- 您現在的位置：買賣IC網 > PDF目錄45038 > M37906M4H-XXXSP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP42 PDF資料下載
參數資料
| 型號： | M37906M4H-XXXSP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP42 |
| 封裝： | 0.600 INCH, 1.78 MM PITCH, PLASTIC, SDIP-42 |
| 文件頁數： | 22/101頁 |
| 文件大小： | 766K |
| 代理商： | M37906M4H-XXXSP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁
27
M37906M4C-XXXFP, M37906M4C-XXXSP, M37906M4H-XXXFP
M37906M4H-XXXSP, M37906M6C-XXXFP, M37906M6C-XXXSP
M37906M8C-XXXFP, M37906M8C-XXXSP
PRELIMINAR
Y
Notice:
This
is not
a final
specification.
Som
e param
etric
lim
its are
subject
to change.
16-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
When bit 2 of the timer Ai mode register is “1”, the output is gener-
ated from TAiOUT pin. The output is toggled each time the contents
of the counter reaches to 000016. When the contents of the count
start bit is “0”, “L” is output from TAiOUT pin.
When bit 2 is “0”, TAiOUT can be used as a normal port pin. When bit
4 is “0”, TAiIN can be used as a normal port pin.
When bit 4 is “1”, counting is performed only while the input signal
from the TAiIN pin is “H” or “L” as shown in Figure 22. Therefore, this
can be used to measure the pulse width of the TAiIN input signal.
Whether to count while the input signal is “H” or while it is “L” is de-
termined by bit 3. If bit 3 is “1”, counting is performed while the TAiIN
pin input signal is “H” and if bit 3 is “0”, counting is performed while it
is “L”.
Note that, the duration of “H” or “L” on the TAiIN pin must be 2 or
more cycles of the timer count source.
When data is written to timer Ai register with timer Ai halted, the
same data is also written to the reload register and the counter.
When data is written to timer Ai which is busy, the data is written to
the reload register, but not to the counter. The new data is reloaded
from the reload register to the counter at the next reload time and
counting continues. The contents of the counter can be read at any
time.
When the value set in the timer Ai register is n, the timer frequency
division ratio is 1/(n+1).
0 0 : Always “00” in timer mode
0 : No pulse output (TAiOUT is normal port pin.)
1 : Pulse output (TAiOUT is pulse output pin.) (Note)
0
× : No gate function (TAiIN is normal port pin.) (Note)
1 0 : Count only while TAiIN input is “L”.
1 1 : Count only while TAiIN input is “H”.
0 : Always “0” in timer mode.
Clock source select bits
See Table 7.
Timer A0 mode register
Timer A1 mode register
Timer A2 mode register
Timer A3 mode register
Timer A4 mode register
7
00
6543210
Addresses
5616
5716
5816
5916
5A16
0
Note: Each of timers A3, and A5 through A8 has no I/O pin. Therfore, fix each of these bits to “0”.
Timer A5 mode register
Timer A6 mode register
Timer A7 mode register
Timer A8 mode register
Timer A9 mode register
Addresses
D616
D716
D816
D916
DA16
Fig. 20 Bit configuration of timer Ai mode register in timer mode
Fig. 19 Bit configuration of timer A clock division select register
Table 7. Relationship between timer A clock division select bits,
clock source select bits, and count source
Timer A clock division select bit
(See Table 7.)
76543210
Timer A clock division select register
Address
4516
“0” at read.
Clock source select bits
(bits 7 and 6 at addresses
5616 to 5A16)
(bits 7 and 6 at addresses
D616 to DA16)
1 0
0 0
0 1
Timer A clock division select bits
(bits 1 and 0 at address 4516)
f2
f16
f64
1 1
f512
00
f1
f16
f64
f4096
01
f1
f64
f512
f4096
10
11
Do not
select.
Note: Timers A0 to A9 use the same clock, which is selected by the
timer A clock division select bits.
相關PDF資料 |
PDF描述 |
|---|---|
| M37920F8MHP | 16-BIT, FLASH, 26 MHz, MICROCONTROLLER, PQFP100 |
| M37920S4CGP | 16-BIT, 20 MHz, MICROCONTROLLER, PQFP100 |
| M37920S4CGP | 16-BIT, 20 MHz, MICROCONTROLLER, PQFP100 |
| M38002E2FS | 8-BIT, UVPROM, 8 MHz, MICROCONTROLLER, CQCC64 |
| M38007E4SP | 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PDIP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M37906M6C-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER |
| M37906M6C-XXXSP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER |
| M37906M8C-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER |
| M37906M8C-XXXSP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER |
| M37906T-PRB | 功能描述:DEV POD PROBE FOR M37900T2-RPD-E RoHS:否 類別:編程器，開發系統 >> 配件 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program RoHS指令信息:IButton RoHS Compliance Plan 標準包裝:1 系列:- 附件類型:USB 至 1-Wire? RJ11 適配器 適用于相關產品:1-Wire? 設備 產品目錄頁面:1429 (CN2011-ZH PDF) |
發布緊急采購，3分鐘左右您將得到回復。