- 您現在的位置：買賣IC網 > PDF目錄45035 > M37542M2-XXXHP 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQCC36 PDF資料下載
參數資料
| 型號： | M37542M2-XXXHP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQCC36 |
| 封裝： | 6 X 6 MM, 0.50 MM PITCH, PLASTIC, WQFN-36 |
| 文件頁數： | 16/122頁 |
| 文件大?。?/td> | 1311K |
| 代理商： | M37542M2-XXXHP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁
7542 Group
Rev.3.03
Jul 11, 2008
Page 112 of 117
REJ03B0006-0303
Notes on Output Compare
1. When the selected source timer of each compare channel is
stopped, written data to compare register is loaded to the com-
pare latch simultaneously.
2. Do not write the same data to both of compare latch x0 (x=0, 1,
2, 3) and x1.
3. When setting value of the compare register is larger than timer
setting value, compare match signal is not generated. Accord-
ingly, the output waveform is fixed to “L” or “H” level.
However, when setting value of another compare register is
smaller than timer setting value, this compare match signal is
generated. Accordingly, if the corresponding compare latch y
(y=00, 01, 10, 11, 20, 21, 30, 31) interrupt source bit is set to “1”
(valid), compare match interrupt request occurs.
4. When the compare x trigger enable bit is cleared to “0” (dis-
abled), the match trigger to the waveform output circuit is
disabled. Accordingly, the output waveform can be fixed to “L”
or “H” level.
However, in this case, the compare match signal is generated.
Accordingly, if the corresponding compare latch y (y=00, 01, 10,
11, 20, 21, 30, 31) interrupt source bit is set to “1”
(valid),compare match interrupt request occurs.
Notes on Input Capture
1. If the capture trigger is input while the capture register (low-or-
der and high-order) is in read, captured value is changed
between high-order reading and low-order reading. Accordingly,
some countermeasure by software is recommended, for ex-
ample comparing the values that twice of read.
2. Timer A cannot be used for the capture source timer in the fol-
lowing state;
XIN oscillation selected by clock division ratio selection bits
(bits 7 and 6 of CPU mode register (address 3B16))
Timer A count source: On-chip oscillator output.
Timer B cannot be used for the capture source timer in the fol-
lowing state;
XIN oscillation selected by clock division ratio selection bits
Timer B count source: Timer A underflow
Timer A count source: On-chip oscillator output.
3. As shown below, when the capture input is performed to both
capture latch 00 and 01 at the same time, the value of capture
0 status bit (bit 4 of capture/compare status register (address
2216)) is undefined (same as capture 1).
When “1” is written to capture latch 00 software trigger bit (bit 0
of capture software trigger register (address 1316)) and capture
latch 01 software trigger bit (bit 1 of capture software trigger reg-
ister) at the same time
When external trigger of capture latch 00 and software trigger of
capture latch 01 occur at the same time
When external trigger of capture latch 01 and software trigger of
capture latch 00 occur at the same time
4. When the capture interrupt is used as the interrupt for return
from stop mode, set the capture 0 noise filter clock selection
bits (bits 5 and 4 of capture mode register (address 2016)) to
“00 (Filter stop)” (same as capture 1).
相關PDF資料 |
PDF描述 |
|---|---|
| M37542M2-XXXGP | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP32 |
| M37542F4SP | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PDIP32 |
| M37542F8HP | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQCC36 |
| M37544G2ASP | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDIP32 |
| M37544G2ASP | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDIP32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M37542M2-XXXSP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M37542M4-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M37542M4-XXXGP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M37542M4-XXXHP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M37542M4-XXXSP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。