- 您現在的位置：買賣IC網 > PDF目錄359054 > M34A08-VDW6T (意法半導體) 2 Kbit Serial SMBus EEPROM for ACR Card Configuration PDF資料下載
參數資料
| 型號： | M34A08-VDW6T |
| 廠商： | 意法半導體 |
| 英文描述： | 2 Kbit Serial SMBus EEPROM for ACR Card Configuration |
| 中文描述： | 2千位串行EEPROM中的SMBus對于ACR卡配置 |
| 文件頁數： | 3/15頁 |
| 文件大?。?/td> | 123K |
| 代理商： | M34A08-VDW6T |
3/15
M34A02
can be calculated). In most applications, though,
this method of synchronization is not employed,
and so the pull-up resistor is not necessary,
provided that the bus master has a push-pull
(rather than open drain) output.
Serial Data (SDA)
This bi-directional signal is used to transfer data in
or out of the device. It is an open drain output that
may be wire-OR’ed with other open drain or open
collector signals on the bus. A pull up resistor must
be connected from Serial Data (SDA) to V
CC
.
(Figure 3 indicates how the value of the pull-up
resistor can be calculated).
Chip Enable (E0, E1, E2)
These input signals are used to set the value that
is to be looked for on the three least significant bits
(b3, b2, b1) of the 7-bit Device Select Code. These
inputs should be tied to V
CC
or V
SS
, to establish
the Device Select Code.
Write Control (WC)
This input signal is useful for protecting the entire
contents of the memory from inadvertent erase
and write operations. Write operations are
disabled to the entire memory array when Write
Control (WC) is held High. When unconnected, the
signal is internally read as V
IL
, and Write
operations are allowed.
When Write Control (WC) is held High, Device
Select and Address bytes are acknowledged,
Data bytes are
not
acknowledged.
DEVICE OPERATION
The device supports the ACR Serial Bus protocol.
This is summarized in Figure 4. Any device that
sends data on to the bus is defined to be a
transmitter, and any device that reads the data to
be a receiver. The device that controls the data
transfer is known as the bus master, and the other
as the slave device. A data transfer can only be
initiated by the bus master, which will also provide
the serial clock for synchronization. The device is
always a slave in all communication.
Start Condition
Start is identified by a falling edge of Serial Data
(SDA) while Serial Clock (SCL) is stable in the
High state. A Start condition must precede any
data transfer command. The device continuously
monitors (except during a Write cycle) Serial Data
(SDA) and Serial Clock (SCL) for a Start condition,
and will not respond unless one is given.
Stop Condition
Stop is identified by a rising edge of the SDA line
while the clock SCL is stable in the High state. A
Stop
condition
terminates
between the device and the bus master. A Stop
condition at the end of a Read command, provided
that it is followed by NoAck, forces the device into
its Stand-by mode. A Stop condition at the end of
a Write command triggers the internal EEPROM
Write cycle.
Acknowledge Bit (ACK)
The acknowledge bit is used to indicate a
successful byte transfer. The bus transmitter,
whether it be bus master or slave device, releases
Serial Data (SDA) after sending eight bits of data.
During the 9
th
clock pulse period, the receiver pulls
Serial Data (SDA) Low to acknowledge the receipt
of the eight data bits.
Data Input
During data input, the device samples Serial Data
(SDA) on the rising edge of Serial Clock (SCL).
communication
Figure 4. Maximum R
L
Value versus Bus Capacitance (C
BUS
) for an ACR Serial Bus
AI01665
VCC
CBUS
SDA
RL
MASTER
RL
SCL
CBUS
100
0
4
8
12
16
20
CBUS (pF)
M
)
10
1000
fc = 400kHz
fc = 100kHz
相關PDF資料 |
PDF描述 |
|---|---|
| M34C00 | SWITCH TACT 6MM SQ L=5.85MM160GF |
| M34C00-WDW6T | 3 x 128 bit Serial IC Bus EEPROM For ee-Tags |
| M34C00-WMN6T | 3 x 128 bit Serial IC Bus EEPROM For ee-Tags |
| M34C00MN | 3 x 128 bit Serial IC Bus EEPROM For ee-Tags |
| M34C00DW | 3 x 128 bit Serial IC Bus EEPROM For ee-Tags |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M34A08-VMN6T | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2 Kbit Serial SMBus EEPROM for ACR Card Configuration |
| M34C/S | 制造商:Brady 功能描述:WEAR EAR PROTECTION |
| M34C00 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:3 x 128 bit Serial IC Bus EEPROM For ee-Tags |
| M34C00DW | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:3 x 128 bit Serial IC Bus EEPROM For ee-Tags |
| M34C00MN | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:3 x 128 bit Serial IC Bus EEPROM For ee-Tags |
發布緊急采購，3分鐘左右您將得到回復。