conventional UART, in double buffering mode, the Tx interrupt is generated
when the double buffer is ready to receive new data.
8.18.10
The 9th bit (bit 8) in double buffering (Modes 1, 2 and 3)
If double buffering is disabled TB8 can be written before or after SBUF is written, as
long as TB8 is updated some time before that bit is shifted out. TB8 must not be
changed until the bit is shifted out, as indicated by the Tx interrupt.
If double buffering is enabled, TB8 must be updated before SBUF is written, as TB8
will be double-buffered together with SBUF data.
8.19 Analog comparators
One analog comparator is provided on the P89LPC901. Two analog comparators are
provided on the P89LPC902 and P89LPC903 devices. Comparator operation is such
that the output is a logical one (which may be read in a register) when the positive
input is greater than the negative input (selectable from a pin or an internal reference
voltage). Otherwise the output is a zero. The comparator may be congured to cause
an interrupt when the output value changes.
The connections to the comparator are shown in Figure 19. Note: Not all possible
comparator congurations are available on all three devices. Please refer to the Logic
diagrams in Section 6 “Logic symbols” on page 12. The comparator functions to
VDD = 2.4 V.
When the comparator is rst enabled, the comparator output and interrupt ag are not
guaranteed to be stable for 10 microseconds. The comparator interrupt should not be
enabled during that time, and the comparator interrupt ag must be cleared before
the interrupt is enabled in order to prevent an immediate interrupt service.
When a comparator is disabled the comparator’s output, COx, goes HIGH. If the
comparator output was LOW and then is disabled, the resulting transition of the
comparator output from a LOW to HIGH state will set the comparator ag, CMFx.
This will cause an interrupt if the comparator interrupt is enabled. The user should
therefore disable the comparator interrupt prior to disabling the comparator.
Additionally, the user should clear the comparator ag, CMFx, after disabling the
comparator.
相關PDF資料
PDF描述
P89LPC901FD,112 IC 80C51 MCU FLASH 1K 8-SOIC
DS80C320-ENL IC MCU HI SPEED 33MHZ IND 44TQFP
DS80C323-END IC MCU HI SPEED 18MHZ IND 44TQFP
DS80C320-ENG IC MCU HI SPEED 25MHZ IND 44TQFP
DS89C450-ENG IC MCU FLASH 64KB 25MHZ 44-TQFP
相關代理商/技術參數
參數描述
P89LPC902FN 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontrollers with two-clock 80C51 core 1 kB 3 V Flash with 128-byte RAM
P89LPC902FN,129 功能描述:8位微控制器 -MCU 80C51 1K FL 128B RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
P89LPC902FN.129 制造商:NXP Semiconductors 功能描述:8BIT MCU 1K FLASH 89LC902 DIP8
P89LPC903 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontrollers with two-clock 80C51 core 1 kB 3 V Flash with 128-byte RAM
P89LPC903FD 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontrollers with two-clock 80C51 core 1 kB 3 V Flash with 128-byte RAM