Each " />
參數資料
型號: MPC8313EVRADDB
廠商: Freescale Semiconductor
文件頁數: 87/99頁
文件大小: 0K
描述: MPU POWERQUICC II PRO 516-PBGA
標準包裝: 40
系列: MPC83xx
處理器類型: 32-位 MPC83xx PowerQUICC II Pro
速度: 267MHz
電壓: 0.95 V ~ 1.05 V
安裝類型: 表面貼裝
封裝/外殼: 516-BBGA 裸露焊盤
供應商設備封裝: 516-PBGAPGE(27x27)
包裝: 托盤
MPC8313E PowerQUICC II Pro Processor Hardware Specifications, Rev. 4
88
Freescale Semiconductor
22.2
PLL Power Supply Filtering
Each of the PLLs listed above is provided with power through independent power supply pins (AVDD1,
AVDD2, and SDAVDD, respectively). The AVDD level should always be equivalent to VDD, and preferably
these voltages are derived directly from VDD through a low frequency filter scheme such as the following.
There are a number of ways to reliably provide power to the PLLs, but the recommended solution is to
provide independent filter circuits as illustrated in Figure 58, one to each of the five AVDD pins. By
providing independent filters to each PLL the opportunity to cause noise injection from one PLL to the
other is reduced.
This circuit is intended to filter noise in the PLLs resonant frequency range from a 500 kHz to 10 MHz
range. It should be built with surface mount capacitors with minimum effective series inductance (ESL).
Consistent with the recommendations of Dr. Howard Johnson in High Speed Digital Design: A Handbook
of Black Magic (Prentice Hall, 1993), multiple small capacitors of equal value are recommended over a
single large value capacitor.
Each circuit should be placed as close as possible to the specific AVDD pin being supplied to minimize
noise coupled from nearby circuits. It should be possible to route directly from the capacitors to the AVDD
pin, which is on the periphery of package, without the inductance of vias.
This figure shows the PLL power supply filter circuits.
Figure 58. PLL Power Supply Filter Circuit
The SDAVDD signal provides power for the analog portions of the SerDes PLL. To ensure stability of the
internal clock, the power supplied to the PLL is filtered using a circuit like the one shown in Figure 59.
For maximum effectiveness, the filter circuit should be placed as closely as possible to the SDAVDD ball
to ensure it filters out as much noise as possible. The ground connection should be near the SDAVDD ball.
The 0.003-F capacitor is closest to the ball, followed by the two 2.2-F capacitors, and finally the 1-
resistor to the board supply plane. The capacitors are connected from traces from SDAVDD to the ground
plane. Use ceramic chip capacitors with the highest possible self-resonant frequency. All traces should be
kept short, wide, and direct.
Figure 59. SerDes PLL Power Supply Filter Circuit
Note the following:
SDAVDD should be a filtered version of XCOREVDD.
VDD
AVDD1 and AVDD2
10
2.2 F
Low ESL Surface Mount Capacitors
Note:
1. An 0805 sized capacitor is recommended for system initial bring-up.
XCOREVDD
SDAVDD
SDAVSS
2.2 F1
0.003 F
1.0
2.2 F1
相關PDF資料
PDF描述
IDT7143LA20JG IC SRAM 32KBIT 20NS 68PLCC
MPC8315EVRAFDA MPU POWERQUICC II PRO 620-PBGA
MPC8315CVRAFDA MPU POWERQUICC II PRO 620-PBGA
MC68LC302CAF20CT IC MPU MULTI PROTOCOL 100-LQFP
IDT70V05S15J8 IC SRAM 64KBIT 15NS 68PLCC
相關代理商/技術參數
參數描述
MPC8313EVRADDC 功能描述:微處理器 - MPU 8313 REV2.2 W/ENC RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MPC8313EVRAFD 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:PowerQUICC? II Pro Processor Hardware Specifications
MPC8313EVRAFDA 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:PowerQUICC? II Pro Processor Hardware Specifications
MPC8313EVRAFDB 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:PowerQUICC? II Pro Processor Hardware Specifications
MPC8313EVRAFF 功能描述:微處理器 - MPU 8313 NOPB PBGA W/ ENCR RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324