- 您現在的位置：買賣IC網 > PDF目錄383617 > MICRF213AYQS (MICREL INC) 1.8 V dual UART, 20 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA), and XScale VLIO bus interface, SOT912-1 (TFBGA36), Tray Pack, Bakeable, Multiple PDF資料下載
參數資料
| 型號： | MICRF213AYQS |
| 廠商： | MICREL INC |
| 元件分類： | 消費家電 |
| 英文描述： | 1.8 V dual UART, 20 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA), and XScale VLIO bus interface, SOT912-1 (TFBGA36), Tray Pack, Bakeable, Multiple |
| 中文描述： | SPECIALTY CONSUMER CIRCUIT, PDSO16 |
| 封裝： | QSOP-16 |
| 文件頁數： | 8/16頁 |
| 文件大小： | 850K |
| 代理商： | MICRF213AYQS |
Micrel, Inc.
MICRF213
Application Information
May 2007
8
M9999-052307-A
(408) 944-0800
+3.3V
1C3
ANT2
C6
0.47μF
Y1
9.81563MHz
C8
U1 MICRFAYQS
RO1
GNDRF
ANT
GNDRF
VDD
SQ
SEL0
SHDN
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
GND
DO
SEL1
CTH
CAGC
RSSI
NC
RO2
J2
L2
DO
RSSI
C4
4.7μF
R2
(np)
+3.3V
R1
JR2
short
R3
JP3
open
JP1
short
C5
0.1μF
C9
ANT1
L1
6
5
4
3
2
1
RSSI
SH
NC
D0
GND
+3.3V
+3.3V
DO
SH
RSSI
L3
75nH 2%
Figure 3. QR213HE1 Application Example, 315MHz
The MICRF213 can be fully tested by using one of the
many evaluation boards designed by Micrel and
intended for use with this device. As an entry level,
the QR213HE1 (reference Figure 3) offers a good
start for most applications. It has a helical PCB
antenna with its matching network, a band-pass-filter
front-end as a pre-selector filter, matching network
and the minimum components required to make the
device work. The minimum components are a crystal,
Cagc, and Cth capacitors. By removing the matching
network of the helical PCB antenna (C9 and L3), a
whip antenna (ANT2) or a RF connector (J2) can be
used instead. Figure 3 shows the entire schematic for
315MHz. Other frequencies can be used and the
values needed are listed in the tables below.
Capacitor C9 and inductor L3 are the passive
elements for the helical PCB matching network. It is
recommended that a tight tolerance be used for these
devices; such as 2% for the inductor and 0.1pF for the
capacitor. PCB variations may require different values
and optimization. Table 2 shows the matching
elements for the device frequency range. For
additional information, reference the: Small PCB
Antennas for Micrel RF Products application note.
Freq (MHz)
303.825
315
345
C9 (pF)
1.2
1.2
1.2
L3 (nH)
82
75
62
Table 2. Matching Values for the Helical PCB Antenna
To use another antenna, such as the whip kind, remove
C9 and place the whip antenna in the hole provided in
the PCB. Also, a RF signal can be injected there.
L1 and C8 form the pass-band-filter front-end. Its
purpose is to attenuate undesired outside band noise
which reduces the receiver performance. It is
calculated by the parallel resonance equation
f = 1/(2*PI*(SQRT(L1*C8)). Table 3 shows the most
used frequency values.
Freq (MHz)
303.825
315
345
C8 (pF)
6.8
6.8
5.6
L1 (nH)
39
39
39
Table 3. Band-Pass-Filter Front-End Values
There is no need for the band-pass-filter front-end for
applications where it is proven the outside band noise
does not cause a problem. The MICRF213 has image
reject mixers which improve significantly the selectivity
and rejection of outside band noise.
Capacitor C3 and inductor L2 form the L-shape
matching network. The capacitor provides additional
attenuation for low frequency outside band noise and
the inductor provides additional ESD protection for the
antenna pin. Two ways can be used to find these
values, which are matched close to 50
. One method
is done by calculating the values using the equations
below and another by using a Smith chart. The latter
is made easier by using software that plots the values
of the components C8 and L1, like WinSmith by Noble
Publishing.
To calculate the matching values, one needs to know
the input impedance of the device. Table 4 shows the
input impedance of the MICRF213 and the suggested
matching values used for the most frequencies.
相關PDF資料 |
PDF描述 |
|---|---|
| MIIC5271 | Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection |
| MIIC5271-5.0BM5 | Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection |
| MIIC5271BM5 | Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection |
| MIIC5271-3.0BM5 | Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection |
| MIL-PRF-83401 | MILITARY NETWORKS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MICRF213AYQS TR | 功能描述:射頻接收器 300MHz to 350MHz, 3.0V to 3.6V, 7.2kbps, 4mA, ASK Receiver with RSSI, Shutdown in 16-Lead QSOP (Lead-Free) RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
| MICRF218 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3.3V, 315/433MHz Wide-IF Bandwidth ASK Receiver |
| MICRF218_11 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3.3V, 315/433MHz Wide-IF Bandwidth ASK Receiver |
| MICRF218AYQS | 功能描述:射頻接收器 300MHz to 450MHz, 3.0V to 3.6V, <10kbps, 4mA, Wide-IF Bandwidth ASK Receiver with RSSI, Shutdown in 16-Lead QSOP RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
| MICRF218AYQS TR | 功能描述:射頻接收器 300MHz to 450MHz, 3.0V to 3.6V, <10kbps, 4mA, Wide-IF Bandwidth ASK Receiver with RSSI, Shutdown in 16-Lead QSOP RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。