參數資料
型號: M37906M4C-XXXSP
元件分類: 微控制器/微處理器
英文描述: 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP42
封裝: 0.600 INCH, 1.78 MM PITCH, PLASTIC, SDIP-42
文件頁數: 66/101頁
文件大?。?/td> 766K
代理商: M37906M4C-XXXSP
67
M37906M4C-XXXFP, M37906M4C-XXXSP, M37906M4H-XXXFP
M37906M4H-XXXSP, M37906M6C-XXXFP, M37906M6C-XXXSP
M37906M8C-XXXFP, M37906M8C-XXXSP
PRELIMINAR
Y
Notice:
This
is not
a final
specification.
Som
e param
etric
lim
its are
subject
to change.
16-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
1/16
Watchdog timer
frequency select bit
“FFF16” is set.
Writing to watchdog
timer register
STP instruction
Watchdog timer
interrupt request
Wf32
Wf512
Watchdog timer
f2
Wait mode
1/16
1
0
Watchdog timer register: address 6016
Watchdog timer frequency select register: bit 0 at address 6116
Watchdog timer clock source select bits at STP state termination: bits 6, 7 at address 6116
When the most significant bit of the watchdog timer becomes “0”, this signal will be generated.
Note: During the stop mode and until the stop mode is terminated, setting for disabling the
watchdog timer is ignored.
RESET
Disables watchdog
timer (Note).
fX16
fX32
fX64
fX128
Watchdog timer clock source select
bits at STP state termination
Stop mode
Divided f(XIN)
WATCHDOG TIMER
The watchdog timer is used to detect unexpected execution se-
quence caused by software runaway and others. Figure 74 shows
the block diagram of the watchdog timer.
The watchdog timer consists of a 12-bit binary counter.
The watchdog timer counts clock Wf32, which is obtained by dividing
the peripheral devices’ clock f2 by 16; or clock Wf512, which is ob-
tained by doing it by 256. Bit 0 of the watchdog timer frequency se-
lect register (watchdog timer frequency select bit) shown in Figure 75
selects which clock is to be counted.
Wf512 is selected when this bit 0 is “0”, and Wf32 is selected when bit
0 is “1”. Bit 0 is cleared to “0” after reset.
FFF16 is set in the watchdog timer when “L” level voltage is applied
to pin RESET, STP instruction is executed, data is written to the
watchdog timer register (address 6016), or the most significant bit of
the watchdog timer becomes “0”.
After FFF16 is set in the watchdog timer, when the watchdog timer
counts Wf32 or Wf512 by 2048 counts, the most significant bit of
watchdog timer becomes “0”, the watchdog timer interrupt request
bit is set to “1”, and FFF16 is set again in the watchdog timer.
In program coding, make sure that data is written in the watchdog
timer before the most significant bit of the watchdog timer becomes
“0”. If this routine is not executed owing to unexpected program ex-
ecution or others, the most significant bit of the watchdog timer be-
Fig. 74 Block diagram of watchdog timer
Fig. 75 Bit configuration of watchdog timer frequency select register
76543210
Watchdog timer frequency select register
Watchdog timer frequency select bit
0 : W f512
1 : W f32
Watchdog timer clock source select bits at STP
state termination
0 0 : fX32
0 1 : fX16
1 0 : fX128
1 1 : fX64
76543210
Address
6116
comes “0” and an interrupt is generated.
The microcomputer can generate a reset pulse by writing “1” to bit 6
(software reset bit) of processor mode register 0 in an interrupt rou-
tine and can be restarted.
The watchdog timer can also be used to return from the STP state,
where a clock has stopped its operation owing to the STP instruction
execution. For details, refer to the sections on the clock generating
circuit and standby function.
The watchdog timer stops its operation in the following cases, and at
this time, input to the watchdog timer is disabled:
When the external area is accessed in the hold state
In the wait mode
In the stop mode
相關PDF資料
PDF描述
M37906M4H-XXXSP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP42
M37920F8MHP 16-BIT, FLASH, 26 MHz, MICROCONTROLLER, PQFP100
M37920S4CGP 16-BIT, 20 MHz, MICROCONTROLLER, PQFP100
M37920S4CGP 16-BIT, 20 MHz, MICROCONTROLLER, PQFP100
M38002E2FS 8-BIT, UVPROM, 8 MHz, MICROCONTROLLER, CQCC64
相關代理商/技術參數
參數描述
M37906M4H-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER
M37906M6C-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER
M37906M6C-XXXSP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER
M37906M8C-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER
M37906M8C-XXXSP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER