- 您現在的位置：買賣IC網 > PDF目錄45352 > MPC603PFE233LX (MOTOROLA INC) 32-BIT, 233 MHz, RISC PROCESSOR, CQFP240 PDF資料下載
參數資料
| 型號： | MPC603PFE233LX |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, 233 MHz, RISC PROCESSOR, CQFP240 |
| 封裝： | 32 X 32 MM, 4.15 MM HEIGHT, 0.50 MM PITCH, WIRE BOND, CERAMIC, QFP-240 |
| 文件頁數： | 24/40頁 |
| 文件大小： | 156K |
| 代理商： | MPC603PFE233LX |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
30
PID7v-603e Hardware Specifications
PRELIMINARY—SUBJECT TO CHANGE WITHOUT NOTICE
1.8.2 PLL Power Supply Filtering
The AVdd power signal is provided on the 603e to provide power to the clock generation phase-locked loop.
To ensure stability of the internal clock, the power supplied to the AVdd input signal should be ltered using
a circuit similar to the one shown in Figure 14. The circuit should be placed as close as possible to the AVdd
pin to ensure it lters out as much noise as possible. The 0.1
F capacitor should be closest to the AVdd pin,
followed by the 10
F capacitor, and nally the 10 resistor to Vdd. These traces should be kept short and
direct.
Figure 14. PLL Power Supply Filter Circuit
1.8.3 Decoupling Recommendations
Due to the 603e’s dynamic power management feature, large address and data buses, and high operating
frequencies, the 603e can generate transient power surges and high frequency noise in its power supply,
especially while driving large capacitive loads. This noise must be prevented from reaching other
components in the 603e system, and the 603e itself requires a clean, tightly regulated source of power.
Therefore, it is recommended that the system designer place at least one decoupling capacitor at each Vdd
and OVdd pin of the 603e. It is also recommended that these decoupling capacitors receive their power from
separate Vdd, OVdd, and GND power planes in the PCB, utilizing short traces to minimize inductance.
These capacitors should vary in value from 220 pF to 10
F to provide both high- and low-frequency
ltering, and should be placed as close as possible to their associated Vdd or OVdd pin. Suggested values
for the Vdd pins—220 pF (ceramic), 0.01
F (ceramic), and 0.1 F (ceramic). Suggested values for the
OVdd pins—0.01
F (ceramic), 0.1 F (ceramic), and 10 F (tantalum). Only SMT (surface mount
technology) capacitors should be used to minimize lead inductance.
In addition, it is recommended that there be several bulk storage capacitors distributed around the PCB,
feeding the Vdd and OVdd planes, to enable quick recharging of the smaller chip capacitors. These bulk
capacitors should also have a low ESR (equivalent series resistance) rating to ensure the quick response time
necessary. They should also be connected to the power and ground planes through two vias to minimize
inductance. Suggested bulk capacitors—100
F (AVX TPS tantalum) or 330 F (AVX TPS tantalum).
1.8.4 Connection Recommendations
To ensure reliable operation, it is highly recommended to connect unused inputs to an appropriate signal
level. Unused active low inputs should be tied to Vdd. Unused active high inputs should be connected to
GND. All NC (no-connect) signals must remain unconnected.
Power and ground connections must be made to all external Vdd, OVdd, and GND pins of the 603e.
1.8.5 Pull-up Resistor Requirements
The 603e requires high-resistive (weak: 10 K
) pull-up resistors on several control signals of the bus
interface to maintain the control signals in the negated state after they have been actively negated and
released by the 603e or other bus master. These signals are—TS, ABB, DBB, and ARTRY.
Vdd
AVdd
10
10
F
0
.1
F
GND
相關PDF資料 |
PDF描述 |
|---|---|
| MPC603PRX225LX | 32-BIT, 225 MHz, RISC PROCESSOR, CBGA255 |
| MPC603PFE240LX | 32-BIT, 240 MHz, RISC PROCESSOR, CQFP240 |
| MPC603RRX266LX | 32-BIT, 266 MHz, RISC PROCESSOR, CBGA255 |
| MPC603RRX300TX | 32-BIT, 300 MHz, RISC PROCESSOR, CBGA255 |
| MPC603RRX200LX | 32-BIT, 200 MHz, RISC PROCESSOR, CBGA255 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MPC603RRX200LC | 功能描述:微處理器 - MPU 603R REV2.1 HIP3.0 RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC603RRX200TC | 功能描述:微處理器 - MPU 603R REV2.1 HIP3.0 RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC603RRX266LC | 功能描述:微處理器 - MPU 603R REV2.1 HIP3.0 RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC603RRX266TC | 功能描述:微處理器 - MPU 603R REV2.1 HIP3.0 RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC603RRX300LC | 功能描述:微處理器 - MPU 603R REV2.1 HIP3.0 RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
發布緊急采購，3分鐘左右您將得到回復。