- 您現在的位置：買賣IC網 > PDF目錄367723 > P87C591SFB (NXP SEMICONDUCTORS) Single-chip 8-bit microcontroller with CAN controller PDF資料下載
參數資料
| 型號： | P87C591SFB |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Single-chip 8-bit microcontroller with CAN controller |
| 中文描述： | 8-BIT, OTPROM, 16 MHz, MICROCONTROLLER, PQFP44 |
| 封裝： | 10 X 10 X 1.75 MM, PLASTIC, SOT-307-2, QFP-44 |
| 文件頁數： | 34/161頁 |
| 文件大?。?/td> | 588K |
| 代理商： | P87C591SFB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁當前第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁
1999 Aug 19
34
Philips Semiconductors
Objective Specification
Single-chip 8-bit microcontroller with CAN controller
P8xC591
12.5.2
M
ODE
R
EGISTER
(MOD)
The contents of the Mode Register are used to change the behaviour of the CAN Controller. Bits may be set or reset by
the CPU that uses the Mode Register as a read / write memory. Reserved Bits are read as “0”.
Table 13
Mode Register (MOD) CAN Addr. 0 bit interpretation
Notes
1.
A write access to the bits MOD.1, MOD.2, MOD.5, MOD.6 and MOD.7 is possible only, if the Reset Mode is entered
previously.
The PeliCAN Block will enter Sleep Mode, if the Sleep Mode bit is set ‘1’ (sleep), there is no bus activity and no
interrupt is pending. Setting of SM with at least one of the previously mentioned exceptions valid will result in a
wake-up interrupt. The CAN block will wake up if SM is set LOW (wake-up) or there is bus activity. On wake-up, a
Wake-up Interrupt is generated. A sleeping CAN block which wakes up due to bus activity will not be able to receive
this message until it detects 11 consecutive recessive bits (Bus-Free sequence). Note that setting of SM is not
possible in Reset Mode. After clearing of Reset Mode, setting of SM is possible first, when Bus-Free is detected
again.
2.
BIT
SYMBOL
NAME
VALUE
FUNCTION
MOD.7
TM
Test Mode;
Note 1
1 (activated)
The TX0 pin will reflect the bit, detected on RX pin, with the
next positive edge of the system clock. TN0 and TP0 are
configured according the setting of OCR. The TXDC output
directly reflects RXDC. The RPM bit has no influence within
this mode.
0 (disabled)
1 (high active)
MOD.6
MOD.5
RIPM
RPM
Reserved.
Receive Polarity
Mode
RXD inputs are active high (dominant = 1).
0 (low active)
1 (high active)) The PeliCAN Block enters Sleep Mode if no CAN interrupt is
pending and there is no bus activity.
0 (low active)
1 (self test)
In this mode a full node test is possible without any other
active node on the bus using the Self Reception Request
command. The CAN Controller will perform a successful
transmission, even if there is no acknowledge received.
0 (normal)
An acknowledge is required for successful transmission.
1 (reset)
In this mode the CAN would give no acknowledge to the
CAN bus, even if a message is received successfully. No
active error flags are driven to the bus. The error counters
are stopped at the current value.
0 (normal)
Normal communication.
1 (reset)
Setting the Reset Mode bit results in aborting the current
transmission/reception of a message and entering the Reset
Mode.
0 (normal)
On the’1’-to-’0’ transition of the Reset Mode bit, the CAN
Controller returns to the Operating Mode.
RXD inputs are active low (dominant = 0).
MOD.4
SM
Sleep Mode;
Note 2
MOD.3
MOD.2
reserved
Self Test Mode;
Note 1
STM
MOD.1
LOM
Listen Only
Mode; Notes 1
and 3
MOD.0
RM
Reset Mode;
Note 4
相關PDF資料 |
PDF描述 |
|---|---|
| P80C591 | Single-chip 8-bit microcontroller with CAN controller |
| P83C591 | Single-chip 8-bit microcontroller with CAN controller |
| P87C591 | Single-chip 8-bit microcontroller with CAN controller |
| P83C591VFA | Single-chip 8-bit microcontroller with CAN controller |
| P80CE560 | 8-BIT SINGLE CHIP MICROCONTROLLERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P87C591VFA/00,512 | 功能描述:8位微控制器 -MCU 80C51 16K OTP/CAN RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| P87C654X2BBD,157 | 功能描述:8位微控制器 -MCU 16K/256 OTP 12/6 CLK I2C LQFP RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| P87C654X2FA | 制造商:NXP Semiconductors 功能描述:P87C654X2FA 8bit microcontroller,33MHz |
| P87C654X2FA,529 | 功能描述:8位微控制器 -MCU 16K/256 OTP 12/6 CLK RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| P87C654X2FA-S | 功能描述:8位微控制器 -MCU 16K/256 OTP 12/6 CLK I2C PLCC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。