參數資料
型號: MPG5374X
元件分類: LED
英文描述: T-1 3/4 SINGLE COLOR LED, GREEN, 5 mm
封裝: ROHS COMPLIANT PACKAGE-2
文件頁數: 13/32頁
文件大?。?/td> 413K
代理商: MPG5374X
20
XMEGA C3 [DATASHEET]
8361D–AVR–07/2013
1kHz output. The oscillator is automatically enabled/disabled when it is used as clock source for any part of the device.
This oscillator can be selected as the clock source for the RTC.
10.3.2 32.768kHz Calibrated Internal Oscillator
This oscillator provides an approximate 32.768kHz clock. It is calibrated during production to provide a default frequency
close to its nominal frequency. The calibration register can also be written from software for run-time calibration of the
oscillator frequency. The oscillator employs a built-in prescaler, which provides both a 32.768kHz output and a 1.024kHz
output.
10.3.3 32.768kHz Crystal Oscillator
A 32.768kHz crystal oscillator can be connected between the TOSC1 and TOSC2 pins and enables a dedicated low
frequency oscillator input circuit. A low power mode with reduced voltage swing on TOSC2 is available. This oscillator
can be used as a clock source for the system clock and RTC, and as the DFLL reference clock.
10.3.4 0.4 - 16MHz Crystal Oscillator
This oscillator can operate in four different modes optimized for different frequency ranges, all within 0.4 - 16MHz.
10.3.5 2MHz Run-time Calibrated Internal Oscillator
The 2MHz run-time calibrated internal oscillator is the default system clock source after reset. It is calibrated during
production to provide a default frequency close to its nominal frequency. A DFLL can be enabled for automatic run-time
calibration of the oscillator to compensate for temperature and voltage drift and optimize the oscillator accuracy.
10.3.6 32MHz Run-time Calibrated Internal Oscillator
The 32MHz run-time calibrated internal oscillator is a high-frequency oscillator. It is calibrated during production to
provide a default frequency close to its nominal frequency. A digital frequency looked loop (DFLL) can be enabled for
automatic run-time calibration of the oscillator to compensate for temperature and voltage drift and optimize the oscillator
accuracy. This oscillator can also be adjusted and calibrated to any frequency between 30MHz and 55MHz. The
production signature row contains 48MHz calibration values intended used when the oscillator is used a full-speed USB
clock source.
10.3.7 External Clock Sources
The XTAL1 and XTAL2 pins can be used to drive an external oscillator, either a quartz crystal or a ceramic resonator.
XTAL1 can be used as input for an external clock signal. The TOSC1 and TOSC2 pins is dedicated to driving a
32.768kHz crystal oscillator.
10.3.8 PLL with 1x-31x Multiplication Factor
The built-in phase locked loop (PLL) can be used to generate a high-frequency system clock. The PLL has a user-
selectable multiplication factor of from 1 to 31. In combination with the prescalers, this gives a wide range of output
frequencies from all clock sources.
相關PDF資料
PDF描述
MPI002/TERM/RD PUSHBUTTON SWITCH, SPST, MOMENTARY-TACTILE, 0.05A, 24VDC, PANEL MOUNT
MPN-7430 300 V, SILICON, PIN DIODE
MPR3372X T-1 SINGLE COLOR LED, RED, 3 mm
MPS101A SLIDE SWITCH, SP3T, LATCHED, 0.3A, 30VDC, THROUGH HOLE-RIGHT ANGLE
MPS3414 NPN SILICON TRANSISTOR
相關代理商/技術參數
參數描述
MPG5379K 制造商:Stanley Electric Co 功能描述:LED Uni-Color Green 560nm 2-Pin Bulk 制造商:The Stanley Works 功能描述:Green 2.5 x 5 mm 24 x 18 Min 12 mcd Typical 24 mcd Diffused Through Hole LED 制造商:STANLEY 功能描述:Green 2.5 x 5 mm 24 ? x 18 ? Min 12 mcd Typical 24 mcd Diffused Through Hole LED 制造商:Stanley Electric Co 功能描述:Green 2.5 x 5 mm 24 ? x 18 ? Min 12 mcd Typical 24 mcd Diffused Through Hole LED
MPG5763X 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic
MPG5764X 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic
MPG5773X 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic
MPG5774X 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic