• <dfn id="qse5y"></dfn>
    <tt id="qse5y"><thead id="qse5y"><legend id="qse5y"></legend></thead></tt>
  • <span id="qse5y"></span>
    <rp id="qse5y"></rp>
    <var id="qse5y"></var>
  • <li id="qse5y"><form id="qse5y"><div id="qse5y"></div></form></li>
    參數資料
    型號: OR2C06A3T100I-DB
    廠商: LATTICE SEMICONDUCTOR CORP
    元件分類: FPGA
    英文描述: FPGA, 144 CLBS, 6900 GATES, PQFP100
    封裝: TQFP-100
    文件頁數: 118/196頁
    文件大?。?/td> 1393K
    代理商: OR2C06A3T100I-DB
    第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁當前第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁
    28
    Lattice Semiconductor
    Data Sheet
    ORCA Series 2 FPGAs
    November 2006
    Programmable Input/Output Cells
    (continued)
    A. Simplied Diagram of OR2CxxA Programmable
    I/O Cell (PIC)
    B. Simplied Diagram of OR2TxxA/OR2TxxB
    Programmable I/O Cell (PIC)
    Figure 24. Simplied Diagrams
    Outputs
    The PIC’s output drivers have programmable drive
    capability and slew rates. Three propagation delays
    (fast, slewlim, sinklim) are available on output drivers.
    The sinklim mode has the longest propagation delay
    and is used to minimize system noise and minimize
    power consumption. The fast and slewlim modes allow
    critical timing to be met.
    The drive current is 12 mA sink/6 mA source for the
    slewlim and fast output speed selections and
    6 mA sink/3 mA source for the sinklim output. Two adja-
    cent outputs can be interconnected to increase the out-
    put sink current to 24 mA.
    All outputs that are not speed critical should be cong-
    ured as sinklim to minimize power and noise. The num-
    ber of outputs that switch simultaneously in the same
    direction should be limited to minimize ground bounce.
    To minimize ground bounce problems, locate heavily
    loaded output buffers near the ground pads. Ground
    bounce is generally a function of the driving circuits,
    traces on the PCB, and loads and is best determined
    with a circuit simulation.
    Outputs can be inverted, and 3-state control signals
    can be active-high or active-low. An open-drain output
    may be obtained by using the same signal for driving
    the output and 3-state signal nets so that the buffer out-
    put is enabled only by a low. At powerup, the output
    drivers are in slewlim mode, and the input buffers are
    congured as TTL-level compatible with a pull-up. If an
    output is not to be driven in the selected conguration
    mode, it is 3-stated.
    5 V Tolerant I/O (OR2TxxA)
    The I/O on the OR2TxxA series devices allow intercon-
    nection to both 3.3 V and 5 V device (selectable on a
    per-pin basis) by way of special VDD5 pins that have
    been added to the OR2TxxA devices. If any I/O on the
    OR2TxxA device interfaces to a 5 V input, then all of
    the VDD5 pins must be connected to the 5 V supply. If
    no pins on the device interface to a 5 V signal, then the
    VDD5 pins must be connected to the 3.3 V supply.
    If the VDD5 pins are disconnected (i.e., they are oat-
    ing), the device will not be damaged; however, the
    device may not operate properly until VDD5 is returned
    to a proper voltage level. If the VDD5 pins are then
    shorted to ground, a large current ow will develop, and
    the device may be damaged.
    PULL-UP
    VDD
    DELAY
    TTL/CMOS
    PAD
    SLEW RATE
    POLARITY
    DOUT/OUT
    PULL-DOWN
    dintb, dinlr
    in
    POLARITY
    TRI
    5-4591(F)
    PULL-UP
    VDD
    DELAY
    PAD
    SLEW RATE
    POLARITY
    DOUT/OUT
    PULL-DOWN
    dintb, dinlr
    in
    POLARITY
    TRI
    5-4591.T(F)
    Select
    devices
    have
    been
    discontinued.
    See
    Ordering
    Information
    section
    for
    product
    status.
    相關PDF資料
    PDF描述
    OR2C06A3T144I-DB FPGA, 144 CLBS, 6900 GATES, PQFP144
    OR2C06A4T100-DB FPGA, 144 CLBS, 6900 GATES, PQFP100
    OR2C15A-2B256 FPGA, 400 CLBS, 15000 GATES, PBGA256
    OR2C15A-3B256 FPGA, 400 CLBS, 15000 GATES, PBGA256
    OR2C15A-4B256 FPGA, 400 CLBS, 15000 GATES, PBGA256
    相關代理商/技術參數
    參數描述
    OR2C06A-3T144 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays
    OR2C06A-3T144I 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays
    OR2C06A3T144I-DB 功能描述:FPGA - 現場可編程門陣列 Use ECP/EC or XP RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
    OR2C06A-3T160 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays
    OR2C06A-3T160I 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays