- 您現在的位置：買賣IC網 > PDF目錄69028 > MC68HC705G1FU (MOTOROLA INC) 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PQFP64 PDF資料下載
參數資料
| 型號： | MC68HC705G1FU |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PQFP64 |
| 封裝： | QFP-64 |
| 文件頁數： | 101/124頁 |
| 文件大?。?/td> | 732K |
| 代理商： | MC68HC705G1FU |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁當前第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁
MOTOROLA
8-12
MC68HC05G1
SERIAL PERIPHERAL INTERFACE
8
MODF bit is normally a logic zero and is set only when the master device has its SS pin pulled
low. Toggling the MODF bit to a logic one affects the internal serial peripheral interface (SPI)
system in the following ways:
1) MODF is set and SPI interrupt is generated if SPIE=1
2) The SPE bit is forced to a logic zero. This blocks all output drive from the
device, disables the SPI system.
3) The MSTR bit is forced to a logic zero, thus forcing the device into the slave
mode.
Clearing the MODF is accomplished by a software sequence of accessing the serial peripheral
status register while MODF is set followed by a write to the serial peripheral control register.
Control bits SPE and MSTR may restored to their original set state during this clearing sequence
or after the MODF bit has been cleared. Hardware does not allow the user to set the SPE and
MSTR bit while MODF is a logic one unless it is during the proper clearing sequence. The MODF
ag bit indicates that there might have been a multi-master conict for system control and allows
a proper exit from system operation to a reset or default system state. The MODF is cleared by
reset.
8.4.3
Serial Peripheral Data I/O Register (SPDR)
The serial peripheral data I/O register is used to transmit and receive data on the serial bus.
A write to this register will initiate transmission/reception of another byte and this will only occur in
the master device. A slave device writing to this data I/O register will not initiate a transmission. At
the completion of transmitting a byte of data, the SPIF is set in both the master and slave devices.
A write or read of the serial peripheral data I/O register, after accessing the serial peripheral status
register with SPIF set, will clear SPIF.
During the clock cycle that the SPIF bit is being set, a copy of the received data byte in the shift
register is being moved to a buffer. When the user reads the serial peripheral data I/O register, the
buffer is actually being read. During an overrun condition, when the master device has sent
several bytes of data and the slave device has not internally responded to clear the rst SPIF, only
the rst byte is contained in the receive buffer of the slave device; all others are lost. The user may
read the buffer at any time. The rst SPIF must be cleared by the time a second transfer of data
from the shift register to the read buffer is initiated or an overrun condition will exist.
A write to the serial peripheral data I/O register is not buffered and places data directly into the
shift register for transmission.
The ability to access the serial peripheral data I/O register is limited when a transmission is taking
place. It is important to read the discussion dening the WCOL and SPIF status bits to understand
the limits on using the serial peripheral data I/O register.
Address
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
$2C
TPG
74
相關PDF資料 |
PDF描述 |
|---|---|
| MC68HC05G1B | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP56 |
| MC68HC705JB2DW | 8-BIT, OTPROM, 3 MHz, MICROCONTROLLER, PDSO20 |
| MC68HC705JB2P | 8-BIT, OTPROM, 3 MHz, MICROCONTROLLER, PDIP20 |
| MC68HC705JB4P | 8-BIT, OTPROM, 3 MHz, MICROCONTROLLER, PDIP28 |
| MC68HC705K1CDW | 8-BIT, OTPROM, 2 MHz, MICROCONTROLLER, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC68HC705J1A | 制造商:Freescale Semiconductor 功能描述: |
| MC68HC705J1ACDW | 功能描述:IC MCU 4MHZ 1.2K OTP 20-SOIC RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:HC05 其它有關文件:STM32F101T8 View All Specifications 特色產品:STM32 32-bit Cortex MCUs 標準包裝:490 系列:STM32 F1 核心處理器:ARM? Cortex?-M3 芯體尺寸:32-位 速度:36MHz 連通性:I²C，IrDA，LIN，SPI，UART/USART 外圍設備:DMA，PDR，POR，PVD，PWM，溫度傳感器，WDT 輸入/輸出數:26 程序存儲器容量:64KB（64K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:10K x 8 電壓 - 電源 (Vcc/Vdd):2 V ~ 3.6 V 數據轉換器:A/D 10x12b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:36-VFQFN，36-VFQFPN 包裝:托盤 配用:497-10030-ND - STARTER KIT FOR STM32497-8853-ND - BOARD DEMO STM32 UNIV USB-UUSCIKSDKSTM32-PL-ND - KIT IAR KICKSTART STM32 CORTEXM3497-8512-ND - KIT STARTER FOR STM32F10XE MCU497-8505-ND - KIT STARTER FOR STM32F10XE MCU497-8304-ND - KIT STM32 MOTOR DRIVER BLDC497-6438-ND - BOARD EVALUTION FOR STM32 512K497-6289-ND - KIT PERFORMANCE STICK FOR STM32MCBSTM32UME-ND - BOARD EVAL MCBSTM32 + ULINK-MEMCBSTM32U-ND - BOARD EVAL MCBSTM32 + ULINK2更多... 其它名稱:497-9032STM32F101T8U6-ND |
| MC68HC705J1ACP | 功能描述:IC MCU 4MHZ 1.2K OTP 20-DIP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:HC05 其它有關文件:STM32F101T8 View All Specifications 特色產品:STM32 32-bit Cortex MCUs 標準包裝:490 系列:STM32 F1 核心處理器:ARM? Cortex?-M3 芯體尺寸:32-位 速度:36MHz 連通性:I²C，IrDA，LIN，SPI，UART/USART 外圍設備:DMA，PDR，POR，PVD，PWM，溫度傳感器，WDT 輸入/輸出數:26 程序存儲器容量:64KB（64K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:10K x 8 電壓 - 電源 (Vcc/Vdd):2 V ~ 3.6 V 數據轉換器:A/D 10x12b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:36-VFQFN，36-VFQFPN 包裝:托盤 配用:497-10030-ND - STARTER KIT FOR STM32497-8853-ND - BOARD DEMO STM32 UNIV USB-UUSCIKSDKSTM32-PL-ND - KIT IAR KICKSTART STM32 CORTEXM3497-8512-ND - KIT STARTER FOR STM32F10XE MCU497-8505-ND - KIT STARTER FOR STM32F10XE MCU497-8304-ND - KIT STM32 MOTOR DRIVER BLDC497-6438-ND - BOARD EVALUTION FOR STM32 512K497-6289-ND - KIT PERFORMANCE STICK FOR STM32MCBSTM32UME-ND - BOARD EVAL MCBSTM32 + ULINK-MEMCBSTM32U-ND - BOARD EVAL MCBSTM32 + ULINK2更多... 其它名稱:497-9032STM32F101T8U6-ND |
| MC68HC705J1ACPE | 功能描述:8位微控制器 -MCU HCO5 CORE+1.2K RAM + EPR RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| MC68HC705J2CDW | 制造商:Motorola Inc 功能描述: 制造商:Motorola Inc 功能描述:MicroController, 8-Bit, 20 Pin, Plastic, SOP |
發布緊急采購，3分鐘左右您將得到回復。