- 您現在的位置：買賣IC網 > PDF目錄363776 > OPA3684IDR Operational Amplifier PDF資料下載
參數資料
| 型號： | OPA3684IDR |
| 英文描述： | Operational Amplifier |
| 中文描述： | 運算放大器 |
| 文件頁數： | 13/25頁 |
| 文件大小： | 448K |
| 代理商： | OPA3684IDR |
OPA3684
SBOS241A
13
www.ti.com
directly into the blocking capacitor. The source will then see
the 5k
load of the biasing network as a load. The gain
resistor (R
G
) is AC-coupled, giving the circuit a DC gain of +1,
which puts the noninverting input DC bias voltage (2.5V) on
the output as well. The feedback resistor value has been
adjusted from the bipolar
±
5V supply condition to re-optimize
for a flat frequency response in +5V only, gain of +2,
operation. On a single +5V supply, the output voltage can
swing to within 1.0V of either supply pin while delivering more
than 70mA output current
—
easily giving a 3Vp-p output
swing into 100
(8dBm maximum at the matched 50
load).
The circuit of Figure 3 shows a blocking capacitor driving into
a 50
output resistor, then into a 50
load. Alternatively, the
blocking capacitor could be removed if the load is tied to a
supply midpoint or to ground if the DC current then required
by the load is acceptable.
The circuits of Figure 3 and 4 show single-supply operation
at +5V. These same circuits may be used up to single
supplies of +12V with minimal change in the performance of
the OPA3684.
FIGURE 3. AC-Coupled, G = +2V/V, Single-Supply Specifi-
cations and Test Circuit.
FIGURE 4. AC-Coupled, G =
–
1V/V, Single-Supply Specifi-
cations and Test Circuit.
FIGURE 5. Noninverting Differential I/O Amplifier.
Figure 4 shows the AC-coupled, single +5V supply, gain of
–
1V/V circuit configuration used as a basis for the inverting
+5V only Typical Characteristics for each channel. In this
case, the midpoint DC bias on the noninverting input is also
decoupled with an additional 0.1
μ
F capacitor. This reduces
the source impedance at higher frequencies for the
noninverting input bias current noise. This 2.5V bias on the
noninverting input pin appears on the inverting input pin and,
since R
G
is DC-blocked by the input capacitor, will also
appear at the output pin. One advantage to inverting opera-
tion is that since there is no signal swing across the input
stage, higher slew rates and operation to even lower supply
voltages is possible. To retain a 1Vp-p output capability,
operation down to a 3V supply is allowed. At a +3V supply,
the input stage is saturated, but for the inverting configuration
of a current-feedback amplifier, wideband operation is re-
tained even under this condition.
LOW-POWER, VIDEO LINE DRIVER APPLICATIONS
For low-power, video line driving, the OPA3684 provides the
output current and linearity to support 3 channels of either
single video lines, or up to 4 video lines in parallel on each
output. Figure 5 shows a typical
±
5V supply video line driver
application where only one channel is shown and only a
single line is being driven. The improved 2nd-harmonic
distortion of the CFB
PLUS
architecture, along with the
OPA3684
’
s high output current and voltage, gives excep-
tional differential gain and phase performance for a low-
power solution. As the Typical Characteristics show, a single
video load shows a dG/dP of 0.04%/0.02
°
. Multiple loads
may be driven on each output, with minimal x-talk, while the
dG/dP is still < 0.1%/0.1
°
for up to 4 parallel video loads. The
slew rate and gain of 2 bandwidth are also suitable to
moderate resolution RGB applications.
R
F
1k
1/3
OPA3684
+5V
50
50
Load
50
Source
0.1
μ
F
6.8
μ
F
+
10k
10k
R
M
50
R
G
1k
0.1
μ
F
0.1
μ
F
0.1
μ
F
V
I
DIS
R
F
1.0k
1/3
OPA3684
+5V
50
50
Load
50
Source
0.1
μ
F
0.1
μ
F
6.8
μ
F
+
R
G
1.0k
10k
10k
0.1
μ
F
V
I
0.1
μ
F
R
52.3
DIS
1k
OPA3684
+5V
DIS
–
5V
75
75
1k
75
Load
Supply decoupling not shown.
Coax
VIDEO
IN
相關PDF資料 |
PDF描述 |
|---|---|
| OPA3690ID | OP-AMP|TRIPLE|BIPOLAR|SOP|16PIN|PLASTIC |
| OPA3690IDBQR | 1MHZ 128K I2C SERIAL EEPROM, -40C to +85C, 8-MSOP, T/R |
| OPA3690IDBQT | OP-AMP|TRIPLE|BIPOLAR|SSOP|16PIN|PLASTIC |
| OPA3690IDR | OP-AMP|TRIPLE|BIPOLAR|SOP|16PIN|PLASTIC |
| OPA3691ID | Current-Feedback Operational Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| OPA3684IDRG4 | 功能描述:高速運算放大器 Low-Power Triple Current Feedback RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| OPA369 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1.8V, 700nA, Zer?-Crossover RAIL-TO-RAIL I/O OPERATIONAL AMPLIFIER |
| OPA369_1 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1.8V, 700nA, Zer?-Crossover RAIL-TO-RAIL I/O OPERATIONAL AMPLIFIER |
| OPA3690 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Dual, Wideband, High Output Current, Operational Amplifier with Current Limit |
| OPA3690ID | 功能描述:高速運算放大器 Triple Wideband Voltage-Feedback RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。