參數資料
型號: P87C592EFA
廠商: NXP SEMICONDUCTORS
元件分類: 微控制器/微處理器
英文描述: 8-bit microcontroller with on-chip CAN
中文描述: 8-BIT, OTPROM, 16 MHz, MICROCONTROLLER, PQCC68
文件頁數: 38/108頁
文件大小: 650K
代理商: P87C592EFA
1996 Jun 27
38
Philips Semiconductors
Product specification
8-bit microcontroller with on-chip CAN
P8xC592
Notes to the description of the SR bits
1.
When the Bus Status bit is set HIGH (Bus-OFF), the CAN-controller will set the Reset Request bit HIGH (present).
It will stay in this state until the CPU sets the Reset Request bit LOW (absent). Once this is completed the
CAN-controller will wait the minimum protocol-defined time (128 occurrences of the Bus-Free signal) before setting
the Bus Status bit LOW (Bus-ON), the Error Status bit LOW (ok) and resetting the Error Counters. During Bus-OFF
the output drivers are switched off (floating); external transceiver circuits should output a recessive level in this case.
2.
If both the Receive Status and Transmit Status bits are LOW (idle) the CAN-bus is idle.
3.
If the CPU tries to write to the Transmit Buffer when the Transmit Buffer Access bit is LOW (locked), the written bytes
will not be accepted and will be lost without this being signalled. The Transmission Complete Status bit is set LOW
(incomplete) whenever the Transmission Request bit is set HIGH (present). If an Abort Transmission command is
issued, the Transmit Buffer will be released. If the message, which was requested and then aborted, was not
transmitted, the Transmission Complete Status bit will remain LOW.
4.
If Data Overrun = HIGH (overrun) is detected, the currently received message is dropped. A transmitted message,
granted acceptance, is also stored in a Receive Buffer. This occurs because it is not known if the CAN-controller will
lose arbitration and so become a receiver of the message. If no Receive Buffer is available, Data Overrun is
signalled. However, this transmitted and accepted message does neither cause a Receive Interrupt nor set the
Receive Buffer Status bit to HIGH (full). Also, a Data Overrun does not cause the transmission of an Overload Frame
(see Sections 13.6.1 and 13.6.5).
5.
If the command bit Release Receive Buffer is set HIGH (released) by the CPU, the Receive Buffer Status bit is set
LOW (empty) by IML. When a new message is stored in any of the receive buffers, the Receive Buffer Status bit is
set HIGH (full) again.
相關PDF資料
PDF描述
P8xC592 8-bit microcontroller with on-chip CAN
P83C652EBAA CMOS single-chip 8-bit microcontrollers
P83C652EHBB CMOS single-chip 8-bit microcontrollers
P80C652EHBB CMOS single-chip 8-bit microcontroller
P83C652FFP CMOS single-chip 8-bit microcontrollers
相關代理商/技術參數
參數描述
P87C654X2BBD,157 功能描述:8位微控制器 -MCU 16K/256 OTP 12/6 CLK I2C LQFP RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
P87C654X2FA 制造商:NXP Semiconductors 功能描述:P87C654X2FA 8bit microcontroller,33MHz
P87C654X2FA,529 功能描述:8位微控制器 -MCU 16K/256 OTP 12/6 CLK RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
P87C654X2FA-S 功能描述:8位微控制器 -MCU 16K/256 OTP 12/6 CLK I2C PLCC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
P87C660X2BBD 功能描述:8位微控制器 -MCU 16K/512 OTP 12/6 CLK I2C PCA RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT