- 您現在的位置：買賣IC網 > PDF目錄96097 > MTP50N03HDL (ON SEMICONDUCTOR) 50 A, 30 V, 0.025 ohm, P-CHANNEL, Si, POWER, MOSFET, TO-220AB PDF資料下載
參數資料
| 型號： | MTP50N03HDL |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | JFETs |
| 英文描述： | 50 A, 30 V, 0.025 ohm, P-CHANNEL, Si, POWER, MOSFET, TO-220AB |
| 封裝： | CASE 221A-09, 3 PIN |
| 文件頁數： | 6/8頁 |
| 文件大?。?/td> | 71K |
| 代理商： | MTP50N03HDL |
MTP50P03HDL
http://onsemi.com
6
I S
,SOURCE
CURRENT
t, TIME
Figure 11. Reverse Recovery Time (trr)
di/dt = 300 A/s
Standard Cell Density
High Cell Density
tb
trr
ta
trr
SAFE OPERATING AREA
The Forward Biased Safe Operating Area curves define
the maximum simultaneous drain–to–source voltage and
drain current that a transistor can handle safely when it is
forward biased. Curves are based upon maximum peak
junction temperature and a case temperature (TC) of 25°C.
Peak repetitive pulsed power limits are determined by using
the thermal response data in conjunction with the procedures
discussed in AN569, “Transient Thermal Resistance –
General Data and Its Use.”
Switching between the off–state and the on–state may
traverse any load line provided neither rated peak current
(IDM) nor rated voltage (VDSS) is exceeded, and that the
transition time (tr, tf) does not exceed 10 s. In addition the
total power averaged over a complete switching cycle must
not exceed (TJ(MAX) – TC)/(R
θJC).
A power MOSFET designated E–FET can be safely used
in switching circuits with unclamped inductive loads. For
reliable operation, the stored energy from circuit inductance
dissipated in the transistor while in avalanche must be less
than the rated limit and must be adjusted for operating
conditions differing from those specified. Although industry
practice is to rate in terms of energy, avalanche energy
capability is not a constant. The energy rating decreases
non–linearly with an increase of peak current in avalanche
and peak junction temperature.
Although many E–FETs can withstand the stress of
drain–to–source avalanche at currents up to rated pulsed
current (IDM), the energy rating is specified at rated
continuous current (ID), in accordance with industry
custom. The energy rating must be derated for temperature
as shown in the accompanying graph (Figure 13). Maximum
energy at currents below rated continuous ID can safely be
assumed to equal the values indicated.
VDS, DRAIN-TO-SOURCE VOLTAGE (VOLTS)
TJ, STARTING JUNCTION TEMPERATURE (°C)
E AS
,SINGLE
PULSE
DRAIN-T
O-SOURCE
AV
ALANCHE
ENERGY
(mJ)
I D
,DRAIN
CURRENT
(AMPS)
Figure 12. Maximum Rated Forward Biased
Safe Operating Area
25
150
50
100
125
75
0
1400
800
600
400
200
1000
Figure 13. Maximum Avalanche Energy versus
Starting Junction Temperature
0.1
1.0
10
100
1
10
100
1000
dc
100 s
1 ms
10 ms
RDS(on) LIMIT
THERMAL LIMIT
PACKAGE LIMIT
VGS = 20 V
SINGLE PULSE
TC = 25°C
ID = 50 A
1200
相關PDF資料 |
PDF描述 |
|---|---|
| MTP50N06EU | 50 A, 60 V, 0.025 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-220AB |
| MTP50N06EN | 50 A, 60 V, 0.025 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-220AB |
| MTP50N06E16 | 50 A, 60 V, 0.025 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-220AB |
| MTP10N10EWC | 10 A, 100 V, 0.25 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-220AB |
| MTP10N10EUA | 10 A, 100 V, 0.25 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-220AB |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MTP50N05E | 制造商:Motorola Inc 功能描述: 制造商:Texas Instruments 功能描述: |
| MTP50N05EW | 制造商:Motorola Inc 功能描述:50 A, 50 V, 0.028 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-220AB |
| MTP50N06 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:TMOS POWER FET 42 AMPERES 60 VOLTS RDS(on) = 0.032 OHM |
| MTP50N06EL | 制造商:ON Semiconductor 功能描述: |
| MTP50N06V | 功能描述:MOSFET DISC BY MFG 2/02 RoHS:否 制造商:STMicroelectronics 晶體管極性:N-Channel 汲極/源極擊穿電壓:650 V 閘/源擊穿電壓:25 V 漏極連續電流:130 A 電阻汲極/源極 RDS（導通）:0.014 Ohms 配置:Single 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:Max247 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。