- 您現在的位置：買賣IC網 > PDF目錄367726 > P83C380 (NXP SEMICONDUCTORS) Microcontrollers for monitors with DDC interface, auto-sync detection and sync proc(帶DDC接口，同步監測和同步處理的監視器微控制器) PDF資料下載
參數資料
| 型號： | P83C380 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Microcontrollers for monitors with DDC interface, auto-sync detection and sync proc(帶DDC接口，同步監測和同步處理的監視器微控制器) |
| 中文描述： | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PDIP42 |
| 封裝： | 0.600 INCH, PLASTIC, SOT-270-1, SDIP-42 |
| 文件頁數： | 81/84頁 |
| 文件大小： | 420K |
| 代理商： | P83C380 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁當前第81頁第82頁第83頁第84頁
1997 Dec 12
81
Philips Semiconductors
Product specification
Microcontrollers for monitors with DDC
interface, auto-sync detection and sync proc.
P83Cx80; P87C380
29 SOLDERING
29.1
Introduction
There is no soldering method that is ideal for all IC
packages. Wave soldering is often preferred when
through-hole and surface mounted components are mixed
on one printed-circuit board. However, wave soldering is
not always suitable for surface mounted ICs, or for
printed-circuits with high population densities. In these
situations reflow soldering is often used.
This text gives a very brief insight to a complex technology.
A more in-depth account of soldering ICs can be found in
our “IC Package Databook”(order code 9398 652 90011).
29.2
Soldering by dipping or by wave
The maximum permissible temperature of the solder is
260
°
C; solder at this temperature must not be in contact
with the joint for more than 5 seconds. The total contact
time of successive solder waves must not exceed
5 seconds.
The device may be mounted up to the seating plane, but
the temperature of the plastic body must not exceed the
specified maximum storage temperature (T
stg max
). If the
printed-circuit board has been pre-heated, forced cooling
may be necessary immediately after soldering to keep the
temperature within the permissible limit.
29.3
Repairing soldered joints
Apply a low voltage soldering iron (less than 24 V) to the
lead(s) of the package, below the seating plane or not
more than 2 mm above it. If the temperature of the
soldering iron bit is less than 300
°
C it may remain in
contact for up to 10 seconds. If the bit temperature is
between 300 and 400
°
C, contact may be up to 5 seconds.
相關PDF資料 |
PDF描述 |
|---|---|
| P87C380 | Microcontrollers for monitors with DDC interface, auto-sync detection and sync proc(帶DDC接口，同步監測和同步處理的監視器微控制器) |
| P83C880 | Microcontrollers for monitors with DDC interface, auto-sync detection and sync proc(帶DDC接口，同步監測和同步處理的監視器微控制器) |
| P83C180 | Microcontrollers for monitors with DDC interface, auto-sync detection and sync proc(帶DDC接口，同步監測和同步處理的監視器微控制器) |
| P83C370AAR | Microcontrollers for PAL/SECAM TV with OSD and VST(帶 OSD和 VST的在PAL/SECAM TV中應用的微控制器) |
| P83C570AAR | Microcontrollers for NTSC TVs with On-Screen Display OSD and Closed Caption CC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P83C434 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontrollers with LCD-driver |
| P83C434CFP | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontrollers with LCD-driver |
| P83C453EBAA | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:80C51 8-bit microcontroller family 8K/256 OTP/ROM, expanded I/O |
| P83C453EFAA | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:CMOS single-chip 8-bit microcontrollers |
| P83C504GBA | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。