- 您現在的位置：買賣IC網 > PDF目錄359055 > M34F04 (意法半導體) 4Kbit Serial I2C Bus EEPROM With Hardware Write Control on Top Half of Memory PDF資料下載
參數資料
| 型號： | M34F04 |
| 廠商： | 意法半導體 |
| 元件分類： | EEPROM |
| 英文描述： | 4Kbit Serial I2C Bus EEPROM With Hardware Write Control on Top Half of Memory |
| 中文描述： | 4Kbit串行I2C總線的EEPROM，帶有硬件寫控制記憶的上半部分 |
| 文件頁數： | 8/20頁 |
| 文件大?。?/td> | 262K |
| 代理商： | M34F04 |
M34F04
8/20
Figure 6. Write Mode Sequences, to Addresses in the Top Half, with WC=1 (data write inhibited)
Write Operations
Following a Start condition the bus master sends
a Device Select Code with the RW bit reset to 0.
The device acknowledges this, as shown in Figure
7, and waits for an address byte. The device re-
sponds to the address byte with an acknowledge
bit, and then waits for the data byte.
When the bus master generates a Stop condition
immediately after the Ack bit (in the “10
th
bit” time
slot), either at the end of a Byte Write or a Page
Write, the internal memory Write cycle is triggered.
A Stop condition at any other time slot does not
trigger the internal Write cycle.
During the internal Write cycle, Serial Data (SDA)
and Serial Clock (SCL) are ignored, and the de-
vice does not respond to any requests.
Byte Write
After the Device Select code and the address byte,
the bus master sends one data byte. If the ad-
dressed location is Write-protected, by Write Con-
trol (WC) being driven High (during the period from
the Start condition until the end of the address
byte), the device replies to the data byte with
NoAck, as shown in Figure 6, and the location is
not modified. If, instead, the addressed location is
not Write-protected, the device replies with Ack.
The bus master terminates the transfer by gener-
ating a Stop condition, as shown in Figure 7.
Page Write
The Page Write mode allows up to 16 bytes to be
written in a single Write cycle, provided that they
are all located in the same page in the memory:
that is, the most significant memory address bits
are the same. If more bytes are sent than will fit up
to the end of the page, a condition known as ‘roll-
over’ occurs. This should be avoided, as data
starts to become overwritten in an implementation
dependent way.
The bus master sends from 1 to 16 bytes of data,
each of which is acknowledged by the device if
Write Control (WC) is Low. If the addressed loca-
tion is Write-protected, by Write Control (WC) be-
ing driven High (during the period from the Start
S
S
Byte Write
DEV SEL
BYTE ADDR
DATA IN
WC
S
Page Write
DEV SEL
BYTE ADDR
DATA IN 1
DATA IN 2
WC
DATA IN 3
AI02803C
Page Write
(cont'd)
WC (cont'd)
S
DATA IN N
ACK
ACK
NO ACK
R/W
ACK
ACK
NO ACK
NO ACK
R/W
NO ACK
NO ACK
相關PDF資料 |
PDF描述 |
|---|---|
| M34F04-WMN6T | 4Kbit Serial I2C Bus EEPROM With Hardware Write Control on Top Half of Memory |
| M34F04-WMN6TG | 4Kbit Serial I2C Bus EEPROM With Hardware Write Control on Top Half of Memory |
| M34F04-WMN6TP | 4Kbit Serial I2C Bus EEPROM With Hardware Write Control on Top Half of Memory |
| M35080MN | 8 Kbit Serial SPI Bus EEPROM With Incremental Registers |
| M35080 | 8 Kbit Serial SPI Bus EEPROM With Incremental Registers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M34F04-WMN6P | 功能描述:電可擦除可編程只讀存儲器 4Kbit Serial EE RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| M34F04-WMN6T | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:4Kbit Serial I2C Bus EEPROM With Hardware Write Control on Top Half of Memory |
| M34F04-WMN6TG | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:4Kbit Serial I2C Bus EEPROM With Hardware Write Control on Top Half of Memory |
| M34F04-WMN6TP | 功能描述:電可擦除可編程只讀存儲器 4Kbit Serial EE RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| M34JBL69X | 制造商:Panasonic Industrial Company 功能描述:CRT |
發布緊急采購，3分鐘左右您將得到回復。