- 您現在的位置：買賣IC網 > PDF目錄69013 > M37544G2GP 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PQFP32 PDF資料下載
參數資料
| 型號： | M37544G2GP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PQFP32 |
| 封裝： | 7 X 7 MM, 0.80 MM PITCH, PLASTIC, LQFP-32 |
| 文件頁數： | 39/68頁 |
| 文件大小： | 738K |
| 代理商： | M37544G2GP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁當前第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁
7544 Group
Rev.1.04
2004.06.08
page 44 of 66
REJ03B0012-0104Z
5. Setup for I/O ports
Setup I/O ports using hardware and software as follows:
<Hardware>
Connect a resistor of 100
or more to an I/O port in series.
<Software>
As for an input port, read data several times by a program for
checking whether input levels are equal or not.
As for an output port, since the output data may reverse because
of noise, rewrite data to its port latch at fixed periods.
Rewrite data to direction registers and pull-up control registers at
fixed periods.
Note: When a direction register is set for input port again at fixed
periods, a several-nanosecond short pulse may be output
from this port. If this is undesirable, connect a capacitor to
this port to remove the noise pulse.
Fig. 58 Setup for I/O ports
6. Providing of watchdog timer function by software
If a microcomputer runs away because of noise or others, it can
be detected by a software watchdog timer and the microcomputer
can be reset to normal operation. This is equal to or more effective
than program runaway detection by a hardware watchdog timer.
The following shows an example of a watchdog timer provided by
software.
In the following example, to reset a microcomputer to normal op-
eration, the main routine detects errors of the interrupt processing
routine and the interrupt processing routine detects errors of the
main routine.
This example assumes that interrupt processing is repeated mul-
tiple times in a single main routine processing.
Fig. 59 Watchdog timer by software
<The main routine>
Assigns a single byte of RAM to a software watchdog timer
(SWDT) and writes the initial value N in the SWDT once at each
execution of the main routine. The initial value N should satisfy
the following condition:
N+1
≥ (Counts of interrupt processing executed in each main
routine)
As the main routine execution cycle may change because of an
interrupt processing or others, the initial value N should have a
margin.
Watches the operation of the interrupt processing routine by
comparing the SWDT contents with counts of interrupt process-
ing after the initial value N has been set.
Detects that the interrupt processing routine has failed and de-
termines to branch to the program initialization routine for
recovery processing in the following case:
If the SWDT contents do not change after interrupt processing.
<The interrupt processing routine>
Decrements the SWDT contents by 1 at each interrupt process-
ing.
Determines that the main routine operates normally when the
SWDT contents are reset to the initial value N at almost fixed
cycles (at the fixed interrupt processing count).
Detects that the main routine has failed and determines to
branch to the program initialization routine for recovery process-
ing in the following case:
If the SWDT contents are not initialized to the initial value N but
continued to decrement and if they reach 0 or less.
Direction register
Port latch
Data bus
I/O port
pins
Noise
N.G.
O.K.
Main routine
(SWDT)
← N
CLI
Main processing
(SWDT)
Interrupt processing
routine errors
N
Interrupt processing routine
(SWDT)
← (SWDT)—1
Interrupt processing
(SWDT)
Main routine
errors
>0
≤0
RTI
Return
=N?
≤0?
≠N
7. Electric Characteristic Differences Between Mask ROM and
One Time PROM Version MCUs
There are differences in electric characteristics, operation margin,
noise immunity, and noise radiation between the mask ROM and
One Time PROM version MCUs due to the difference in the manu-
facturing processes.
When manufacturing an application system with the One Time
PROM version and then switching to use of the Mask ROM ver-
sion, please perform sufficient evaluations for the commercial
samples of the Mask ROM version.
相關PDF資料 |
PDF描述 |
|---|---|
| M37549G2-XXXFP | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDSO24 |
| M37549G1-XXXFP | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDSO24 |
| M37549G1FP | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDSO24 |
| M37560M8-XXXFP | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP100 |
| M37560EFDFP | 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PQFP100 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M37544G2HP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M37544G2SP | 功能描述:IC 740 MCU OTP 8K 32P4B RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:740/38000 標準包裝:330 系列:- 核心處理器:- 芯體尺寸:8/16-位 速度:40MHz 連通性:UART/USART 外圍設備:DMA，PWM，WDT 輸入/輸出數:32 程序存儲器容量:- 程序存儲器類型:外部程序存儲器 EEPROM 大小:- RAM 容量:- 電壓 - 電源 (Vcc/Vdd):4.5 V ~ 5.5 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:100-BQFP 包裝:管件 |
| M37544M2-XXXGP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M37544M2-XXXHP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M37544M2-XXXSP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。