參數資料
型號： OM13006,598
廠商： NXP Semiconductors
文件頁數： 8/51頁
文件大?。?/td> 0K
描述： BOARD EVAL EM773 METER EU PLUG
其它有關文件： EM773 Energy Metering IC Training
設計資源： Plug Meter Schematics, Gerber Files
USB Dongle Schematics, Gerber Files
標準包裝： 1
主要目的： 電源管理，電度表/功率表
嵌入式： 是，MCU，32 位
已用 IC / 零件： EM773FHN33，551
已供物品： 板
相關產品： 568-5213-ND - IC ENERGY METER ARM 32VQFN
其它名稱： 568-6681
EM773
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2012. All rights reserved.
Product data sheet
Rev. 2 — 3 January 2012
16 of 51
NXP Semiconductors
EM773
Energy metering IC
7.15.1.2
System oscillator
The system oscillator can be used as the clock source for the CPU, with or without using
the PLL.
The system oscillator operates at frequencies of 1 MHz to 25 MHz. This frequency can be
boosted to a higher frequency, up to the maximum CPU operating frequency, by the
system PLL.
7.15.1.3
Watchdog oscillator
The watchdog oscillator can be used as a clock source that directly drives the CPU, the
watchdog timer, or the CLKOUT pin. The watchdog oscillator nominal frequency is
programmable between 7.8 kHz and 1.7 MHz. The frequency spread over processing and
temperature is
40 %.
7.15.2 System PLL
The PLL accepts an input clock frequency in the range of 10 MHz to 25 MHz. The input
frequency is multiplied up to a high frequency with a Current Controlled Oscillator (CCO).
The multiplier can be an integer value from 1 to 32. The CCO operates in the range of
156 MHz to 320 MHz, so there is an additional divider in the loop to keep the CCO within
its frequency range while the PLL is providing the desired output frequency. The PLL
output frequency must be lower than 100 MHz. The output divider may be set to divide by
2, 4, 8, or 16 to produce the output clock. Since the minimum output divider value is 2, it is
insured that the PLL output has a 50 % duty cycle. The PLL is turned off and bypassed
following a chip reset and may be enabled by software. The program must configure and
activate the PLL, wait for the PLL to lock, and then connect to the PLL as a clock source.
The PLL settling time is 100
s.
7.15.3 Clock output
The EM773 features a clock output function that routes the IRC oscillator, the system
oscillator, the watchdog oscillator, or the main clock to an output pin.
7.15.4 Wake-up process
The EM773 begin operation at power-up and when awakened from Deep power-down
mode by using the 12 MHz IRC oscillator as the clock source. This allows chip operation
to resume quickly. If the system oscillator or the PLL is needed by the application,
software will need to enable these features and wait for them to stabilize before they are
used as a clock source.
7.15.5 Power control
The EM773 support a variety of power control features. There are three special modes of
processor power reduction: Sleep mode, Deep-sleep mode, and Deep power-down mode.
The CPU clock rate may also be controlled as needed by changing clock sources,
reconfiguring PLL values, and/or altering the CPU clock divider value. This allows a
trade-off of power versus processing speed based on application requirements. In
addition, a register is provided for shutting down the clocks to individual on-chip
peripherals, allowing fine tuning of power consumption by eliminating all dynamic power
use in any peripherals that are not required for the application. Selected peripherals have
their own clock divider which provides even better power control.
相關PDF資料
PDF描述
CM252016-680KL INDUCTOR CHIP 68UH 2520 SMD
ECM25DRXN CONN EDGECARD 50POS DIP .156 SLD
VI-J4P-EX CONVERTER MOD DC/DC 13.8V 75W
SI5319-EVB BOARD EVALUATION SI5319
EMM11DSEN-S243 CONN EDGECARD 22POS .156 EYELET
相關代理商/技術參數
參數描述
OM13007 制造商:NXP Semiconductors 功能描述:KIT DEV FOR MPT612 制造商:NXP Semiconductors 功能描述:DEV KIT, FOR MPT612 制造商:NXP Semiconductors 功能描述:DEV KIT, FOR MPT612; SVHC:No SVHC (19-Dec-2012); Kit Features:Low Power High Performance, High Value, LPC1102, with 32KB Of Flash, 8KB of RAM; MCU Supported Families:MPT612
OM13007,598 功能描述:開發板和工具包 - ARM MPT612 IC REFERENCE BOARD RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V
OM13008 制造商:NXP Semiconductors 功能描述:LPC1227, LPCXPRESSO, DEV BOARD 制造商:NXP Semiconductors 功能描述:LPCXpresso Board for LPC1200 Series Development Board 制造商:NXP Semiconductors 功能描述:LPCXpresso Board for LPC1200 Low-Cost Development Board ARM Cortex-M0 MCU 制造商:NXP Semiconductors 功能描述:LPC1227, LPCXPRESSO, DEV BOARD; Silicon Manufacturer:NXP; Core Architecture:ARM; Core Sub-Architecture:Cortex-M0; Silicon Core Number:LPC12xx; Silicon Family Name:LPC122X; Features:Development Board for LPC122X Microcontroller; ;RoHS Compliant: Yes 制造商:NXP 功能描述:LPCXpresso Board for LPC1200 Low-Cost Development Board ARM Cortex-M0 MCU
OM13008, 598 制造商:NXP Semiconductors 功能描述:
OM13008,598 功能描述:開發板和工具包 - ARM LPCXpresso Board RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*