參數資料
型號： MPC5567MZQ112
廠商： FREESCALE SEMICONDUCTOR INC
元件分類： 微控制器/微處理器
英文描述： FLASH, 112 MHz, MICROCONTROLLER, PBGA324
封裝： 23 X 23 MM, 1 MM PITCH, PLASTIC, MS-034AAJ-1, BGA-324
文件頁數： 60/66頁
文件大?。?/td> 1903K
代理商： MPC5567MZQ112
Revision History for the MPC5567 Data Sheet
MPC5567 Microcontroller Data Sheet, Rev. 1.0
Freescale Semiconductor
63
Table 12 FMPLL Electrical Characteristics:
Added (TA = TL – TH) to the end of the second line in the table title.
Spec 1, footnote 1 in column 2: ‘PLL reference frequency range’: Changed to read ‘Nominal crystal and external
reference values are worst-case not more than 1%. The device operates correctly if the frequency remains within
± 5% of the specification limit. This tolerance range allows for a slight frequency drift of the crystals over time.
The designer must thoroughly understand the drift margin of the source clock.‘
Spec 1, added two more lines to the PLL reference frequency range’ to read as follows
:
crystal reference (20)
fref_crystal
8
≤ 20
crystal reference (40)
fref_crystal
> 20
40
external reference (20)
fref_ext
8
≤ 20
external reference (40)
fref_ext
> 20
40
Spec 1, footnote 2 in column 1: Changed to: ‘The 8–20 MHz crystal or external reference values have PLLCFG[2]
pulled low’ and applies to spec 1, column 2, crystal reference and external reference.
Specs 12 and 13: Grouped (2 x Cl).
Spec 21, column 2: Changed fref_crystal to fref in ICO frequency equation, and
added the same equation but substituted fref_ext for fref for the external reference clock, giving:
fico = [ fref_crystal × (MFD + 4) ] ÷ (PREDIV + 1)
fico = [ fref_ext × (MFD + 4) ] ÷ (PREDIV + 1)
Spec 21, column 4, Max: Deleted old footnote 18 that reads:
The ICO frequency can be higher than the maximum allowable system frequency. For this case, set the CMPLL
synthesizer control register reduced frequency divider (FMPLL_SYNCR[RFD]) to divide-by-two (RFD = 0b001).
Therefore, for a 40 MHz maximum device (system frequency), program the FMPLL to generate 80 MHz at the
ICO output and then divide-by-two the RFD to provide the 40 MHz system clock.’
Spec 21: Changed column 5 from ‘fSYS’ MHz’ to: ‘fMAX’.
Spec 22: Changed column 4, Max Value from fMAX to 20, and added footnote 17 to read, ‘Maximum value for
dual controller (1:1) mode is (fMAX ÷ 2) and the predivider set to 1 (FMPLL_SYNCR[PREDIV] = 0b001).’
Table 13 eQADC Conversion Specifications: Added (TA = TL – TH) to the table title.
Table 14 Flash Program and Erase Specifications:
Added (TA = TL – TH) to the table title.
Specs 7, 8, 9, and 10 Changed values for the H7Fa Flash pre-program and erase times and used the previous
values for Typical values.
48 KB: from 340 to 345
64 KB: from 400 to 415
Spec 8, 128KB block pre-program and erase time, Max column value from 15,000 to 7,500.
Moved footnote 1 from the table title to directly after the ‘Typical’ in the column 5 header.
Footnote 2: Changed from: ‘Initial factory condition:
≤ 100 program/erase cycles, 25 oC, typical supply voltage,
80 MHz minimum system frequency.‘ To: ‘Initial factory condition:
≤ 100 program/erase cycles, 25 oC, using a
typical supply voltage measured at a minimum system frequency of 80 MHz.’
Table 15 Flash EEPROM Module Life:
Replaced (Full Temperature Range) with (TA = TL – TH) in the table title.
Spec 1b, Min. column value changed from 10,000 to 1,000.
Table 33. Table and Figure Changes Between Rev. 0.0 and 1.0 (continued)
Location
Description of Changes
Because
of
an
order
from
the
United
States
International
Trade
Commission,
BGA-packaged
product
lines
and
part
numbers
indicated
here
currently
are
not
available
from
Freescale
for
import
or
sale
in
the
United
States
prior
to
September
2010:
MPC551x
and
MPC5533
products
in
208
MAPBGA
packages;
MPC5534
and
MPC5553
products
in
208
and
496
MAPBGA
packages;
MPC5554,
MPC5565,
MPC5566
and
MPC5567
products
in
496
MAPBGA
packages
相關PDF資料
PDF描述
MPC5567MVZ80 FLASH, 80 MHz, MICROCONTROLLER, PBGA324
MPC5567MVR112 FLASH, 112 MHz, MICROCONTROLLER, PBGA416
MPC5601PEF0VLL6 32-BIT, FLASH, 64 MHz, RISC MICROCONTROLLER, PQFP100
MPC5602F0VLH6R 32-BIT, FLASH, 64 MHz, RISC MICROCONTROLLER, PQFP64
MPC5602PEF0MLH6R 32-BIT, FLASH, 64 MHz, RISC MICROCONTROLLER, PQFP64
相關代理商/技術參數
參數描述
MPC5567MZQ112R2 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontroller
MPC5567MZQ132 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontroller
MPC5567MZQ132R2 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontroller
MPC5567MZQ80 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontroller
MPC5567MZQ80R2 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontroller
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*