- 您現在的位置：買賣IC網 > PDF目錄367723 > P83C591VFB (NXP SEMICONDUCTORS) Single-chip 8-bit microcontroller with CAN controller PDF資料下載
參數資料
| 型號： | P83C591VFB |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Single-chip 8-bit microcontroller with CAN controller |
| 中文描述： | 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP44 |
| 封裝： | 10 X 10 MM, 1.75 MM HEIGHT, PLASTIC, SOT-307-2, QFP-44 |
| 文件頁數： | 38/161頁 |
| 文件大?。?/td> | 588K |
| 代理商： | P83C591VFB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁當前第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁
1999 Aug 19
38
Philips Semiconductors
Objective Specification
Single-chip 8-bit microcontroller with CAN controller
P8xC591
12.5.5
I
NTERRUPT
R
EGISTER
(IR)
The Interrupt Register allows the identification of an interrupt source. When one or more bits of this register are set, a
CAN interrupt will be indicated to the CPU. After this register is read by the CPU all bits are reset except of the Receive
Interrupt bit.
The Interrupt Register appears to the CPU as a read only memory.
Table 16
Interrupt Register (IR) CAN Addr. 3, bit interpretation
BIT
SYMBOL
NAME
VALUE
FUNCTION
IR.7
BEI
Bus Error Interrupt
1 (set)
This bit is set when the CAN Controller detects an error on
the CAN Bus and the BEIE bit is set within the Interrupt
Enable Register. After a bus error interrupt event this
interrupt is locked until the Error Code Capture Register is
read out once.
0 (reset)
1 (set)
IR.6
ALI
Arbitration Lost
Interrupt
This bit is set when the CAN Controller has lost arbitration
and becomes a receiver and the ALIE bit is set within the
Interrupt Enable Register. After an arbitration lost interrupt
event this interrupt is locked until the Arbitration Lost Capture
Register is read out once.
0 (reset)
1 (set)
IR.5
EPI
Error Passive
Interrupt
This bit is set whenever the CAN Controller has reached the
Error Passive Status (at least one error counter exceeds the
CAN protocol defined level of 127) or if the CAN Controller is
in Error Passive Status and enters the Error Active Status
again and the EPIE bit is set within the Interrupt Enable
Register.
0 (reset)
1 (set)
IR.4
WUI
Wake-Up Interrupt;
Note 1
This bit is set when the CAN Controller is sleeping and bus
activity is detected and the WUIE bit is set within the
Interrupt Enable Register.
0 (reset)
1 (set)
IR.3
DOI
Data Overrun
Interrupt
This bit is set on a 0-to-1 change of the Data Overrun Status
bit, when the Data Overrun Interrupt Enable is set to ‘1’
(enabled).
0 (reset)
1 (set)
IR.2
EI
Error Interrupt
This bit is set on every change (set and clear) of either the
Error Status or Bus Status bits if the Error Interrupt Enable is
set to ‘1’ (enabled).
0 (reset)
1 (set)
IR.1
TI
Transmit Interrupt;
Note 2
This bit is set whenever the Transmit Buffer Status changes
from ‘0’ to ‘1’ (released) and Transmit Interrupt Enable is set
to ‘1’ (enabled).
0 (reset)
1 (set)
IR.0
RI
Receive Interrupt;
Note 4
This bit is set whenever the RXFIFO is filled with more bytes
than specified in the Rx Interrupt Level register or a message
has passed an acceptance filter which is set to “high priority”
and the RIE bit is set within the Interrupt Enable Register.
0 (reset)
相關PDF資料 |
PDF描述 |
|---|---|
| P87C591VFB | 27 PF 5% 50V NPO/COG (0805) CHIP CAP TR |
| P83C591SFA | Single-chip 8-bit microcontroller with CAN controller |
| P87C591SFA | Single-chip 8-bit microcontroller with CAN controller |
| P80C591SFB | Single-chip 8-bit microcontroller with CAN controller |
| P83C591SFB | Single-chip 8-bit microcontroller with CAN controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P83C592 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with on-chip CAN |
| P83C592FFA | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with on-chip CAN |
| P83C592FHA | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with on-chip CAN |
| P83C652EBA | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:CMOS single-chip 8-bit microcontrollers |
| P83C652EBAA | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:CMOS single-chip 8-bit microcontrollers |
發布緊急采購，3分鐘左右您將得到回復。