參數資料
型號: M700000003
廠商: Spansion Inc.
英文描述: 2 x 64 Megabit (8 M x 16-Bit) CMOS 3.0 Volt-Only Page Mode Flash Memory Data Storage 128 Megabit (8 M x 16-Bit) CMOS
中文描述: 2 × 64兆位(8米× 16位)的CMOS 3.0伏特,只有頁面模式閃存數據存儲128兆位(8米× 16位)的CMOS
文件頁數: 105/128頁
文件大?。?/td> 918K
代理商: M700000003
November 25, 2003
Am70PDL127BDH/Am70PDL129BDH
103
A D V A N C E I N F O R M A T I O N
RY/BY#: Ready/Busy#
The RY/BY# is a dedicated, open-drain output pin
which indicates whether an Embedded Algorithm is in
progress or complete. The RY/BY# status is valid after
the rising edge of the final WE# pulse in the command
sequence. Since RY/BY# is an open-drain output, sev-
eral RY/BY# pins can be tied together in parallel with a
pull-up resistor to V
CC
.
If the output is low (Busy), the device is actively eras-
ing or programming. (This includes programming in
the Erase Suspend mode.) If the output is high
(Ready), the device is in the read mode, the standby
mode, or in the erase-suspend-read mode.
Table 12
shows the outputs for RY/BY#.
DQ6: Toggle Bit I
Toggle Bit I on DQ6 indicates whether an Embedded
Program or Erase algorithm is in progress or com-
plete, or whether the device has entered the Erase
Suspend mode. Toggle Bit I may be read at any ad-
dress, and is valid after the rising edge of the final
WE# pulse in the command sequence (prior to the
program or erase operation), and during the sector
erase time-out.
During an Embedded Program or Erase algorithm op-
eration, successive read cycles to any address cause
DQ6 to toggle. The system may use either OE# or
CE# to control the read cycles. When the operation is
complete, DQ6 stops toggling.
After an erase command sequence is written, if all sectors
selected for erasing are protected, DQ6 toggles for approxi-
mately 100 μs, then returns to reading array data. If not all
selected sectors are protected, the Embedded Erase algo-
rithm erases the unprotected sectors, and ignores the se-
lected sectors that are protected.
The system can use DQ6 and DQ2 together to determine
whether a sector is actively erasing or is erase-suspended.
When the device is actively erasing (that is, the Embedded
Erase algorithm is in progress), DQ6 toggles. When the de-
vice enters the Erase Suspend mode, DQ6 stops toggling.
However, the system must also use DQ2 to determine
which sectors are erasing or erase-suspended. Alterna-
tively, the system can use DQ7 (see the subsection on
DQ7: Data# Polling
).
If a program address falls within a protected sector,
DQ6 toggles for approximately 1
μ
s after the program
command sequence is written, then returns to reading
array data.
DQ6 also toggles during the erase-suspend-program
mode, and stops toggling once the Embedded Pro-
gram algorithm is complete.
Table 12
shows the outputs for Toggle Bit I on DQ6.
Figure 9 shows the toggle bit algorithm. Figure 21 in
the “AC Characteristics” section shows the toggle bit
timing diagrams. Figure 22 shows the differences be-
tween DQ2 and DQ6 in graphical form. See also the
subsection on
DQ2: Toggle Bit II
.
相關PDF資料
PDF描述
M7232 Numeric/Alphanumeric Triplexed LCD Display Drivers
M7232 CONTINUOUS, ON/OFF LIGHT DIMMER
M750000004 128 Megabit (8 M x 16-Bit) CMOS 3.0 Volt-only, Simultaneous Read/Write Flash Memory
M750000005 128 Megabit (8 M x 16-Bit) CMOS 3.0 Volt-only, Simultaneous Read/Write Flash Memory
M750000006 128 Megabit (8 M x 16-Bit) CMOS 3.0 Volt-only, Simultaneous Read/Write Flash Memory
相關代理商/技術參數
參數描述
M7000-TW0D 制造商:Denon Electronics 功能描述:MISSION 702 TWEETER
M7002NND03 制造商:WILLAS 制造商全稱:WILLAS 功能描述:WBFBP-03B Plastic-Encapsulate MOSFETS
M7002TTD03 制造商:WILLAS 制造商全稱:WILLAS 功能描述:WBFBP-03A Plastic-Encapsulate MOSFETS
M7006 制造商:Tamura Corporation of America 功能描述:
M7010R 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:16K x 68-bit Entry NETWORK SEARCH ENGINE